| The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers. |
M200/210 Series Frequency Multipliers DESCRIPTION M200/
Top Searches for this datasheetM200/210 Series M200/210 Series Frequency Multipliers DESCRIPTION M200/210 Series family Phase-Locked Frequency Multipliers that range output frequencies from 200MHz 650MHz. These lowskew, low-noise devices accept either single-ended differential inputs ideally suited applications where environmentally remote stabilized reference available frequency source multiplication. FEATURES 200MHz 650MHz Output Frequency (rms) Typical Phase Jitter 1.5nsec Skew (Fout Fref) Maximum Frequency Lock Range Multiplication Factors from Single Ended Differential Input Models ECL/PECL Differential Outputs Single Supply Operation Extended Temperature Range Models Available M200/210 Frequency Multiplier Series developed specifically meet tough performance requirements found today high-end RISC-based Computers, Telecom Transmission, Base Station, ATE, Datacom applications. Packaged small, 24-pin double-wide metal packages, M200/210 Series devices available with either PECL differential outputs operate from single supply (+5V PECL ECL). Standard models specified +70°C operation. Extended temperature range models available -25°C +85°C operation models) -55°C +125°C operation models). APPLICATIONS High-end RISC-based Computers Telecom Transmission Base Station Datacom 9001 Registered Micro Networks Clark Street Worcester, 01606 tel: 508-852-5400 fax: 508-852-8456 www.micronetworks.com M200/210 Series SPECIFICATIONS Specifications +25°C, -VEE unless otherwise indicated. PARAMETER Units Output Frequency Range Input Frequency Range Multiplication Factor Frequency Lock Range Input Impedence (Note Input Voltage Levels: M200E M200P M210E M210P Output Configuration (Note M200/210E M200/210P Skew (Fout Fref) Rise/Fall Time (20% 80%) Output Voltage Levels: M200/210E M200/210P Output Drive (Note Output Symmetry (Note Output Phase Jitter (Note Start Time Power Supply Requirements: M200/210E (-Vee M200/210P (+Vcc Power Supply Current: M200/210E (-Vee M200/210P (+Vcc ECL, Single Ended PECL, Single Ended ECL, Differntial PECL, Differential Differential Differential PECL compatible PECL compatible nsec psec 45/55 50/55 -5.00 +5.00 -350 +350 55/45 psec (rms) msec Volts Volts -4.35 +4.35 -5.25 +5.25 Notes: output measured with termination resistor connected output jitter measured with maximum input jitter 20psec p-p. Symmetry measured -1.35V M200/210E models +VCC -1.35V M200/210P models. M210 model's input does contain pulldown resistors thereby providing high impedance differential input source. termination resistors should located close input pins possible. differential input voltage should exceed 1.0V. ORDERING INFORMATION Part Number M200P622.080-032K ABSOLUTE RATINGS Operating Temp. Range (Case) -55°C +125°C Specified Temp. Range M2X0X-XXX.XX-XXXK +70°C M2X0X-XXX.XX-XXXL -25°C +85°C M2X0X-XXX.XX-XXXM -55°C +125°C Storage Temp. Range (Ambient) -55°C +125°C Supply M102/210E -7.0 0Volts Supply M102/210P +7.0Volts Output Current 50mA Select M200 single-ended input M210 differential input configuration: Select device output format: Specify PECL Specify frequency xxx.xxxx: Specify multiplication factor: through suffix: +70°C operation -25°C +85°C operation +125°C operation Micro Networks Clark Street Worcester, 01606 tel: 508-852-5400 fax: 508-852-8456 www.micronetworks.com M200/210 Series CONFIGURATIONS M200E Model Ground Ground Volts Ground Volts Ground Volts Ground Osc. Osc. Ground Ground Ground Ground Ground Volts Volts Ground Volts Test Point Volts Ground M200P Model Ground24. Ground Ground Ground Ground Ground Ground Volts Ground Ground Volts Ground Ground Volts Volts Ground Osc. Test Point Osc. Ground Volts Volts VIEW M210E Model Ground Volts Ground Volts Ground Volts Ground Osc. Osc. Ground Volts Ground Ground Ground Volts Volts Ground Volts Test Point Volts Ground M210P Model Volts Ground Volts Ground Volts Ground Volts Osc. Osc. Volts Ground Ground Ground Ground Ground Ground Volts Ground Test Point Ground Volts PACKAGE OUTLINES Micro Networks Clark Street Worcester, 01606 tel: 508-852-5400 fax: 508-852-8456 www.micronetworks.com M200/210 Series APPLICATION CIRCUITS Micro Networks makes assertion warranty that circuitry uses thereof disclosed herein non-infringing valid foreign patents. Micro Networks assumes liability result said specifications reserves right make changes specifications without notice. Contact your nearest Micro Networks sales representative office latest specifications. Micro Networks Integrated Circuit Systems Company Clark Street Worcester, 01606 tel: 508-852-5400 fax: 508-852-8456 European Sales Headquarters Micro Networks Hertogsingel 6214 Maastricht Netherlands tel: +31-43-32-70912 fax: 508-852-8456 fax: +31-43-32-70715 www.micronetworks.com Clark Street www.micronetworks.com Worcester, 01606 tel: 508-852-5400 Other recent searchesZX95-2952+ - ZX95-2952+ ZX95-2952+ Datasheet RA07N3340M - RA07N3340M RA07N3340M Datasheet OPA512 - OPA512 OPA512 Datasheet MPX2300DT1 - MPX2300DT1 MPX2300DT1 Datasheet MBR20200CT - MBR20200CT MBR20200CT Datasheet HDE-20 - HDE-20 HDE-20 Datasheet HDP-20 - HDP-20 HDP-20 Datasheet HDP-22 - HDP-22 HDP-22 Datasheet DM54123 - DM54123 DM54123 Datasheet DM74123 - DM74123 DM74123 Datasheet
Privacy Policy | Disclaimer |