SKEW CLOCK DRIVER/ BUFFER MOBILE WITH FOUR SO-DIMMS output buffer

The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.

SKEW CLOCK DRIVER/ BUFFER MOBILE WITH FOUR SO-DIMMS output buffer

Datasheet Thumbnail

Top Searches for this datasheet

QS5810 SKEW CLOCK DRIVER/BUFFER MOBILE
SKEW CLOCK DRIVER/ BUFFER MOBILE WITH FOUR SO-DIMMS
output buffer/driver Tri-state testing programming capability Power Supply Voltage 3.3V Skew Outputs (<200ps) Multiple noise reduction SSOP package
QS5810
DESCRIPTION
QS5810 high speed, noise 1-10 non-inverting buffer designed SDRAM clock buffer applications. outputs,8 could used drive four SDRAM SO-DIMMS, remaining used external feedback stage synchronization master clock. QS5810 also includes interface, which enable disable each output clock driver. turning outputs off, will reducing Electro Magnetic Interference (EMI).
FUNCTIONAL BLOCK DIAGRAM
SDRAM SDRAM SDRAM SDATA DECODING PORT SDRAM SDRAM SDRAM SDRAM BUF_IN SDRAM SDRAM SDRAM
SCLK
1999 Integrated Device Technology, Inc.
APRIL 2000
DSC-5474/-
QS5810 SKEW CLOCK DRIVER/BUFFER MOBILE
CONFIGURATION
ABSOLUTE MAXIMUM RATINGS(1)
Symbol Description Supply Voltage Ground Output Voltage VOUT Output Voltage Input Diode Current with Maximum Power Dissipation 85°C TSTG Storage Temperature Max. 4.6V 4.6V Unit
SDRAM SDRAM SDRAM SDRAM BUF_IN SDRAM SDATA
SDRAM SDRAM SDRAM SDRAM SDRAM GNDI2 SCLK
NOTE: Stresses greater than those listed under ABSOLUTE MAXIMUM RATINGS cause permanent damage device. This stress rating only functional operation device these other conditions above those indicated operational sections this specification implied. Exposure absolute maximum rating conditions extended periods affect reliability.
SSOP VIEW
DESCRIPTION
Name SDRAM (0:3) SDRAM (4:7) SDRAM (8:9) BUF_IN SDATA SCLK GNDI2C VDDI2C Description SDRAM Byte Clock Outputs. SDRAM Byte Clock Outputs. SDRAM Byte Clock Outputs. Input Buffers. Data Input. 100k internal pull VDD. Data Input. 100k internal pull VDD. Tri-State Output Enable. When asserted LOW, clock outputs high impedance. 100k internal pull VDD. 3.3V power supply output buffers. Ground output buffers. Ground circuitry. 3.3V Power Supply circuitry.
QS5810 SKEW CLOCK DRIVER/BUFFER MOBILE
ELECTRICAL CHARACTERISTICS OVER OPERATING RANGE
Following Conditions Apply Unless Otherwise Specified: Operating Condition: 40°C +85°C
Symbol Parameter Input HIGH Voltage Level Input Voltage Level Input High Current Input Current Test Conditions Inputs inputs except inputs (SDATA SCLK) Inputs (SDATA SCLK) BUF_IN SDATA, SCLK 0pF; Supply Current fIN@66.66MHz(1) fIN@66.66MHz(1) fIN@100MHz(1) 0pF; fIN@100MHz(1) 30pF; 30pF; VOLI2C Output High Voltage Output Voltage Output Voltage Min. Typ.(1) Max. Unit
BUF_IN VDD, other inputs SDRAM (0:9) -36mA SDRAM (0:9) 25mA
SDATA IOLI2C
NOTE: Typical values 3.3V, +25°C ambient.
ELECTRICAL CHARACTERISTICS OVER OPERATING RANGE
Symbol
Parameter Rise Time(1) Fall Time(1) Duty Cycle(1) (output-output)(1) Skew
Test Conditions 0.4V 2.4V; 30pF 2.4V 0.4V; 30pF 1.5V; 30pF, with Input Clock 1.5V; 30pF outputs 1.5V 1.5V 1.5V
Min.
Typ.(1)
Max.
Unit
TPHL TPLH TPZL TPZH TPLZ TPHZ
Propagation Delay Enable Delay, SDRAM Disable Delay, SDRAM
OPERATING CHARACTERISTICS 25oC
Symbol Parameter Power Supply Voltage Operating Temperature Load Capacitance Input Capacitance Min. 3.135 Typ. Max. 3.465 Unit
QS5810 SKEW CLOCK DRIVER/BUFFER MOBILE
SERIAL INTERFACE CONTROL
interface permits individual enable/disable each clock output: unused outputs disabled reduce EMI. QS5810 slave receiver device. read back data stored latches verification. data transfer rate supported interface 100k bits/sec. Data transferred bytes (with addition start, stop, acknowledge bits) sequential order from lowest highest byte with ability stop after complete byte been transferred. first bytes transferred must Command Code followed Byte Count. Both these bytes ignored device. address QS5810
Address read/write writes reads. During read back, first byte read Byte Count representing number bytes following (fixed
SERIAL CONFIGURATION COMMAND BITMAPS
Byte SDRAM Active/Inactive Register Enable, Disable), Default Enable
Description Initialize Initialize Initialize Initialize SDRAM (Active/Inactive) SDRAM (Active/Inactive) SDRAM (Active/Inactive) SDRAM (Active/Inactive)
Byte SDRAM Active/Inactive Register Enable, Disable), Default Enable
Description SDRAM (Active/Inactive) SDRAM (Active/Inactive) SDRAM (Active/Inactive) SDRAM (Active/Inactive) Initialize Initialize Initialize Initialize
Byte SDRAM Active/Inactive Register Enable, Disable), Default Enable
Description SDRAM (Active/Inactive) SDRAM (Active/Inactive) Reserved, power Reserved, power Reserved, power Reserved, power Reserved, power Reserved, power
QS5810 SKEW CLOCK DRIVER/BUFFER MOBILE
TEST CIRCUIT
Pulse Generator
aram eter Tested itch osition
tPLZ, tPZL 30pF Others
Closed Open
TEST CIRCUIT ENABLE DISABLE TIMES
ENABLE CONTROL INPUT tPZL OUTPUT NORMALLY tPZH OUTPUT NORMALLY HIGH 0.5V 0.5V 0.3V tPLZ 1.5V 0.3V
PROPAGATION DELAY
INPUT 2.4V OUTPUT 0.4V 0.5V 1.5V
QS5810 SKEW CLOCK DRIVER/BUFFER MOBILE
ORDERING INFORMATION
Device Type Package
Shrink mall Outline Package (SO28-7)
5810
Skew Clock Driver
CORPORATE HEADQUARTERS 2975 Stender Santa Clara, 95054
SALES: 800-345-7015 408-727-6116 fax: 408-492-8674 www.idt.com*
search sales office near you, please click sales button found home page dial 800# above press logo registered trademark Integrated Device Technology, Inc.

SKEW CLOCK DRIVER/ BUFFER MOBILE WITH FOUR SO-DIMMS output buffer

Top Searches for this datasheet

Other recent searches