16-Bit D-Type Flip-Flop with 3-State Outputs PI74VCX Family desig
|
|
|
Top Searches for this datasheet
PI74VCX16374
16-Bit D-Type Flip-Flop with 3-State Outputs
PI74VCX Family designed voltage operation, 1.8V 3.6V 3.6V Tolerant Inputs Outputs Supports Live Insertion Balanced Drive, ±24mA Uses patented Noise Reduction Circuitry Typical VOLP (Output Ground Bounce) 0.6V 2.5V, Typical VOHV (Output Undershoot) -0.6V 2.5V, Power-Off high impedance inputs outputs Industrial operation -40°C +85°C Packaging (Pb-free Green available): 48-pin mil. wide plastic TSSOP
Product Description
PI74VCX16374 particularly suitable implementing buffer registers, ports, bidirectional drivers, working registers. This device used 8-bit Flip-Flops 16-bit flipflop. positive transition clock (CLK) input, outputs flip-flop take logic levels date inputs. buffered Output Enable (OE) input used place eight outputs either normal logic state (high logic levels) high-impedance state which outputs neither load drive lines significantly. high-impedance state increased drive provide capability drive lines without need interface pullup components. does affect internal operations flip-flop. data retained data entered while outputs high impedance state. ensure high-impedance state during power power down, should tied through pullup resistor; minimum value resistor determined currentsinking capability driver. PI74VCX family Tolerant, allowing operate mixed 1.8V/3.6V systems.
Logic Block Diagram
1CLK
Seven Other Channels
2CLK
Seven Other Channels
06-0204
PS8327B
10/27/06
PI74VCX16374 16-Bit D-Type Flip-Flop with 3-State Outputs
Product Description
Name Description Output Enable Input (Active LOW) Clock Input Data Inputs 3-State Outputs Ground Power
Truth Table(1)
Inputs Outputs
Product Configuration
Notes: High Signal Level Signal Level Don't Care Irrelevant High Impedance
1CLK 2CLK
06-0204
PS8327B
10/27/06
PI74VCX16374 16-Bit D-Type Flip-Flop with 3-State Outputs
Maximum Ratings
(Above which useful life impaired. user guidelines, tested.) Supply Voltage Range, -0.5V 4.6V Input Voltage Range, -0.5V 4.6V Output Voltage Range, (3-Stated) -0.5V 4.6V Output Voltage Range, VO(1) (Active) -0.5V 0.5V Input Diode Current (IIK) -50mA Output Diode Current (IOK) -50mA -50mA Output Source/Sink Current (IOH/IOL) ±50mA Current Supply (ICC GND) ±100mA Storage Temperature Range, TSTG -65°C to150°C
Notes: Absolute maximum must observed. Note: Stresses greater than those listed under MAXIMUM RATINGS cause permanent damage device. This stress rating only functional operation device these other conditions above those indicated operational sections this specification implied. Exposure absolute maximum rating conditions extended periods affect reliability.
Recommended Operating Conditions(1)
Parame cription Supply voltage Data Retention Only High- level input voltage Low- level input voltage Input voltage Active State Output voltage State Output current IOH/IOL 3.0V 3.6V 2.3V 2.7V 1.8V 2.7V 3.6V 2.7V 3.6V ns/V Conditions Operating Units
Input transistion rise fall rate(2) Operating free- temperature
Notes: Unused control inputs must held HIGH prevent them from floating. measured between 0.8V 2.0V, 3.0V.
06-0204
PS8327B
10/27/06
PI74VCX16374 16-Bit D-Type Flip-Flop with 3-State Outputs
Electrical Characteristics over Recommended Operating Free-Air Temperature Range
(unless otherwise noted)
Characteristics (2.7V 3.6V)
Parame cription HIGH Level Input Voltage Level Input Voltage -100A HIGH Level Output Voltage -12mA -18mA -24mA 100A Level Output Voltage 12mA 18mA 24mA IOFF Input Leakage Current STATE Output Leakage Power- Leakage Current Quiescent Supply Current 0.0V, 3.6V 3.6V (VI,VO) 3.6V (VI,VO) 3.6V 0.6V, Other inputs Conditions Typ. Units
Increase input
06-0204
PS8327B
10/27/06
PI74VCX16374 16-Bit D-Type Flip-Flop with 3-State Outputs
Characteristics (2.3V 2.7V)
Parame cription HIGH Level Input Voltage Level Input Voltage
Conditions
Typ.
Units
100A
HIGH Level Output Voltage
12mA 18mA 100A
Level Output Voltage
12mA 18mA
IOFF
Input Leakage Current STATE Output Leakage
0.0V, 2.7V 3.6V
Power- Leakage Current (VI,VO) 3.6V Quiescent Supply Current (VI,VO) 3.6V
Characteristics (1.8V 2.3V)
Parame cription HIGH Level Input Voltage Level Input Voltage HIGH Level Output Voltage 100A Level Output Voltage 100A IOFF Input Leakage Current STATE Output Leakage Power- Leakage Current Quiescent Supply Current 0.0V, 1.8V 3.6V (VI,VO) 3.6V (VI,VO) 3.6V Conditions Typ. Units
06-0204
PS8327B
10/27/06
PI74VCX16374 16-Bit D-Type Flip-Flop with 3-State Outputs
Electrical Characteristics(1)
-40°C +85°C, 30pF, 3.3V 0.3V Symbol fMAX tPLH, tPHL tPZH, tPZL tPHZ, tPLZ Parame Maximum Clock Frequency Prop Delay, Output Enable Time Output Disable Time 2.5V 0.2V 1.8V Units
tOSHL, tOSLH Output Output Skew(2)
Notes: 50pF approximatly 300ps maximum specification. Skew defined absolute value difference between actual propagation delay separate outputs same device. specification applies outputs switching same direction, either HIGH (tOSHL) HIGH (tOSLH).
Setup Requirements
30pF, Symbol Parame 3.3V 0.3V 2.5V 0.2V Setup Time Hold Time Pulse Width Typ. Typ. 1.8V Typ. Units
Dynamic Switching Characteristics
Symbol VOLP Parame Quiet Output Dynamic Peak 50pF 50pF Conditions +25°C Typical 0.25 0.25 Units
VOLP
Quiet Output Dynamic Valley
VOLP
50pF Quiet Output Dynamic Valley
Capacitance
Symbol COUT Parame Input Capacitance Output Capacitance Power Dissipation Capacitance Conditions 1.8, 2.5V 3.3V, VDD, 1.8V, 2.5V 3.3V VDD, 1.8V, 2.5V 3.3V +25°C Typical Units
06-0204
PS8327B
10/27/06
PI74VCX16374 16-Bit D-Type Flip-Flop with 3-State Outputs
Test Circuits Switching Waveforms
Parameter Measurement Information (VDD 1.8V 3.6V)
Open 30pF
(See Note
Switch Position
tPLZ/tPZL
Open
From Output Under Test
tPHZ/tPZH
Pulse Width
Low-High-Low Pulse VDD/2
Setup, Hold, Release Timing
Data Input Timing Input VDD/2
High-Low-High Pulse VDD/2
Propagaton Delay
VDD/2
Input tPLH tPHL VDD/2 Output tPHL Opposite Phase Input Transition tPLH VDD/2 VDD/2
Notes: includes probe capacitance. Waveform output with internal conditions such that output except when disabled output control. Waveform output with internal conditions such that output HIGH except when disabled output control. input pulses supplied generators having follow characteristics: MHz, 2ns, 2ns, measured from 90%, unless otherwise specified. outputs measured time with transition measurement.
Enable Disable Timing
Output Control
(Active LOW)
VDD/2 tPZL VDD/2 +0.15V tPZH VDD/2 tPHZ -0.15V tPLZ
Output Waveform 2xVDD
(see Note
Output Waveform
(see Note
06-0204
PS8327B
10/27/06
PI74VCX16374 16-Bit D-Type Flip-Flop with 3-State Outputs
Packaging Mechanical: 48-pin TSSOP
.236 .244
.488 12.4 .496 12.6 .047 1.20 SEATING PLANE
.004 0.09 .008 0.20 0.45 .018 0.75 .030 .319
X.XX X.XX
DENOTES DIMENSIONS MILLIMETERS
.0197 0.50
.007 .010 0.17 0.27
.002 .006 0.05 0.15
Ordering Information
Ordering Code PI74VCX16374A PI74VCX16374AE Package Code Package Type 48-pin TSSOP Pb-free Green, 48-pin TSSOP
Notes: Thermal characteristics found company site www.pericom.com/packaging/ Pb-free Green Adding suffix Tape/Reel
Pericom Semiconductor Corporation 1-800-435-2336 www.pericom.com
06-0204
PS8327B
10/27/06
Other recent searches
SM20M05-18 - SM20M05-18 SM20M05-18 Datasheet
Si8429DB - Si8429DB Si8429DB Datasheet
MC3487 - MC3487 MC3487 Datasheet
LG285D - LG285D LG285D Datasheet
LG285D - LG285D LG285D Datasheet
HFBR-4531 - HFBR-4531 HFBR-4531 Datasheet
HFBR-4532 - HFBR-4532 HFBR-4532 Datasheet
ENN8371 - ENN8371 ENN8371 Datasheet
DTA144VKA - DTA144VKA DTA144VKA Datasheet
CYW2338 - CYW2338 CYW2338 Datasheet
Privacy Policy | Disclaimer
© 2012 Datasheet Archive
