KTR03 (0603 size 10W) Features Power rating Limiting element volt

The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.

KTR03 (0603 size 10W) Features Power rating Limiting element volt

Datasheet Thumbnail

Top Searches for this datasheet

High Voltage Resistance Chip Resistors
KTR03 (0603 size 10W)
Features Power rating Limiting element voltage series times compared with that series. Highly reliable chip resistor Ruthenium oxide dielectric offers superior resistance elements. ROHM resistors have approved ISO9001- ISO/TS 16949- certification. Design specifications subject change without notice. Carefully check specification sheet before using ordering Ratings
Item Rated power Conditions Power must derated according power derating curve Figure when ambient temperature exceeds 70°C.
POWER LOAD
Specifications 0.10W 10W) 70°C
AMBIENT TEMPERATURE (°C)
Fig.1 Rated voltage voltage rating calculated following equation. value obtained exceeds limiting element voltage, voltage rating equal maximum operating voltage. Rated voltage Rated power Nominal resistance Nominal resistance Operating temperature Table -55°C 155°C Limiting element voltage 350V
Table Resistance tolerance (±1%) (±5%) Resistance range Resistance temperature coefficient (ppm/°C)
(E24) (E24)
±100 ±200
Before using components circuits where they will exposed transients such pulse loads (short-duration, high- level loads), certain evaluate component mounted state. addition, reliability performance this component cannot guaranteed used with steady state voltage that greater than rated voltage.
www.rohm.com
2009 ROHM Co., Ltd. rights reserved.
2009.08 Rev.C
KTR03
Characteristics
Item Resistance Variation resistance with temperature Overload Guaranteed value Resistor type Table.1 (2.0%+0.1) Test conditions (JIS 5201-1) 5201-1 5201-1 Measurement +125°C 5201-1 4.13 Rated voltage (current) Maximum overload voltage 500V 5201-1 4.17 (25%WT) Soldering condition 235±5°C Duration immersion 2.0±0.5s. 5201-1 4.18 Soldering condition 260±5°C Duration immersion 10±1s. 5201-1 4.19 Test temp. -55°C +125°C 5cyc 5201-1 4.24 40°C, 93%RH Test time 1,000h 1,048h 5201-1 4.25.1 Rated voltage (current), 70°C 1.5h 0.5h Test time 1,000h 1,048h 5201-1 4.25.3 155°C Test time 1,000h 1,048h 5201-1 4.29 23±5°C, Immersion cleaning, 5±0.5min. Solvent 2-propanol 5201-1 4.33
Data Sheet
Solderability
uniform coating minimum surface being immersed soldering damage. (1.0%+0.05) remarkable abnormality appearance. (1.0%+0.05)
Resistance soldering heat Rapid change temperature Damp heat, steady state
(3.0%+0.1)
Endurance 70°C
(3.0%+0.1)
Endurance
(3.0%+0.1)
Resistance solvent
(1.0%+0.05) (1.0%+0.05) Without mechanical damage such breaks.
Bend strength face plating
Dimensions (Unit
0.3±0.2
Material Resistive element (Oxide metal thick film) Silver thick film electrode Nickel electrode electrode Alumina substrate Overcoating (Resin)
0.3±0.2 1.6±0.1
0.45±0.1
Mark
www.rohm.com
2009 ROHM Co., Ltd. rights reserved.
0.8±0.1
2009.08 Rev.C
KTR03
Packaging
Reel Taping
Data Sheet
Heat crimp cover/Tape
Label EIAJ ET-7200B compliant
Thick paper mount
Chip resistor Square punchout hole
(Underside paper tape)
(Unit:
(Unit: -1.5 +1.0 13±0.2
8.0±0.3 +0.1
3.5±0.05 4.0±0.1
1.75±0.1 4.0±0.1
1.1±0.1 2.0±0.05
1.9±0.1 Max.
Part Explanation
Part
Resistance tolerance
Nominal resistance
Resistance code, digits.
Resistance tolerance
Resistance code digits digits
Packaging Specifications Code
Part KTR03 Code Resistance tolerance J(±5%) F(±1%) Packaging specifications Paper tape (4mm Pitch) Reel 180mm (7inch) Basic ordering unit(pcs) 5,000
Reel (180mm) Compatible with JEITA standard "EIAJ ET-7200B" Standard product
www.rohm.com
2009 ROHM Co., Ltd. rights reserved.
2009.08 Rev.C
Notice
Notes
copying reproduction this document, part whole, permitted without consent ROHM Co.,Ltd. content specified herein subject change improvement without notice. content specified herein purpose introducing ROHM's products (hereinafter "Products"). wish such Product, please sure refer specifications, which obtained from ROHM upon request. Examples application circuits, circuit constants other information contained herein illustrate standard usage operations Products. peripheral conditions must taken into account when designing circuits mass production. Great care taken ensuring accuracy information specified this document. However, should incur damage arising from inaccuracy misprint such information, ROHM shall bear responsibility such damage. technical information specified herein intended only show typical functions examples application circuits Products. ROHM does grant you, explicitly implicitly, license exercise intellectual property other rights held ROHM other parties. ROHM shall bear responsibility whatsoever dispute arising from such technical information. Products specified this document intended used with general-use electronic equipment devices (such audio visual equipment, office-automation equipment, communication devices, electronic appliances amusement devices). Products specified this document designed radiation tolerant. While ROHM always makes efforts enhance quality reliability Products, Product fail malfunction variety reasons. Please sure implement your equipment using Products safety measures guard against possibility physical injury, fire other damage caused event failure Product, such derating, redundancy, fire control fail-safe designs. ROHM shall bear responsibility whatsoever your Product outside prescribed scope accordance with instruction manual. Products designed manufactured used with equipment, device system which requires extremely high level reliability failure malfunction which result direct threat human life create risk human injury (such medical instrument, transportation equipment, aerospace machinery, nuclear-reactor controller, fuel-controller other safety device). ROHM shall bear responsibility Products above special purposes. Product intended used such special purpose, please contact ROHM sales representative before purchasing. intend export ship overseas Product technology specified herein that controlled under Foreign Exchange Foreign Trade Law, will required obtain license permit under Law.
Thank your accessing ROHM product informations. More detail product informations catalogs available, please contact
ROHM Customer Support System
http://www.rohm.com/contact/
www.rohm.com 2009 ROHM Co., Ltd. rights reserved.
R0039A

KTR03 (0603 size 10W) Features Power rating Limiting element volt

Top Searches for this datasheet

Other recent searches