RADIATION HARDENED POWER MOSFET THRU-HOLE (TO-254AA) Part Number

The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.

RADIATION HARDENED POWER MOSFET THRU-HOLE (TO-254AA) Part Number

Datasheet Thumbnail

Top Searches for this datasheet

91224D
RADIATION HARDENED POWER MOSFET THRU-HOLE (TO-254AA)
Part Number IRHM7360SE Radiation Level RDS(on) 100K Rads (Si) 0.20
Hard HEXFET TECHNOLOGY
IRHM7360SE JANSR2N7391 400V, N-CHANNEL REF:MIL-PRF-19500/661
Part Number JANSR2N7391
International Rectifiers RADHardHEXFET® MOSFET technology provides high performance power MOSFETs space applications. This technology over decade proven performance reliability satellite applications. These devices have been characterized both Total Dose Single Event Effects (SEE). combination RDS(on) gate charge reduces power losses switching applications such converters motor control. These devices retain well established advantages MOSFETs such voltage control, fast switching, ease paralleling temperature stability electrical parameters.
TO-254AA
Features:
Single Event Effect (SEE) Hardened Ultra RDS(on) Total Gate Charge Proton Tolerant Simple Drive Requirements Ease Paralleling Hermetically Sealed Light Weight
Absolute Maximum Ratings
Parameter
12V, 25°C 12V, 100°C 25°C dv/dt TSTG Continuous Drain Current Continuous Drain Current Pulsed Drain Current Max. Power Dissipation Linear Derating Factor Gate-to-Source Voltage Single Pulse Avalanche Energy Avalanche Current Repetitive Avalanche Energy Peak Diode Recovery dv/dt Operating Junction Storage Temperature Range Lead Temperature Weight footnotes refer last page
Pre-Irradiation
Units
W/°C
V/ns
(0.063 (1.6mm) from case sec.) (Typical)
www.irf.com
5/17/01
IRHM7360SE
Pre-Irradiation
25°C (Unless Otherwise Specified)
Electrical Characteristics
Parameter
Units
0.51 0.20 0.21 -100 V/°C
Test Conditions
1.0mA Reference 25°C, 1.0mA 12V, 12V, VGS, 1.0mA 15V, VDS= 320V ,VGS=0V 320V, 125°C -20V =12V, 200V =200V, =22A, =12V, 2.35
BVDSS Drain-to-Source Breakdown Voltage Temperature Coefficient Breakdown Voltage RDS(on) Static Drain-to-Source On-State Resistance VGS(th) Gate Threshold Voltage Forward Transconductance IDSS Zero Gate Voltage Drain Current
IGSS IGSS td(on) td(off)
Gate-to-Source Leakage Forward Gate-to-Source Leakage Reverse Total Gate Charge Gate-to-Source Charge Gate-to-Drain (Miller) Charge Turn-On Delay Time Rise Time Turn-Off Delay Time Fall Time Total Inductance
Measured from drain lead (6mm/0.25in. from package) source lead (6mm/0.25in. from package)
Ciss
Input Capacitance Output Capacitance Reverse Transfer Capacitance
4000 1000
1.0MHz
Source-Drain Diode Ratings Characteristics
Parameter
Continuous Source Current (Body Diode) Pulse Source Current (Body Diode) Diode Forward Voltage Reverse Recovery Time Reverse Recovery Charge Forward Turn-On Time
Units
Test Conditions
25°C, 22A, 25°C, 22A, di/dt 100A/µs
Intrinsic turn-on time negligible. Turn-on speed substantially controlled
Thermal Resistance
Parameter
RthJC RthCS RthJA Junction-to-Case Case-to-Sink Junction-to-Ambient
Units
0.50 0.21
°C/W
Test Conditions
Typical socket mount
Note: Corresponding Spice Saber models available Website. footnotes refer last page
www.irf.com
Pre-Irradiation
IRHM7360SE
International Rectifier Radiation Hardened MOSFETs tested verify their radiation hardness capability. hardness assurance program International Rectifier comprised radiation environments. Every manufacturing tested total ionizing dose (per notes using TO-3 package. Both pre- post-irradiation performance tested specified using same drive circuitry test conditions order provide direct comparison.
Table Electrical Characteristics 25°C, Post Total Dose Irradiation
Parameter
BVDSS V/5JD IGSS IGSS IDSS RDS(on) RDS(on) Drain-to-Source Breakdown Voltage Gate Threshold Voltage Gate-to-Source Leakage Forward Gate-to-Source Leakage Reverse Zero Gate Voltage Drain Current Static Drain-to-Source# On-State Resistance (TO-3) Static Drain-to-Source# On-State Resistance (TO-254) Diode Forward Voltage#
100K Rads (Si)
-100 0.20 0.20
Units
Test Conditions
1.0mA VDS, 1.0mA -20V VDS= 320V, VGS=0V 12V, 12V,
International Rectifier radiation hardened MOSFETs have been characterized heavy environment Single Event Effects (SEE). Single Event Effects characterization illustrated Fig. Table
Table Single Event Effect Safe Operating Area
Energy Range MeV/(mg/cm (MeV) (µm) @V/5=0V @V/5=-5V @V/5=-10V @V/5=-15V @V/5=-20V @V/5=-25V 36.8
Single Event Effect, Safe Operating Area
footnotes refer last page
www.irf.com
IRHM7360SE
Pre-Irradiation
Drain-to-Source Current
Drain-to-Source Current
9.0V 8.0V 7.0V 6.0V BOTTOM 5.0V
9.0V 8.0V 7.0V 6.0V BOTTOM 5.0V
5.0V
5.0V
20µs PULSE WIDTH
20us PULSE WIDTH 150o
Drain-to-Source Voltage
Drain-to-Source Voltage
Typical Output Characteristics
Typical Output Characteristics
RDS(on) Drain-to-Source Resistance (Normalized)
ID=22A
Drain-to-Source Current
20µs PULSE WIDTH
10.8 12.0
Gate-to-Source Voltage
Junction Temperature
Typical Transfer Characteristics
Normalized On-Resistance Temperature
www.irf.com
Pre-Irradiation
IRHM7360SE
8000
Gate-to-Source Voltage
1MHz Ciss SHORTED Crss Coss
ID=22A
Capacitance (pF)
6000
320V 200V
Ciss
4000
Coss
2000
Crss
TEST CIRCUIT FIGURE
Drain-to-Source Voltage
Total Gate Charge (nC)
Typical Capacitance Drain-to-Source Voltage
Typical Gate Charge Gate-to-Source Voltage
1000
Reverse Drain Current
OPERATION THIS AREA LIMITED RDS(on)
Drain Current
10us
100us
Single Pulse
10ms 1000
,Source-to-Drain Voltage
Drain-to-Source Voltage
Typical Source-Drain Diode Forward Voltage
Maximum Safe Operating Area
www.irf.com
IRHM7360SE
Pre-Irradiation
D.U.T.
Drain Current
-VDD
Pulse Width Duty Factor
10a. Switching Time Test Circuit
Case Temperature
Maximum Drain Current Case Temperature
td(on)
d(off)
10b. Switching Time Waveforms
Thermal Response thJC
0.50 0.20 0.10 0.05 0.02 0.01 Notes: Duty factor Peak thJC 0.0001 0.001 0.01
0.01
SINGLE PULSE (THERMAL RESPONSE)
0.001 0.00001
Rectangular Pulse Duration (sec)
Maximum Effective Transient Thermal Impedance, Junction-to-Case
www.irf.com
Pre-Irradiation
IRHM7360SE
Single Pulse Avalanche Energy (mJ)
1000
BOTTOM
DRIVER
D.U.T.
0.01
12a. Unclamped Inductive Test Circuit
V(BR)DSS
Starting Junction Temperature
12c. Maximum Avalanche Energy Drain Current
12b. Unclamped Inductive Waveforms
Current Regulator Same Type D.U.T.
.2µF .3µF
D.U.T.
Charge
Current Sampling Resistors
13a. Basic Gate Charge Waveform
13b. Gate Charge Test Circuit
www.irf.com
IRHM7360SE
Pre-Irradiation
Footnotes:
Repetitive Rating; Pulse width limited
maximum junction temperature. 50V, starting 25°C, Peak 22A, 22A, di/dt 120A/µs, 400V, 150°C
Pulse width Duty Cycle Total Dose Irradiation with Bias.
volt applied during irradiation MIL-STD-750, method 1019, condition Total Dose Irradiation with Bias. volt applied during irradiation MlL-STD-750, method 1019, condition
Case Outline Dimensions TO-254AA
.005 3.78 .149 3.53 .139 -A13.84 .545 13.59 .535 6.60 .260 6.32 .249 -B1.27 .050 1.02 .040
17.40 .685 16.89 .665 31.40 1.235 30.39 1.199
20.32 .800 20.07 .790
13.84 .545 13.59 .535
LEGEND COLL EMIT GATE
3.81 .150 NOTES:
1.14 .045 0.89 .035 .020 .010
3.81 .150
IRHM57163SED IRHM57163SEU
LEGEND DRAIN SOURCE GATE
CAUTION BERYLLIA WARNING MIL-PRF-19500 Package containing beryllia shall ground, sandblasted, machined, have other operations performed them which will produce beryllia beryllium dust. Furthermore, beryllium oxide packages shall placed acids that will produce fumes containing beryllium.
WORLD HEADQUARTERS: Kansas St., Segundo, California 90245, Tel: (310) 252-7105 Fax: (310) 252-7903 Visit www.irf.com sales contact information. Data specifications subject change without notice. 05/01
www.irf.com

RADIATION HARDENED POWER MOSFET THRU-HOLE (TO-254AA) Part Number

Top Searches for this datasheet

Other recent searches