transducer electronic measurement distorted waveforms current, with ga

The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.

transducer electronic measurement distorted waveforms current, with ga

Datasheet Thumbnail

Top Searches for this datasheet

AC/DC Current transducer DHR-C10
transducer electronic measurement distorted waveforms current, with galvanic isolation between primary (High power) secondary circuits (Electronic circuit). True 0-10V voltage output.
100.1000
Primary Nominal Current (A.t.RMS) 1000 Primary Current Max. Peak Value 1000 1000 1800 1800 1800 Analogue Output Signal (VDC) 0-10 0-10 0-10 0-10 0-10 0-10 0-10 Type
Features
waveforms current measurement True output Panel mounting Eliminates insertion loss
1000
Load resistance Supply voltage Current Consumption Limitation voltage output (0-10V) Overloaded input current (Ampere Turns)
30000
Advantages
Large aperture cable High isolation between primary secondary circuits Easy mount
Accuracy-Dynamic performance data
Accuracy IPN, 25°C (without offset) Linearity IPN) Electrical offset voltage, 25°C Thermal drift (-20.+60 (-40.+70 Thermal drift gain reading) Response time Frequency bandwidth (±1%)
±1.0 ±1.0 mV/K ±2.0 mV/K ±0.1 20.6000Hz
Applications
Controlled Loads: output indicates motor attached load operating. Controlled Loads: Acurate measurement phase angle fired burst fired (time proportioned) SCRs. Current measurement gives faster response than temperature measurement. Switching Power Supplies Electronic Ballasts: True sensing most accurate measure power supply ballast input power.
General data
Ambient operating temperature Ambient storage temperature Mass Protection type UL94 classification IP20
Notes Installation maintenance should done with power supply disconnected.
operator must have accrediation install this material. users must take care protection gurantee against electrical shock.
050526/4
reserves right carry modifications transducers, order improve them, without previous notice. Page
Components
www.lem.com
Current Transducer DHR-C10
Isolation characteristics
Rated Voltage 1000 with 61010-1 acc. 61326 standards following conditions Single insulation Over voltage category Pollution degree None uniform field R.m.s. voltage insulation test, 50Hz, 1min Creepage distance Clearance distance Comparative tracking index (Group
Notes Output polarity with input
Output
-Ipn
+Ipn
050526/4
reserves right carry modifications transducers, order improve them, without previous notice. Page
Components
www.lem.com
Dimensions DHR-C10 0.0394 inch)
8.30
Connections
Wires
Mechanical characteristics
General tolerance Primary aperture Panel mounting Distance between holes 32.0 holes 70.0
Output Connector 1(+) 2(none) 3(out) 4(GND) Power
(see above dimensions) panel mounting, replace screws (not supplied) with appropriate length thickness.
Safety
Load
(Controller, meter etc)
This transducer must used electric/electronic equipment with respect applicable standards safety requirements accordance with following manufacturer's operating instructions.
+24VDC
Caution, risk electrical shock When operating transducer, certain parts module carry hazardous voltage (eg. primary busbar, power supply). Ignoring this warning lead injury and/or cause serious damage. This transducer built-in device, whose conducting parts must inaccessible after installation. protective housing additional shield could used. Main supply must able disconnected. 050526/4
Page
reserves right carry modifications transducers, order improve them, without previous notice.
Components
www.lem.com

transducer electronic measurement distorted waveforms current, with ga

Top Searches for this datasheet

Other recent searches