26C31 CURRENT Search Results

26C31

Abstract: PTC-55 encoder circuit Encoder interface SCHEMATIC IL10 75175 26C31 current
Contextual Info: Output circuits Incremental encoders Complementary line-driver 05A encoder circuit schematic typical user interface +Vs +Vs 100 Ω AM 26C31 MC 3489 SN 75175 AM 26 LS 32A 0V 0V voltage supply level of signal 5 VDC ± 10% UHigh ≥ 2,4 V at -IHigh = 20 mA ULow ≤ 0,4 V at ILow = 20 mA

AM26C31-EP

Abstract: 26C31
Contextual Info: AM26C31 SLLS103N – DECEMBER 1990 – REVISED OCTOBER 2011 www.ti.com QUADRUPLE DIFFERENTIAL LINE DRIVER Check for Samples: AM26C31 FEATURES 1 1A 1 16 VCC 1Y 2 15 4A 1Z 3 14 4Y G 4 13 4Z 2Z 5 12 G 2Y 6 11 2A 7 10 3Z 3Y GND 8 9 3A 2 1 20 19 4A 1A 3 1Z 4 18

26C31

Abstract: 26C31 current 26LS31 RS422 cable
Contextual Info: PC2 Cable Driver for Incremental Encoders Description: The TTL outputs of our incremental encoders can sink pull down less than 4mA and source (pull up) less than 200uA. This is not always adequate. For long cables (6 to 1000 feet) or noisy environments, one of these tiny plug-in driver boards will provide

26C31

Abstract: application note 26LS31 26C31 current 26LS31 800.736.0194 RS422 cable
Contextual Info: PC2 Cable Driver for Incremental Encoders Description: Pinout: Pin 1 2 3 4 5 6 7 8 9 10 The TTL outputs of our incremental encoders can sink pull down less than 4mA and source (pull up) less than 200uA. This is not always adequate. For long cables (6 to 1000 feet) or noisy environments, one of these tiny plug-in driver boards will provide

26C31

Abstract: INCREMENTAL ENCODER 2048 MEH20
Contextual Info: rev. page 1 of 3 date 08/14/2007 DESCRIPTION: incremental encoder PART NUMBER: MEH20 ELECTRICAL SPECIFICATIONS output waveform output signals current consumption frequency response output phase difference Square Wave A, B, Z phase ≤50 mA 0~100 KHz A, B phase difference 90° ± 45°

26C31

Abstract: MEH30 0.5" shaft diameter encoder 500 ppr
Contextual Info: rev. page 1 of 3 date 05/2009 DESCRIPTION: incremental encoder PART NUMBER: MEH30 ELECTRICAL SPECIFICATIONS output waveform output signals current consumption frequency response output phase difference Square Wave A, B, Z phase ≤50 mA 0~100 KHz A, B phase difference 90° ± 45°

INCREMENTAL ENCODER 2000 ppr

Abstract: 26C31 INCREMENTAL ENCODER 2048 PPR-1000 MES12
Contextual Info: rev. page 1 of 3 date 08/08/2007 DESCRIPTION: incremental encoder PART NUMBER: MES12 ELECTRICAL SPECIFICATIONS output waveform output signals current consumption frequency response output phase difference Square wave A, B, Z phase ≤40 mA 0~100 KHz A, B phase difference 90° ± 45° T/4±T/8

INCREMENTAL ENCODER 2048

Abstract: 26C31 MEH12 2M290
Contextual Info: rev. page 1 of 3 date 08/08/2007 DESCRIPTION: incremental encoder PART NUMBER: MEH12 ELECTRICAL SPECIFICATIONS output waveform output signals current consumption frequency response output phase difference Square Wave A, B, Z phase ≤40 mA 0~100 KHz A, B phase difference 90° ± 45° T/4±T/8

INCREMENTAL ENCODER 2048

Abstract: 26C31 PPR-256 PPR-1000 MEH12
Contextual Info: rev. page 1 of 3 date 05/2009 DESCRIPTION: incremental encoder PART NUMBER: MEH12 ELECTRICAL SPECIFICATIONS output waveform output signals current consumption frequency response output phase difference Square Wave A, B, Z phase ≤40 mA 0~100 KHz A, B phase difference 90° ± 45° T/4±T/8

Contextual Info: rev. page 1 of 3 date 05/2009 DESCRIPTION: incremental encoder PART NUMBER: MEH85 ELECTRICAL SPECIFICATIONS output waveform output signals current consumption frequency response output phase difference Square wave A, B, Z phase ≤60 mA 0~100 KHz A, B phase difference 90° ± 45°

AM26C31-EP

Contextual Info: AM26C31 SLLS103N – DECEMBER 1990 – REVISED OCTOBER 2011 www.ti.com QUADRUPLE DIFFERENTIAL LINE DRIVER Check for Samples: AM26C31 FEATURES 1 1A 1 16 VCC 1Y 2 15 4A 1Z 3 14 4Y G 4 13 4Z 2Z 5 12 G 2Y 6 11 2A 7 10 3Z 3Y GND 8 9 3A 2 1 20 19 4A 1A 3 1Z 4 18

INCREMENTAL ENCODER 2048

Abstract: 26C31 MES20
Contextual Info: rev. page 1 of 3 date 08/14/2007 DESCRIPTION: incremental encoder PART NUMBER: MES20 ELECTRICAL SPECIFICATIONS output waveform output signals current consumption frequency response output phase difference Square wave A, B, Z phase ≤50 mA 0~100 KHz A, B phase difference 90° ± 45°

Contextual Info: AM26C31 QUADRUPLE DIFFERENTIAL LINE DRIVER SLLS103K − DECEMBER 1990 − REVISED SEPTEMBER 2004 D Meets or Exceeds the Requirements of D D D D D D D TIA/EIA-422-B and ITU Recommendation V.11 Low Power, ICC = 100 µA Typ Operates From a Single 5-V Supply High Speed, tPLH = tPHL = 7 ns Typ

26C31

Abstract: INCREMENTAL ENCODER 4500 INCREMENTAL ENCODER 2048 MEH30 800PPR PPR60
Contextual Info: rev. page 1 of 3 date 12/14/2007 DESCRIPTION: incremental encoder PART NUMBER: MEH30 ELECTRICAL SPECIFICATIONS output waveform output signals current consumption frequency response output phase difference Square Wave A, B, Z phase ≤50 mA 0~100 KHz A, B phase difference 90° ± 45°

Contextual Info: AM26C31 QUADRUPLE DIFFERENTIAL LINE DRIVER SLLS103K − DECEMBER 1990 − REVISED SEPTEMBER 2004 D Meets or Exceeds the Requirements of D D D D D D D TIA/EIA-422-B and ITU Recommendation V.11 Low Power, ICC = 100 µA Typ Operates From a Single 5-V Supply High Speed, tPLH = tPHL = 7 ns Typ

AM26C31

Abstract: AM26C31M AM26C31Q AM26LS31 AM26C31C AM26C31CN AM26C31I
Contextual Info: AM26C31 QUADRUPLE DIFFERENTIAL LINE DRIVER SLLS103J − DECEMBER 1990 − REVISED NOVEMBER 2003 D Meets or Exceeds the Requirements of D D 1A 1Y 1Z G 2Z 2Y 2A GND 1 16 2 15 3 14 4 13 5 12 6 11 7 10 8 9 VCC 4A 4Y 4Z G 3Z 3Y 3A AM26C31M . . . FK PACKAGE TOP VIEW

Contextual Info: USB1 Encoder Data Acquisition USB Device Page 1 of 6 Description The USB1 is no longer available for purchase, and has been replaced by our recently released USB4 Encoder Data Acquisition USB Device. The USB4 is a redesigned, enhanced version of the USB1, and is already

26C31

Abstract: AM26C31 AM26C31C AM26C31CD AM26C31CN AM26C31I AM26C31M AM26C31Q AM26LS31
Contextual Info: AM26C31 QUADRUPLE DIFFERENTIAL LINE DRIVER SLLS103K − DECEMBER 1990 − REVISED SEPTEMBER 2004 D Meets or Exceeds the Requirements of D D D D D D D TIA/EIA-422-B and ITU Recommendation V.11 Low Power, ICC = 100 µA Typ Operates From a Single 5-V Supply High Speed, tPLH = tPHL = 7 ns Typ

Contextual Info: AM26C31 QUADRUPLE DIFFERENTIAL LINE DRIVER SLLS103K − DECEMBER 1990 − REVISED SEPTEMBER 2004 D Meets or Exceeds the Requirements of D D D D D D D TIA/EIA-422-B and ITU Recommendation V.11 Low Power, ICC = 100 µA Typ Operates From a Single 5-V Supply High Speed, tPLH = tPHL = 7 ns Typ

Contextual Info: AM26C31 QUADRUPLE DIFFERENTIAL LINE DRIVER SLLS103K − DECEMBER 1990 − REVISED SEPTEMBER 2004 D Meets or Exceeds the Requirements of D D D D D D D TIA/EIA-422-B and ITU Recommendation V.11 Low Power, ICC = 100 µA Typ Operates From a Single 5-V Supply High Speed, tPLH = tPHL = 7 ns Typ

Contextual Info: AM26C31 QUADRUPLE DIFFERENTIAL LINE DRIVER SLLS103K − DECEMBER 1990 − REVISED SEPTEMBER 2004 D Meets or Exceeds the Requirements of D D D D D D D TIA/EIA-422-B and ITU Recommendation V.11 Low Power, ICC = 100 µA Typ Operates From a Single 5-V Supply High Speed, tPLH = tPHL = 7 ns Typ

Contextual Info: AM26C31 QUADRUPLE DIFFERENTIAL LINE DRIVER SLLS103K − DECEMBER 1990 − REVISED SEPTEMBER 2004 D Meets or Exceeds the Requirements of D D D D D D D TIA/EIA-422-B and ITU Recommendation V.11 Low Power, ICC = 100 µA Typ Operates From a Single 5-V Supply High Speed, tPLH = tPHL = 7 ns Typ

Contextual Info: AM26C31 QUADRUPLE DIFFERENTIAL LINE DRIVER SLLS103K − DECEMBER 1990 − REVISED SEPTEMBER 2004 D Meets or Exceeds the Requirements of D D D D D D D TIA/EIA-422-B and ITU Recommendation V.11 Low Power, ICC = 100 µA Typ Operates From a Single 5-V Supply High Speed, tPLH = tPHL = 7 ns Typ

Contextual Info: AM26C31 QUADRUPLE DIFFERENTIAL LINE DRIVER SLLS103K − DECEMBER 1990 − REVISED SEPTEMBER 2004 D Meets or Exceeds the Requirements of D D D D D D D TIA/EIA-422-B and ITU Recommendation V.11 Low Power, ICC = 100 µA Typ Operates From a Single 5-V Supply High Speed, tPLH = tPHL = 7 ns Typ