High sensitivity optical receiver front end" module 10Gb/s point-to-po

The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.

High sensitivity optical receiver front end" module 10Gb/s point-to-po

Datasheet Thumbnail

Top Searches for this datasheet

MTRX192AR Receiver Module
High sensitivity optical receiver front end" module 10Gb/s point-to-point operation.
Photonics Communications
Features:
2002
MTRX192AR: member Multiplex Receiver Family APDs, PINs, single differential output products: High sensitivity optical receiver module including diode high gain, noise TIA. power consumption. Data output interface either with coaxial connector soldering feed through circuit board directly. Choice output coaxial connector among: connector, Kconnector, connector. Inverted, single-end AC-couple output. (Package version with differential outputs available.) Choice input optical connector such FC-PC, etc. Case Operational Temperature: -20oC 70oC.
Note: trademark Gilbert Engineer Co., Inc. K-connector trademark Anritsu/Wiltron.
Performance Specifications
Parameters *Receiver sensitivity
Unit Unit degree
Worst Case 0.75
1.2K
Best Case
Comments/Test Conditions
Gb/s. 1x10-10. 1.5µm =1.5µm; error free operation, Room Temperature. BER<10-14
*Maximum operational optical input power Parameters responsivity Receiver transimpedance gain Receiver Bandwidth Receiver frequency cutoff (3dB) Receiver transfer function phase linearity deviation
Comments/Test Conditions
=1.5µm Small signal gain Small signal frequency response -20oC +70oC (100 GHz) (100 9GHz) =1.3µm 1.5µm; excluding reflection from optical connector.
Receiver transfer function amplitude peaking *Input optical reflectance
Output maximum electrical return loss (S22) Total Power consumption Measured every device. Plot provided with every device. Screened every device.
05/02, MTRX192AR
Photonics Communications
Operating Characteristics (MTRX192AR):
Parameters diode bias (Note-1) Positive receiver module bias Negative receiver module bias Unit +3.3 +3.0 -2.4 +3.3 -2.2 +3.6 -2.0 Current (mA; Max)
Note-1. tests were performed with reverse bias photo diode. Increasing reverse bias will, general, enhance receiver sensitivity slightly. Higher reverse bias voltage tends increase dark current slightly, however, this increase should cause receiver sensitivity degradation.
Schematic MTRX 192AR
MTRX192AR
+3.3V
-2.2V
05/02, MTRX192AR
MTRX192AR Physical Dimensions
Photonics Communications
View
Bottom View
Side View with without connector
Descriptions
Number MTRX192AR V_PIN -2.2V +3.3V Unit
Dimensions
Inch 0.192 0.008 0.120 0.008 0.230 0.008 0.140 0.008 0.795 0.020 0.184 0.010 0.229 0.020 0.300 0.010 0.700 0.008 0.050 0.010 0.100 0.010 0.660 0.008 4.88 0.20 3.05 0.20 5.84 0.20 3.05 0.20 3.56 0.50 4.67 0.26 5.82 0.50 7.62 0.26 17.78 0.20 1.27 0.26 2.54 0.26 16.76 0.20
05/02, MTRX192AR
Photonics Communications
Ordering Code Options Receiver Product Family:
Part Number Description Output Coupling Connector Fiber Lengths (meters) Optical Signal Noise Optimization (with versions only)
(Single Mode Fiber) Ordering Symbol MTRX192AR Connector Pkg, Single Analog Output, High Sensitivity MTRX192AW Connector Pkg., Single Analog Output, OSNR 12.5 Gb/s MTRX192L Connector Pkg., Single Digital Output, High Sensitivity MTRX192LW Connector Pkg., Single Digital Output, OSNR 12.5 Gb/s RX192DA CoplanarPkg., Differential, Analog Output RX192AW Coplanar-Differential Pkg., Single Analog Output, OSNR 12.5 Gb/s RX192DL Coplanar Pkg., Differential, Digital Output RX192DLW Coplanar Pkg., Differential, Digital Output, OSNR 12.5 Gb/s (SMA) Electrical (GPO, Standard) Optical
*The LC-connectorized pigtail these packages offered with meter pigtail length. *The SC-connectorized pigtail these packages offered with meter pigtail length
Photonics Communications
05/02, MTRX192AR
following examples given ease ordering: Example receiver coplanar package, with differential digital output, coupled optical connector (0.6 meter pigtail length only) high sensitivity 10Gb/s applications:
Multiplex Ordering Code:
RX192DLXASC06
Example receiver RF-connector package, with single analog output, coupled, electrical connector, optical connector meter fiber pigtail only) optimized OSNR Gb/s) applications:
Multiplex Ordering Code:
MTRX192AWXDGSC10-O
Example receiver coplanar package, with differential digital output, coupled, optical connector meter fiber pigtail only), optimized 12.5 Gb/s applications:
Multiplex Ordering Code:
RX192DLWXDSC10
Product Inquiries please contact: Phil Altieri Customer Marketing Engineer Multiplex, Inc. 5000 Hadley Ave. South Plainfield, Jersey 07080 (908) 757-8817 x6214
05/02, MTRX192AR

High sensitivity optical receiver front end" module 10Gb/s point-to-po

Top Searches for this datasheet

Other recent searches