50 OHM TERMINATION TEXAS Search Results

1R09R1

Abstract: wcr1210 WCR1206 wcr series
Contextual Info: GENERAL PURPOSE THICK FILM CHIP RESISTOR ISO-9001 Registered WCR SERIES Organic Protection Wrap-around termination Solder Plating • • • • Wide ohmic range 1S to 22MS Tolerances to ±0.5% TCR down to "50 ppm/°C Zero ohm jumpers available Glass Passivation

E1295

Contextual Info: DB781S50N-SY DB781S75N-SY MicroFILL Indoor Antenna 870-960 MHz Model Number DB781S50N-SY DB781S75N-SY 50 ohms 75 ohms Impedance Termination 75 OHM FEMALE CONNECTORS MAY BE SPECIAL ORDERED. Type N-Female Frequency Range 870-960 MHz Gain >0 dBd or >2.1 dBi

Contextual Info: DB791S50N-SY DB791S75N-SY Micro Fill Indoor Antenna 870-960 MHz Model Number Impedance DB791S50N-SY DB791S75N-SY 50 ohms Termination 75 OHM FEMALE CONNECTORS MAY BE SPECIAL ORDERED. Type N-Female Frequency Range Gain 75 ohms 870-960 MHz >4.0 dBd or >6.1 dBi

DB791S50N-C

Abstract: Decibel Products
Contextual Info: DB791S50N-C DB791S75N-C Micro Fill Indoor Antenna Model Number Impedance DB791S50N-C DB791S75N-C 50 ohms 75 ohms 75 OHM FEMALE CONNECTORS MAY BE SPECIAL ORDERED. Type N-Female Termination 824-894 MHz Frequency Range >4.0 dBd or >6.1 dBi Gain <1.5:1 VSWR Polarization

DB781S50N-C

Abstract: DB781S75N-C
Contextual Info: DB781S50N-C DB781S75N-C MicroFILL Indoor Antenna 824-894 MHz Model Number DB781S50N-C DB781S75N-C 50 ohms 75 ohms Impedance Termination 75 OHM FEMALE CONNECTORS MAY BE SPECIAL ORDERED. Type N-Female Frequency Range 824-894 MHz Gain >0 dBd or >2.1 dBi VSWR

g5d2

Abstract: ths730a PM10-24S05 backplane layout SN74GTLPH1655 LT1083
Contextual Info: GTLP Evaluation Module EVM User’s Guide June 2001 Standard Linear & Logic Printed in U.S.A. 0601 SCEA023 GTLP Evaluation Module (EVM) User’s Guide SCEA023 June 2001 Printed on Recycled Paper IMPORTANT NOTICE Texas Instruments and its subsidiaries (TI) reserve the right to make changes to their products

GMII layout

Abstract: TNETX4090 schematic diagram clock schematic SPWA025 TNETX4090 macronix rambus Concurrent RDRAM
Contextual Info: Design and Layout Guidelines for the TNETX4090 Device APPLICATION REPORT: SPWA025A Worldwide Broadband Access Group, Enterprise Products May 1998 IMPORTANT NOTICE Texas Instruments TI reserves the right to make changes to its products or to discontinue any

TI380C30

Abstract: TI380C60 TI380FPA P802 TI380 TI380C25 valor magnetics tokenring
Contextual Info: TEXAS INSTRUMENTS Semiconductor Group TI380C30 Physical Layer Interface Design Guidelines of the Integrated Token-Ring COMMProcessor Application Design Note Revision A March 9, 1995 Questions may be directed to: TI380 TECHNICAL SUPPORT LINE ti380hot@micro.ti.com

Contextual Info: CDCM7005 QFN Package Evaluation Module Manual HPA/High Speed Communications User’s Guide 2005 Clock Drivers SCAU015A IMPORTANT NOTICE Texas Instruments Incorporated and its subsidiaries (TI) reserve the right to make corrections, modifications, enhancements, improvements, and other changes to its products and services at any time and to discontinue

Contextual Info: CDCM7005 BGA Package Evaluation Module Manual HPA/High Speed Communications User’s Guide 2005 Clock Drivers SCAU013A IMPORTANT NOTICE Texas Instruments Incorporated and its subsidiaries (TI) reserve the right to make corrections, modifications, enhancements, improvements, and other changes to its products and services at any time and to discontinue

VCA8613

Abstract: R20-R29 U5-U14 dale cw-5 C168 JP13 OPA690 REG103 JEDEC-MO-150 SOCKET64
Contextual Info: VCA8613EVM Evaluation Module User’s Guide June 2004 High-Speed Communications SBOU021 IMPORTANT NOTICE Texas Instruments Incorporated and its subsidiaries TI reserve the right to make corrections, modifications, enhancements, improvements, and other changes to its products and services at any time and to discontinue

Contextual Info: UCC5614 9-Line 3-5 Volt Low Capacitance SCSI Active Terminator FEATURES DESCRIPTION • Complies with SCSI, SCSI-2 and SCSI-3 Standards • 2.7V to 7V Operation The UCC5614 provides 9 lines of active termination for a SCSI Small Computer Systems Interface parallel bus. The SCSI standard recommends active termination at both ends of the cable.

Contextual Info: UCC5610 18-Line 3-5 Volt Low Capacitance SCSI Active Terminator FEATURES DESCRIPTION • Complies with SCSI, SCSI-2, SCSI-3 and FAST-20 Ultra Standards • 2.75V to 7V Operation The UCC5610 provides 18 lines of active termination for a SCSI (Small Computer Systems Interface) parallel bus. The SCSI standard recommends active termination at both ends of the cable.

Contextual Info: UCC5606 9-Line 3-5 Volt SCSI Active Terminator, Reverse Disconnect FEATURES DESCRIPTION • Complies with SCSI, SCSI-2 and SCSI-3 Standards • 2.7V to 7V Operation The UCC5606 provides 9 lines of active termination for a SCSI Small Computer Systems Interface parallel bus. The SCSI standard recommends active termination at both ends of the cable segment.

50 Ohm Termination Texas

Abstract: toko a50 1K Ohm resistor 1/4W 3266W-1-202 7937 74VHC541 OPA642 SPT7937 TK11240B banana socket pcb mount
Contextual Info: AN7937 EVALUATION BOARD APPLICATION NOTE FEATURES APPLICATIONS • 12-bit Resolution • Up to 28 MSPS Conversion Rate • Separate Analog and Digital Supply Voltages • On-board Clock Comparator/Driver • On-board Fixed Reference and Common Mode Voltage

50 Ohm Termination Texas

Abstract: comparator circuit using op-amp 3266W-1-202 EX panasonic resistor array 74VHC541 OPA642 SPT7937 SPT7938 TK11240B
Contextual Info: AN7938 EVALUATION BOARD APPLICATION NOTE FEATURES APPLICATIONS • 12-bit Resolution • Up to 40 MSPS Conversion Rate • Separate Analog and Digital Supply Voltages • On-board Clock Comparator/Driver • On-board Fixed Reference and Common Mode Voltage

PLCC-28

Abstract: SOIC-28 UCC5610
Contextual Info: UCC5610 18-Line 3-5 Volt Low Capacitance SCSI Active Terminator FEATURES DESCRIPTION • Complies with SCSI, SCSI-2, SCSI-3 and FAST-20 Ultra Standards • 2.75V to 7V Operation The UCC5610 provides 18 lines of active termination for a SCSI (Small Computer Systems Interface) parallel bus. The SCSI standard recommends active termination at both ends of the cable.

PLCC-28

Abstract: SOIC-28 UCC5611
Contextual Info: UCC5611 18-Line 3-5 Volt SCSI Active Terminator, Reverse Disconnect FEATURES DESCRIPTION • Complies with SCSI, SCSI-2, SCSI-3 and FAST-20 Ultra Standards • 2.75V to 7V Operation The UCC5611 provides 18 lines of active termination for a SCSI (Small Computer Systems Interface) parallel bus. The SCSI standard recommends active termination at both ends of the cable segment.

panasonic hf series capacitor

Abstract: 74VHC541 OPA642 SPT7937 TK11240B j6a ANALOG DEVICE
Contextual Info: AN7937 EVALUATION BOARD APPLICATION NOTE JUNE 26, 2001 FEATURES APPLICATIONS • 12-bit Resolution • Up to 28 MSPS Conversion Rate • Separate Analog and Digital Supply Voltages • On-board Clock Comparator/Driver • On-board Fixed Reference and Common Mode Voltage

component selection criteria for opamp

Abstract: 3266W-1-202 7937 74VHC541 OPA642 SPT7937 TK11240B
Contextual Info: AN7937 EVALUATION BOARD APPLICATION NOTE JUNE 26, 2001 FEATURES APPLICATIONS • 12-bit Resolution • Up to 28 MSPS Conversion Rate • Separate Analog and Digital Supply Voltages • On-board Clock Comparator/Driver • On-board Fixed Reference and Common Mode Voltage

DIL-16

Abstract: SOIC-16 UCC5606 50 Ohm Termination Texas
Contextual Info: UCC5606 9-Line 3-5 Volt SCSI Active Terminator, Reverse Disconnect FEATURES DESCRIPTION • Complies with SCSI, SCSI-2 and SCSI-3 Standards • 2.7V to 7V Operation The UCC5606 provides 9 lines of active termination for a SCSI Small Computer Systems Interface parallel bus. The SCSI standard recommends active termination at both ends of the cable segment.

50 Ohm Termination Texas

Abstract: DIL-16 SOIC-16 UCC5614
Contextual Info: UCC5614 9-Line 3-5 Volt Low Capacitance SCSI Active Terminator FEATURES DESCRIPTION • Complies with SCSI, SCSI-2 and SCSI-3 Standards • 2.7V to 7V Operation The UCC5614 provides 9 lines of active termination for a SCSI Small Computer Systems Interface parallel bus. The SCSI standard recommends active termination at both ends of the cable.

digital led clock circuit diagram

Abstract: 74VHC541 OPA642 SPT7937 SPT7938 TK11240B
Contextual Info: AN7938 EVALUATION BOARD APPLICATION NOTE JUNE 26, 2001 FEATURES APPLICATIONS • 12-bit Resolution • Up to 40 MSPS Conversion Rate • Separate Analog and Digital Supply Voltages • On-board Clock Comparator/Driver • On-board Fixed Reference and Common Mode Voltage

common mode termination 50 Ohm

Abstract: 74VHC541 OPA642 SPT7937 SPT7938 TK11240B
Contextual Info: AN7938 EVALUATION BOARD APPLICATION NOTE JUNE 26, 2001 FEATURES APPLICATIONS • 12-bit Resolution • Up to 40 MSPS Conversion Rate • Separate Analog and Digital Supply Voltages • On-board Clock Comparator/Driver • On-board Fixed Reference and Common Mode Voltage