3.3V CMOS 16-BIT 32-BIT REGISTERED EXCHANGER WITH BYTE MASKS, 3-STATE

The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.

3.3V CMOS 16-BIT 32-BIT REGISTERED EXCHANGER WITH BYTE MASKS, 3-STATE

Datasheet Thumbnail

Top Searches for this datasheet

IDT74ALVCHG162280 3.3V CMOS 16-BIT 32-BIT REGISTERED EXCHANGER
3.3V CMOS 16-BIT 32-BIT REGISTERED EXCHANGER WITH BYTE MASKS, 3-STATE OUTPUTS, BUS-HOLD
MICRON CMOS Technology Typical tSK(0) (Output Skew) 250ps 2000V MIL-STD-883, Method 3015; 200V using machine model 200pF, 0.40mm pitch TVSOP package Commercial range +70°C 3.3V 0.3V, Normal Range CMOS power levels (0.4µ typ. static) Rail-to-Rail output swing increased noise margin switching noise
IDT74ALVCHG162280
device provides synchronous data exchange between ports. Data stored internal registers low-to-high transition clock (CLK) input. data transfer B-to-A direction, select (SEL) input selects data outputs. data transfer A-to-B direction, two-stage pipeline provided path, with single storage register path. Data flow controlled active-low output enable (OE) direction-control (DIR) inputs. control registered synchronize direction changes with clock. mask bits provided both data bytes. data outputs controlled port outputs have equivalent series resistors. port outputs have equivalent series resistors. switching characteristics this spec, based 25pF Port) 80pF Ports) loads, production test accomplished with standard 50pF load. ALVCHG162280 "bus-hold" which retains inputs' last state whenever input goes high impedance. This prevents floating inputs eliminates need pull-up/down resistors.
APPLICATIONS:
SDRAM Modules Motherboards Workstations
DESCRIPTION:
This 16-bit 32-bit registered exchanger manufactured using advanced dual metal CMOS technology. ALVCHG162280 intended applications which data must transferred from narrow highspeed wide lower-frequency bus.
FUNCTIONAL BLOCK DIAGRAM ports)
Channels
1999 Integrated Device Technology, Inc.
JULY 2000
DSC-4559/-
IDT74ALVCHG162280 3.3V CMOS 16-BIT 32-BIT REGISTERED EXCHANGER
FUNCTIONAL BLOCK DIAGRAM Ports)
IDT74ALVCHG162280 3.3V CMOS 16-BIT 32-BIT REGISTERED EXCHANGER
CONFIGURATION
ABSOLUTE MAXIMUM RATINGS
Unit
NEW16link
Symbol Description VTERM(2) Terminal Voltage with Respect VTERM(3) Terminal Voltage with Respect TSTG Storage Temperature IOUT Output Current Continuous Clamp Current, Continuous Clamp Current, Continuous Current through each
Max. ±100
NOTES: Stresses greater than those listed under ABSOLUTE MAXIMUM RATINGS cause permanent damage device. This stress rating only functional operation device these other conditions above those indicated operational sections this specification implied. Exposure absolute maximum rating conditions extended periods affect reliability. terminals. terminals except VCC.
SO80-1
CAPACITANCE +25oC, 1.0MHz)
Symbol COUT CI/O Parameter(1) Conditions Input Capacitance Control Input Input Capacitance port) Output Capacitance VOUT port) Port Capacitance VOUT port) Typ. Max. Unit
NOTE: applicable device type.
DESCRIPTION
Names Description 3-State Output Enable Input (Active LOW) Register Input Clock Select Input Data Inputs(1) Data Inputs(1) 3-State Outputs 3-State Outputs Data Inputs(1) 3-State Outputs Direction Control Input
TVSOP VIEW
NOTE: These pins have "Bus-Hold." other pins standard inputs, outputs, I/Os.
1998 Integrated Device Technology, Inc.
DSC-123456
IDT74ALVCHG162280 3.3V CMOS 16-BIT 32-BIT REGISTERED EXCHANGER
FUNCTION TABLES(1)
A-TO-B STORAGE
Inputs
1B0(2)
C-TO-D STORAGE
Inputs
2B0(2)
Outputs
Outputs
1D0(2) 2D0(2)
L(3) H(3)
L(3) H(3)
B-TO-A STORAGE
Inputs
OUTPUT ENABLE
Output Inputs Active A0(2) Outputs
1Bx, 1Dx,
L(4) H(4)
Active 1B0, 2B0(2)
Active Active Active
NOTES: HIGH Voltage Level Voltage Level Don't Care LOW-to-HIGH Transition High-Impedance Output level before indicated steady-state input conditions were established. edges needed propagate data. edges needed propagate data. data loaded first register when propagates second register when HIGH.
ELECTRICAL CHARACTERISTICS OVER OPERATING RANGE
Following Conditions Apply Unless Otherwise Specified: Operating Condition: +70°C Symbol IOZH IOZL ICCL ICCH ICCZ Parameter Input HIGH Voltage Level Input Voltage Level Input HIGH Current(2) Input Current(2) High Impedance Output Current (excludes bus-hold pins) Input Hysteresis Quiescent Power Supply Current 3.3V 3.6V input 0.6V, other inputs 3-3.6V Test Conditions 3.6V 3.6V 3.6V 3.6V 3.6V Min.
Typ.(1)
Max.
Unit
Quiescent Power Supply Current Variation
NOTES: Typical values 3.3V, +25°C ambient. control I/P's only excludes bus-hold current.
IDT74ALVCHG162280 3.3V CMOS 16-BIT 32-BIT REGISTERED EXCHANGER
BUS-HOLD CHARACTERISTICS
Symbol IBHH IBHL IBHHO IBHLO
NOTES: Pins with Bus-hold identified description. Typical values 3.3V, +25°C ambient.
Parameter(1) Bus-Hold Input Sustain Current Bus-Hold Input Overdrive Current
3.0V 3.6V
Test Conditions 2.0V 0.8V 3.6V
Min.
Typ.(2)
Max.
Unit
OUTPUT DRIVE CHARACTERISTICS
Symbol Parameter Output HIGH Voltage port port) port port) port port) Output Voltage port port) port port) port port)
NOTE: must within min. max. range shown ELECTRICAL CHARACTERISTICS OVER OPERATING RANGE table appropriate range. 70°C.
Test Conditions(1) 3.6V 0.1mA 0.1mA
Min.
Max.
Unit
3.0V 3.0V 3.6V 3.0V
OPERATING CHARACTERISTICS, 25oC
3.3V 0.3V Symbol Parameter Power Dissipation Capacitance Outputs enabled Power Dissipation Capacitance Outputs disabled Test Conditions 0pF, 10Mhz Typical Unit
IDT74ALVCHG162280 3.3V CMOS 16-BIT 32-BIT REGISTERED EXCHANGER
SWITCHING CHARACTERISTICS, 25pF port), 80pF ports)
3.3V 0.3V Symbol tPLH tPHL tPLH tPHL tPLH tPHL tPZH tPZL tPZH tPZL tPZH tPZL tPZH tPZL tPZH tPZL tPHZ tPLZ tPHZ tPLZ tPHZ tPLZ tPHZ tPLZ tPHZ tPLZ fCLOCK
NOTE: test circuits waveforms.
Parameter Propagation Delay, Propagation Delay, Propagation Delay Output Enable Time Output Enable Time Output Enable Time Output Enable Time Output Enable Time Output Disable Time Output Disable Time Output Disable Time Output Disable Time Output Disable Time Setup Time, HIGH LOW, data before Setup Time, HIGH LOW, data before Setup Time, HIGH LOW, data before Setup Time, HIGH LOW, before Setup Time, HIGH LOW, before Hold Time, HIGH LOW, data after Hold Time, HIGH LOW, data after Hold Time, HIGH LOW, data after Hold Time, HIGH LOW, after Hold Time, HIGH LOW, after Pulse Duration, HIGH
Min.
Max.
Unit
IDT74ALVCHG162280 3.3V CMOS 16-BIT 32-BIT REGISTERED EXCHANGER
TEST CIRCUITS WAVEFORMS TEST CONDITIONS PROPAGATION DELAY
Symbol VLOAD VCC(1)= 3.3V 0.3V 25pF Port), 80pF Ports) Unit
OPPOSITE PHASE INPUT TRANSITION OUTPUT tPLH tPHL SAME PHASE INPUT TRANSITION tPLH tPHL
ALVC Link
TEST CIRCUITS OUTPUTS
Pulse Generator
ENABLE DISABLE TIMES
ENABLE DISABLE VLOAD/2
VLOAD Open CONTROL INPUT tPZL
ALVC Link
D.U.T.
VOUT
tPLZ VLOAD/2 tPHZ
DEFINITIONS: Load capacitance: includes probe capacitance. Termination resistance: should equal ZOUT Pulse Generator. NOTE:
Pulse Generator Pulses: Rate 10MHz; 2.5ns; 2.5ns
NOTE: ALVC Link Diagram shown input Control Enable-LOW input Control Disable-HIGH.
OUTPUT SWITCH NORMALLY CLOSED tPZH OUTPUT SWITCH NORMALLY OPEN HIGH
SWITCH POSITION
Test Disable Enable Disable High Enable High Other tests Switch VLOAD Open
SET-UP, HOLD, RELEASE TIMES
DATA INPUT TIMING INPUT ASYNCHRONOUS CONTROL SYNCHRONOUS CONTROL tREM
ALVC Link
PULSE WIDTH
LOW-HIGH-LOW PULSE HIGH-LOW-HIGH PULSE
ALVC Link
IDT74ALVCHG162280 3.3V CMOS 16-BIT 32-BIT REGISTERED EXCHANGER
ORDERING INFORMATION
evice Type ackage ange us-H
Thin utline ackage 80-1
16-B 32-B egistered anger asks, tate tputs ouble-D ensity sistors us-H +70°C
CORPORATE HEADQUARTERS 2975 Stender Santa Clara, 95054
SALES: 800-345-7015 408-727-6116 fax: 408-492-8674 www.idt.com*
search sales office near you, please click sales button found home page dial 800# above press logo registered trademark Integrated Device Technology, Inc.

3.3V CMOS 16-BIT 32-BIT REGISTERED EXCHANGER WITH BYTE MASKS, 3-STATE

Top Searches for this datasheet

Other recent searches