Dual-PLL Clock Generator Features Description Uses inex

The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.

Dual-PLL Clock Generator Features Description Uses inex

Datasheet Thumbnail

Top Searches for this datasheet

FS6206
Dual-PLL Clock Generator
Features
Description
Uses inexpensive fundamental-mode crystals Integrated phase-locked loops (PLL) multiply crystal frequency higher system frequencies needed 3.3V supply voltage available Small circuit board footprint (8-pin 0.150 SOIC) Custom frequency selections available contact your local Sales Representative more information
FS6206 monolithic CMOS clock generator designed minimize cost component count. on-chip crystal oscillator generates reference frequency phase-locked loops used generate precise output reference frequency ratios. Table information frequency ratios programmed into each version FS6206.
Table Version Information Figure Configuration
DEVICE
FREF (MHz)
(MHz) 0.0000 (Stopped Low) 162.5239 (FREF 173.2151 (FREF 173.2343 (FREF 1101
XOUT
FS6206-01 14.318182
FS6206
NOTE: Contact custom versions
8-pin (0.150) SOIC
Figure Block Diagram
Crystal Oscillator XOUT
SEL[1:0]
FS6206
American Microsystems, Inc. reserves right change detail specifications required permit improvements design products.
ISO9001
2.28.02
FS6206
Dual-PLL Clock Generator
Table Descriptions
Key: Analog Input; Analog Output; Digital Input; Input with Internal Pull-Up; Input with Internal Pull-Down; Digital Input/Output; DI-3 Three-Level Digital Input, Digital Output; Power/Ground; Active
TYPE
NAME CLKB XOUT Crystal Oscillator Feedback
DESCRIPTION
Power Supply (+3.3V +5V) Version Information Ground Ground Clock Output Control Input (see Table) Control Input (see Table) Crystal Oscillator Drive
ISO9001
2.28.02
FS6206
Dual-PLL Clock Generator
Electrical Specifications
Table Absolute Maximum Ratings
Stresses above those listed under Absolute Maximum Ratings cause permanent damage device. These conditions represent stress rating only, functional operation device these other conditions above operational limits noted this specification implied. Exposure maximum rating conditions extended conditions affect device performance, functionality, reliability.
PARAMETER Supply Voltage (VSS ground) Input Voltage, Output Voltage, Input Clamp Current, VDD) Output Clamp Current, VDD) Storage Temperature Range (non-condensing) Ambient Temperature Range, Under Bias Junction Temperature Lead Temperature (soldering, 10s) Input Static Discharge Voltage Protection (MIL-STD 883E, Method 3015.7)
SYMBOL
MIN. VSS-0.5 VSS-0.5 VSS-0.5
MAX. VDD+0.5 VDD+0.5
UNITS
CAUTION: ELECTROSTATIC SENSITIVE DEVICE
Permanent damage resulting loss functionality performance occur this device subjected high-energy electrostatic discharge.
Table Operating Conditions
PARAMETER Supply Voltage (3.3 volt system) Supply Voltage (5.0 volt system) Ambient Operating Temperature Range Crystal Resonator Frequency SYMBOL fXTAL CONDITIONS/DESCRIPTION NOTE NOTE NOTE Fundamental Mode MIN. TYP. MAX. UNITS
NOTE These specifications represent generic FS6206 device capability. Device specifications particular version (i.e. FS6206-xx) guaranteed only with operating voltage reference frequency specified Version Information.
ISO9001
2.28.02
FS6206
Dual-PLL Clock Generator
Package Information
Table 8-pin SOIC (0.150") Package Dimensions
DIMENSIONS INCHES MIN. 0.061 0.004 0.055 0.013 0.0075 0.189 0.150 0.230 0.010 0.016 MAX. 0.068 0.0098 0.061 0.019 0.0098 0.196 0.157 0.244 0.016 0.035 MILLIMETERS MIN. 1.55 0.102 1.40 0.33 0.191 4.80 3.81 5.84 0.25 0.41 MAX. 1.73 0.249 1.55 0.49 0.249 4.98 3.99 6.20 0.41 0.89
BASE PLANE RADII: 0.005" 0.01"
AMERICAN MICROSYSTEMS, INC.
SEATING PLANE
typ.
0.050
1.27
Table 8-pin SOIC (0.150") Package Characteristics
PARAMETER Thermal Impedance, Junction Free-Air 8-pin 0.150" SOIC Lead Inductance, Self Lead Inductance, Mutual Lead Capacitance, Bulk SYMBOL CONDITIONS/DESCRIPTION flow Corner lead Center lead lead adjacent lead lead TYP. 0.27 UNITS °C/W
ISO9001
2.28.02
FS6206
Dual-PLL Clock Generator
Ordering Information
Table Device Ordering Codes
ORDERING CODE DEVICE NUMBER PACKAGE TYPE 8-pin (0.150") SOIC (Small Outline Package) 8-pin (0.150") SOIC (Small Outline Package) OPERATING TEMPERATURE RANGE 70°C (Commercial) 70°C (Commercial) SHIPPING CONFIGURATION Tape Reel Tubes
11640-824 11640-834
FS6206-01 FS6206-01
Revision Information
DATE 4/24/00 4/24/00 PAGE DESCRIPTION Added ordering code information Fixed formatting errors
Copyright 1999, 2000 American Microsystems, Inc.
Devices sold covered warranty patent indemnification provisions appearing Terms Sale only. makes warranty, express, statutory implied description, regarding information forth herein regarding freedom described devices from patent infringement. makes warranty merchantability fitness purposes. reserves right discontinue production change specifications prices time without notice. AMI's products intended commercial applications. Applications requiring extended temperature range, unusual environmental requirements, high reliability applications, such military, medical life-support life-sustaining equipment, specifically recommended without additional processing such applications.
American Microsystems, Inc., 2300 Buckskin Rd., Pocatello, 83201, (208) 233-4690, (208) 234-6796, Address: http://www.amis.com E-mail: tgp@amis.com
ISO9001
2.28.02

Dual-PLL Clock Generator Features Description Uses inex

Top Searches for this datasheet

Other recent searches