Watts Aluminum Nitride Flanged Attenuators General Specifica

The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.

Watts Aluminum Nitride Flanged Attenuators General Specifica

Datasheet Thumbnail

Top Searches for this datasheet

Model RFP-100NXXAE Aluminum Nitride Attenuators
Watts
Aluminum Nitride Flanged Attenuators
General Specifications
Resistive Element: Substrate: Cover: Mounting Flange: Lead(s): Thick film Aluminum nitride ceramic Alumina ceramic Copper nickel plated QQ-N-290 99.99% pure silver (.005" thk)
Features
Watts Aluminum Nitride (AIN) Ceramic Welded Silver Leads Non-Nichrome Resistive Element VSWR 100% Tested
Electrical Specifications
Attenuation Value: Frequency Range: Power: 30db Watts
Notes: Tolerance ±.010, unless otherwise specified. Operating temperature -55°C +150°C (see chart). Designed meet exceed applicable portions MIL-E-5400. dimensions inches. Lead length 0.15" minimum. Specifications subject change without notice.
Outline Drawing
.798 .399 .050 100NXX
.230 .115
.225
.119 .125
Note: denotes attenuation value.
.350 .560
.130 DIA. THRU PLACES) .060
.100
VER. 12/5/01
Sales Desk USA: Voice: (800) 544-2414 Fax: (315) 432-9121 Sales Desk Europe: Voice: (+44) 232392 Fax: (+44) 251369
Model RFP-100NXXAE
RATED POWER
Aluminum Nitride Flanged Attenuators
Specifications
PART NUMBER RFP-100N1AE RFP-100N2AE RFP-100N3AE RFP-100N4AE RFP-100N5AE RFP-100N6AE RFP-100N9AE RFP-100N10AE RFP-100N20AE RFP-100N30AE ATTENUATION (dB) TOL. (+/-dB) POWER (WATTS) VSWR 1.25:1 1.25:1 1.25:1 1.25:1 1.25:1 1.25:1 1.25:1 1.25:1 1.25:1 1.25:1 FREQ. (GHZ)
Power Derating
Suggested Mounting Procedures
.025 MIN. PLACES)
BOARD LOWER THAN LEAD.
BOARD EVEN WITH LEAD.
BOARD LOWER THAN LEAD.
BOARD HIGHER THAN LEAD.
SUGGESTED STRESS RELIEF METHODS SCALE: NONE
RECOMMENDED APPLICATION SCALE: NONE
CASE TEMPERATURE
Make sure that devices mounted flat surfaces (.001" under device) optimize heat transfer. Drill heatsink appropriate thread size used Coat heatsink with minimum amount high quality silicone grease (.001" max. thickness). Position device mounting surface secure using socket head screws, flat split washers. Torque screws appropriate value. Make sure that device flat against heatsink. (Care should taken avoid upward pressure leads towards lid). Solder leads place using SN63 type solder with controlled temperature iron (210°C)
Sales Desk USA: Voice: (800) 544-2414 Fax: (315) 432-9121 Sales Desk Europe: Voice: (+44) 232392 Fax: (+44) 251369

Watts Aluminum Nitride Flanged Attenuators General Specifica

Top Searches for this datasheet

Other recent searches