IDT74LVCH16245A 3.3V CMOS 16-BIT TRANSCEIVER WITH 3-STATE OUTPUTS, VOL
|
|
|
Top Searches for this datasheet
IDT74LVCH16245A 3.3V CMOS 16-BIT TRANSCEIVER WITH 3-STATE OUTPUTS
IDT74LVCH16245A 3.3V CMOS 16-BIT TRANSCEIVER WITH 3-STATE OUTPUTS, VOLT TOLERANT BUS-HOLD
Typical tSK(o) (Output Skew) 250ps 2000V MIL-STD-883, Method 3015; 200V using machine model 200pF, 3.3V 0.3V, Normal Range 2.7V 3.6V, Extended Range CMOS power levels (0.4 typ. static) inputs, outputs, tolerant Available SSSOP TSSOP packages
DESCRIPTION:
This 16-bit transceiver built using advanced dual metal CMOS technology. This high-speed, power transceiver ideal asynchronous communication between busses Direction Output Enable controls designed operate this device either independent 8-bit transceivers 16-bit transceiver. direction control (DIR) controls direction data flow. output enable (OE) overrides direction control disables both ports. inputs designed with hysteresis improved noise margin. pins driven from either 3.3V devices. This feature allows this device translator mixed 3.3V/5V supply system. LVCH16245A been designed with ±24mA output driver. This driver capable driving moderate heavy load while maintaining speed performance. LVCH16245A "bus-hold" which retains inputs' last state whenever input goes high impedance. This prevents floating inputs eliminates need pull-up/down resistors.
DRIVE High Output Drivers: ±24mA Reduced system switching noise
APPLICATIONS:
3.3V mixed voltage systems Data communication telecommunication systems
FUNCTIONAL BLOCK DIAGRAM
1DIR
2DIR
logo registered trademark Integrated Device Technology, Inc.
2006 Integrated Device Technology, Inc.
JUNE 2006
DSC-4596/4
IDT74LVCH16245A 3.3V CMOS 16-BIT TRANSCEIVER WITH 3-STATE OUTPUTS
CONFIGURATION
1DIR
ABSOLUTE MAXIMUM RATINGS(1)
Symbol VTERM Description Terminal Voltage with Respect Storage Temperature Output Current Continuous Clamp Current, Continuous Current through each -0.5 +6.5 +150 ±100 Unit
TSTG IOUT
NOTE: Stresses greater than those listed under ABSOLUTE MAXIMUM RATINGS cause permanent damage device. This stress rating only functional operation device these other conditions above those indicated operational sections this specification implied. Exposure absolute maximum rating conditions extended periods affect reliability.
CAPACITANCE +25°C, 1.0MHz)
Symbol COUT CI/O Parameter(1) Input Capacitance Output Capacitance Port Capacitance Conditions VOUT Typ. Max. Unit
NOTE: applicable device type.
DESCRIPTION
Names Description Output Enable Inputs (Active LOW) Direction Control Input Side Inputs 3-State Outputs(1) Side Inputs 3-State Outputs(1) xDIR
2DIR
NOTE: These pins have "Bus-Hold". other pins standard inputs, outputs, I/Os.
FUNCTION TABLE (EACH 8-BIT SECTION)(1)
Inputs xDIR Outputs Data Data Isolation
SSOP/ TSSOP VIEW
NOTES: HIGH Voltage Level Don't Care Voltage Level
IDT74LVCH16245A 3.3V CMOS 16-BIT TRANSCEIVER WITH 3-STATE OUTPUTS
ELECTRICAL CHARACTERISTICS OVER OPERATING RANGE
Following Conditions Apply Unless Otherwise Specified: Operating Condition: -40°C +85°C
Symbol Parameter Input HIGH Voltage Level 2.3V 2.7V 2.7V 3.6V IOZH IOZL IOFF ICCL ICCH ICCZ High Impedance Output Current (3-State Output pins) Input/Output Power Leakage Clamp Diode Voltage Input Hysteresis Quiescent Power Supply Current 5.5V 2.3V, -18mA 3.3V 3.6V -0.7 -1.2 3.6V 5.5V Input Voltage Level Input Leakage Current 2.3V 2.7V 2.7V 3.6V 3.6V 5.5V Test Conditions Min. Typ.(1) Max. Unit
Quiescent Power Supply Current Variation
5.5V(2) input 0.6V, other inputs
NOTES: Typical values 3.3V, +25°C ambient. This applies disabled state only.
BUS-HOLD CHARACTERISTICS
Symbol IBHH IBHL IBHH IBHL IBHHO IBHLO
NOTES: Pins with Bus-Hold identified description. Typical values 3.3V, +25°C ambient.
Parameter(1) Bus-Hold Input Sustain Current Bus-Hold Input Sustain Current Bus-Hold Input Overdrive Current 2.3V 3.6V
Test Conditions 0.8V 1.7V 0.7V 3.6V
Min.
Typ.(2)
Max. ±500
Unit
IDT74LVCH16245A 3.3V CMOS 16-BIT TRANSCEIVER WITH 3-STATE OUTPUTS
OUTPUT DRIVE CHARACTERISTICS
Symbol Parameter Output HIGH Voltage 2.3V 2.3V 2.7V Output Voltage 2.3V 3.6V 2.3V 2.7V 24mA 0.1mA 12mA 12mA 24mA Test Conditions(1) 2.3V 3.6V 0.1mA 12mA Min. Max. 0.55 Unit
NOTE: must within min. max. range shown ELECTRICAL CHARACTERISTICS OVER OPERATING RANGE table appropriate range. 40°C 85°C.
OPERATING CHARACTERISTICS, 3.3V 0.3V, 25°C
Symbol Parameter Power Dissipation Capacitance Transceiver Outputs enabled Power Dissipation Capacitance Transceiver Outputs disabled Test Conditions 0pF, 10Mhz Typical Unit
SWITCHING CHARACTERISTICS(1)
2.7V Symbol tPLH tPHL tPZH tPZL tPHZ tPLZ tSK(o) Parameter Propagation Delay xBx, Output Enable Time Output Disable Time Output Skew(2) Min. Max. 3.3V 0.3V Min. Max. Unit
NOTES: TEST CIRCUITS WAVEFORMS. 40°C 85°C. Skew between outputs same package switching same direction.
IDT74LVCH16245A 3.3V CMOS 16-BIT TRANSCEIVER WITH 3-STATE OUTPUTS
TEST CIRCUITS WAVEFORMS TEST CONDITIONS
Symbol VLOAD VCC(1)= 3.3V±0.3V VCC(1)= 2.7V VCC(2)= 2.5V±0.2V Unit
OPPOSITE PHASE INPUT TRANSITION OUTPUT tPLH tPHL SAME PHASE INPUT TRANSITION tPLH tPHL
Link
Propagation Delay
Pulse Generator D.U.T.
Link
VLOAD Open VOUT CONTROL INPUT
ENABLE
DISABLE
tPZL OUTPUT SWITCH NORMALLY CLOSED tPZH OUTPUT SWITCH NORMALLY OPEN HIGH VLOAD/2 tPHZ
tPLZ
VLOAD/2
Link
Test Circuit Outputs
DEFINITIONS: Load capacitance: includes probe capacitance. Termination resistance: should equal ZOUT Pulse Generator. NOTES: Pulse Generator Pulses: Rate 10MHz; 2.5ns; 2.5ns. Pulse Generator Pulses: Rate 10MHz; 2ns; 2ns.
Enable Disable Times
NOTE: Diagram shown input Control Enable-LOW input Control Disable-HIGH.
SWITCH POSITION
Test Open Drain Disable Enable Disable High Enable High Other Tests Switch VLOAD Open
DATA INPUT TIMING INPUT ASYNCHRONOUS CONTROL SYNCHRONOUS CONTROL
tREM
Link
INPUT
tPLH1
tPHL1
Set-up, Hold, Release Times
LOW-HIGH-LOW PULSE HIGH-LOW-HIGH PULSE
Link
OUTPUT
OUTPUT tPLH2 tPHL2
tSK(x) tPLH2 tPLH1 tPHL2 tPHL1
Pulse Width
Link
Output Skew tSK(X)
NOTES: tSK(o) OUTPUT1 OUTPUT2 outputs. tSK(b) OUTPUT1 OUTPUT2 same bank.
IDT74LVCH16245A 3.3V CMOS 16-BIT TRANSCEIVER WITH 3-STATE OUTPUTS
ORDERING INFORMATION
Bus-Hold Temp. Range Family XXXX Device Type Package
Shrink Small Outline Package SSOP Green Thin Shrink Small Outline Package TSSOP Green
245A 16-Bit Transceiver with 3-State Outputs Double-Density, ±24mA
Bus-hold -40°C +85°C
CORPORATE HEADQUARTERS 6024 Silver Creek Valley Road Jose, 95138
SALES: 800-345-7015 408-284-8200 fax: 408-284-2775 www.idt.com
Tech Support: logichelp@idt.com
Other recent searches
TDA1082 - TDA1082 TDA1082 Datasheet
PF600-1 - PF600-1 PF600-1 Datasheet
CY7C1327F - CY7C1327F CY7C1327F Datasheet
2SA1535 - 2SA1535 2SA1535 Datasheet
2SA1535A - 2SA1535A 2SA1535A Datasheet
1638610000 - 1638610000 1638610000 Datasheet
Privacy Policy | Disclaimer
© 2012 Datasheet Archive
