series Two-Pole, Board Panel Mount Relay File E22575 File LR

The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.

series Two-Pole, Board Panel Mount Relay File E22575 File LR

Datasheet Thumbnail

Top Searches for this datasheet

Catalog 1308242 Issued 3-03 (T92 revised 2-04)
series
Two-Pole, Board Panel Mount Relay
File E22575 File LR15734 File E22575 (type 2,3,4,5) File 5386 (type 1,2,3,4)
Users should thoroughly review technical data before selecting product part number. recommended that user also seek pertinent approvals files agencies/laboratories review them ensure product meets requirements given application.
Features
DPST-NO DPDT switching capabilities. Designed control compressor loads tons, 25.3 FLA, LRA. Extended life >300,000 operations 30A, 240VAC coil). >100,000 operations 30A, 240VAC coil). Meets requirements UL873 UL508 spacings. .315" (8mm) through air, .375" (9.5mm) over surface. Meets requirements spacing, dielectric coil-to-contacts. Meets requirements Class construction. approved 600VAC switching (1.5HP). Conforms 0435, 0631, 0700. screw terminal version.
Coil Data 25°C Coil Temperature)
Nom. Voltage (VDC) Coils (1.7W) Resist. Nom. Voltage (VDC) ±10% (Ohms)
±10% (Ohms)
1,390 7,255 Freq. 50/60 50/60 50/60 Resist. 3800 5485
Resist.
Coils (4.0VA) Nom. Voltage Freq. Resist. Nom. Voltage (VAC) (VAC) ±10% (Ohms) 110/120 36.6 220/240 250/277
±10% (Ohms)
Contact Ratings 25°C with relay properly vented. Remove tape over vent hole after soldering cleaning.
Arrangements: Form (DPST-NO) Form (DPDT). Materials: Silver cadmium oxide. Max. Load Rating: Normally Open Contacts: 120/277VAC, resistive; 600VAC, resistive; 120VAC, 240VAC;1.5 480VAC, 600VAC LRA, 25.3 FLA, 240VAC with coil(1); LRA, 240VAC with coil. 240VAC pilot duty; 28VDC; TV10 120VAC. Rating (Flange Mount): 400VAC, 100K Ops. (30K Ops. Form Models). Rating Mount): 400VAC, 100K Ops. (30K Ops. Form Models). Normally Closed Contacts: 28VDC 277VAC, 480VAC, 600VAC. Rating (Flange Mount): 400VAC, Ops. Min. Load Rating: Normally Open Contacts: 500mA 12VAC/VDC. Normally Closed Contacts: 100mA 6VAC/VDC. Expected Mechanical Life: million operations. Expected Electrical Life: 100,000 operations rated load. 780-86 Endurance Test (section 6.6): HVAC Definite Purpose Contactor Standard Normally Open Contacts Single Phase/Two Pole (Both poles together switching single load) LRA, 25.3 FLA, 200K operations Coil).
Ambient Temperature Coil Voltage
Max. Allowable Ambient Temp. (°C)
Cont Cont
Applied Coil Voltage Rated Nominal)
Assumptions:
Thermal resistance 35°C Watt only.) Still air. Nominal coil resistance. Max. mean coil temperature 155°C (change resistance method). Coil temperature rise load 6.3°C amps. Curves based 1.7W 25°C only.)
Operate Data
Must Operate Voltage: Coil: nominal voltage less. Coil: nominal voltage less. Must Release Voltage: nominal voltage more. Initial Operate Time(2): typical, max. w/bounce). Initial Release Time(2): typical, max. w/bounce). Operating Frequency: operations minute.
Environmental Data
Temperature Range: Storage: -55°C +155°C. Operating: Coil: -40°C +65°C. Coil: -40°C +85°C. Vibration: 0.065" (1.65mm) double amplitude 10-55 Hz., functional. Shock, Operational: sine wave pulse with contact opening 100µs. Shock, Mechanical: 100g sine wave pulse. Flammability: 94V-0.
Single Phase Pole (Single load pole) LRA, FLA, 200K operations Coil). LRA, FLA, 200K operations Coil).
Notes: Vent hole tape must removed achieve listed ratings. Consult factory regarding ratings screw terminal versions.
Mechanical Data
Termination: Printed circuit terminals; .250" (6.35mm) quick connects coil contacts; .187" (4.75mm) quick connects coil .250" (6.35mm) quick connects contacts; screws with captive pressure plates coil contacts. Enclosure: Unsealed, plastic dust cover immersion cleanable, tape sealed plastic cover. Weight: (86g) approximately.
Initial Dielectric Strength
Between Contacts Coil: 4,000V rms, 50/60 Between Open Contacts: 1,500V rms, 50/60 Between Poles: 2,000V rms, 50/60
Initial Insulation Resistance
Between Mutually Insulated Elements: ohms, min. 500VDC.
Coil Data
Voltage: through 110VDC through 277VAC. Resistance: Coil Data table. Nom. Power: Coil: 4.0VA; Coil: 1.7W. Coil Temp. Rise: 35°C/W. Max. Coil Temp.: 155°C. Duty Cycle: Continuous.
Dimensions shown reference purposes only. Dimensions inches over (millimeters) unless otherwise specified.
Conditions
parametric, environmental life tests performed according Standard RS-407-A standard test conditions (25°C ambient, 20-50% 29.5 Hg.) unless otherwise noted.
Notes
FLA, ratings compatible with compressor applications. Nominal voltage, coil suppression, excluding bounce.
Specifications availability subject change. www.tycoelectronics.com Technical support: Refer inside back cover.
Catalog 1308242 Issued 3-03 (T92 revised 2-04)
Ordering Information
Typical Part Number
Basic Series: Printed circuit board panel mount power relay. Enclosure: Plastic dust cover (unsealed). Immersion cleanable, tape sealed plastic case (code sealed, immersion cleanable, tape sealed bottom (codes Contact Arrangement: form (DPST-NO). form (DPDT). Coil Input: voltage, 50/60 (See Coil Data Table) voltage. Mounting Termination: Printed circuit board mount; printed circuit board terminals. Panel mount flanged cover; .250" (6.35mm) .032" (.81mm) quick connect terminals. Panel mount flanged cover; .187" (4.75mm) .032" (.81mm) quick connect terminals coil .250" (6.35mm) contacts. Panel mount flanged cover, .187" (4.75mm) .020" (.51mm) quick connect terminals coil .250" (6.35mm) contacts. Panel mount flanged cover, screw terminals captive pressure plates. Requires Enclosure Contact Arrangement Contact Material: Silver cadmium oxide. Coil Voltage: (See Coil Data Table) (DC) 12VDC 24VDC 48VDC 110VDC (60Hz.) 12VAC 24VAC (50/60Hz.) 100/110VAC 110/120VAC 220/240VAC 250/277VAC option. Consult factory detailed ratings, specifications availability.
Stock Items recommend that authorized distributors stock following items immediate delivery.
T92P7A22-24 T92P7A22-120 T92P7A22-240 T92P7D12-12 T92P7D12-24 T92P7D22-12 T92P7D22-24 T92P11A22-24 T92P11A22-120 T92P11A22-240 T92P11D22-12 T92P11D22-24 T92S7D12-12 T92S7D12-24 T92S11D22-12 T92S11D22-24
Outline Dimensions
Mounting Termination Type
2.06 MAX. (52.32) 1.36 MAX. (34.54)
Mounting Termination Types
2.700 MAX. (68.58) 1.36 MAX. (34.54)
1.21 MAX. (30.73)
.156 (3.96) .250 TYP. (6.35) .032 TYP. (0.81) .047 TYP. (1.19)
1.04 MAX. (26.42)
1.495 MAX. (37.97)
.585 .005 (14.86 .13)
1.618 .020 (41.10 .51) .309 .005 (7.85 .13)
2.05 MAX. (52.07) 2.35 .005 (59.71 .13) .585 .005 (14.86 .13)
1.618 TYP. (41.10 .51) .309 .005 (7.85 .13)
.630 .005 (16.00 .13)
1.000 .010 (25.40 .25)
.090 RAD. (2.29) SCREW
.630 TYP. (16.00)
Mounting Termination Type
2.700 MAX. (68.58)
Suggested Board Layout (Bottom View)
1.36 MAX. (34.54) .090 (2.29) RAD. SCREW 1.618 (41.10) .185 (4.70)
Wiring Diagram
.309 (7.85) .365 (9.27)
.585 (14.86)
2.35 .005 (59.71 .13) 2.135 MAX. (54.23) 1.431 MAX. (36.34)
.630 (16.00)
1.000 (25.40)
Only necessary terminals present single throw models.
2.010 MAX. (51.05) .913 MAX. (23.19)
.203 TYP. (5.16) .162 (4.12) Note:
.052 TYP. (1.32)
.072 TYP. (1.83)
alternate board layout utilizes .076 .003 (1.93 .076) diameter holes same center-to-center spacing shown above. rectangular holes recommended improved solderability.
Dimensions shown
reference purposes only.
Dimensions inches over (millimeters) unless otherwise specified.
Specifications availability subject change.
www.tycoelectronics.com Technical support: Refer inside back cover.

series Two-Pole, Board Panel Mount Relay File E22575 File LR

Top Searches for this datasheet

Other recent searches