REPETITIVE AVALANCHE dv/dt RATED HEXFET TRANSISTOR 60Volt, 0

The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.

REPETITIVE AVALANCHE dv/dt RATED HEXFET TRANSISTOR 60Volt, 0

Datasheet Thumbnail

Top Searches for this datasheet

90883A
REPETITIVE AVALANCHE dv/dt RATED
HEXFET TRANSISTOR
60Volt, 0.025, MEGA HARD HEXFET
International Rectifier's HARD technology HEXFETs demonstrate immunity failure. Additionally, under identical pre- post-radiation test conditions, International Rectifier's HARD HEXFETs retain identical electrical specifications Rads (Si) total dose. compensation gate drive circuitry required. These devices also capable surviving transient ionization pulses high 1012 Rads (Si)/Sec, return normal operation within microseconds. Since HARD process utilizes International Rectifier's patented HEXFET technology, user expect highest quality reliability industry. HARD HEXFET transistors also feature well-established advantages MOSFETs, such voltage control, very fast switching, ease paralleling temperature stability electrical parameters. They well-suited applications such switching power supplies, motor controls, inverters, choppers, audio amplifiers high-energy pulse circuits space weapons environments.
IRH7054 IRH8054
N-CHANNEL
MEGA HARD
Product Summary
Part Number IRH7054 IRH8054 BVDSS RDS(on) 0.025 0.025 45*A 45*A
Features:
Radiation Hardened Rads (Si) Single Event Burnout (SEB) Hardened Single Event Gate Rupture (SEGR) Hardened Gamma (Flash X-Ray) Hardened Neutron Tolerant Identical Pre- Post-Electrical Test Conditions Repetitive Avalanche Rating Dynamic dv/dt Rating Simple Drive Requirements Ease Paralleling Hermetically Sealed
Absolute Maximum Ratings
Parameter
12V, 25°C 12V, 100°C 25°C dv/dt TSTG Continuous Drain Current Continuous Drain Current Pulsed Drain Current Max. Power Dissipation Linear Derating Factor Gate-to-Source Voltage Single Pulse Avalanche Energy Avalanche Current Repetitive Avalanche Energy Peak Diode Recovery dv/dt Operating Junction Storage Temperature Range Lead Temperature Weight
Pre-Irradiation
IRH7054, IRH8054 Units
°C/W V/ns
(0.063 (1.6mm) from case 10s) 11.5 (typical)
www.irf.com
10/9/98
IRH7054, IRH8054 Devices
Pre-Irradiation
Electrical Characteristics 25°C (Unless Otherwise Specified)
Parameter
BVDSS Drain-to-Source Breakdown Voltage BVDSS/TJ Temperature Coefficient Breakdown Voltage RDS(on) Static Drain-to-Source On-State Resistance VGS(th) Gate Threshold Voltage Forward Transconductance IDSS Zero Gate Voltage Drain Current
Units
0.053 0.025 0.028 -100 V/°C
Test Conditions
1.0mA Reference 25°C, 1.0mA 12V, =32A 12V, VGS, 1.0mA 15V, VDS= Rating,VGS=0V Rating 125°C -20V 12V, Rating 30V, 35A, 2.35
IGSS IGSS td(on) td(off)
Gate-to-Source Leakage Forward Gate-to-Source Leakage Reverse Total Gate Charge Gate-to-Source Charge Gate-to-Drain (`Miller') Charge Turn-On Delay Time Rise Time Turn-Off Delay Time Fall Time Internal Drain Inductance Internal Source Inductance
Measured from drain lead, (0.25 from package center die. Measured from source lead, (0.25 from package source bonding pad.
Modified MOSFET symbol showing internal inductances.
Ciss Coss Crss
Input Capacitance Output Capacitance Reverse Transfer Capacitance
4100 2000
1.0MHz
Source-Drain Diode Ratings Characteristics
Parameter
Continuous Source Current (Body Diode) Pulse Source Current (Body Diode) Diode Forward Voltage Reverse Recovery Time Reverse Recovery Charge Forward Turn-On Time
Units
Test Conditions
Modified MOSFET symbol showing integral reverse junction rectifier.
25°C, 35A, 25°C, 35A, di/dt 100A/µs
Intrinsic turn-on time negligible. Turn-on speed substantially controlled
Thermal Resistance
Parameter
RthJC RthCS RthJA Junction-to-Case Junction-to-Sink Junction-to-Ambient
0.83 0.12
Units
°C/W
Test Conditions
Typical socket mount
Current limited diameter.
www.irf.com
Radiation Characteristics
Radiation Performance Hard HEXFETs
International Rectifier Radiation Hardened HEXFETs tested verify their hardness capability. hardness assurance program International Rectifier comprises three radiation environments. Every manufacturing tested dose rate (total dose) environment MIL-STD-750, test method 1019 condition International Rectifier imposed standard gate condition volts note bias condition equal device rated voltage note Pre- post- irradiation limits devices irradiated Rads (Si) identical presented Table column IRH7054. Post-irradiation limits devices irradiated Rads (Si) presented Table
IRH7054, IRH8054 Devices
column IRH8054. values Table will either dose rate test circuits that used. Both pre- post-irradiation performance tested specified using same drive circuitry test conditions order provide direct comparison. High dose rate testing done special request basis using dose rate 1012 Rads (Si)/Sec (See Table International Rectifier radiation hardened HEXFETs have been characterized heavy Single Event Effects (SEE) environments. Single Event Effects characterization shown Table
Table Dose Rate
Parameter
BVDSS VGS(th) IGSS IGSS IDSS RDS(on)1
IRH7054
-100 0.027
IRH8054 Test Conditions
1.0mA VDS, 1.0mA VDS=0.8 Rating, 12V, 25°C, 35A,VGS 1.25 -100 0.027
100K Rads (Si) 1000K Rads (Si) Units
Drain-to-Source Breakdown Voltage Gate Threshold Voltage Gate-to-Source Leakage Forward Gate-to-Source Leakage Reverse Zero Gate Voltage Drain Current Static Drain-to-Source On-State Resistance Diode Forward Voltage
Table High Dose Rate
Parameter
VDSS di/dt
1011 Rads (Si)/sec 1012 Rads (Si)/sec
Drain-to-Source Voltage
Units Test Conditions Applied drain-to-source voltage during gamma-dot Peak radiation induced photo-current A/µsec Rate rise photo-current Circuit inductance required limit di/dt
Table Single Event Effects
(Si) (MeV/mg/cm2)
Fluence (ions/cm2)
Range (µm)
VDSBias
Bias
www.irf.com
IRH7054, IRH8054 Devices
Pre-Irradiation
Pre-
1000
Drain-to-Source Current
Drain-to-Source Current
9.0V 8.0V 7.0V 6.0V BOTTOM 5.0V
1000
9.0V 8.0V 7.0V 6.0V BOTTOM 5.0V
5.0V
20µs PULSE WIDTH
5.0V
20µs PULSE WIDTH
Drain-to-Source Voltage
Drain-to-Source Voltage
Typical Output Characteristics
Typical Output Characteristics
1000
DS(on) Drain-to-Source Resistance (Normalized)
Drain-to-Source Current
20µs PULSE WIDTH
Gate-to-Source Voltage
Junction Temperature(
Typical Transfer Characteristics
Normalized On-Resistance Temperature
www.irf.com
Pre-Irradiation
IRH7054, IRH8054 Devices
8000
Gate-to-Source Voltage
1MHz Ciss SHORTED Crss Coss
Capacitance (pF)
6000
Ciss
4000
Coss
2000
Crss
TEST CIRCUIT FIGURE
Drain-to-Source Voltage
Total Gate Charge (nC)
Typical Capacitance Drain-to-Source Voltage
Typical Gate Charge Gate-to-Source Voltage
1000
1000
Reverse Drain Current
OPERATION THIS AREA LIMITED RDS(on)
Drain Current
100us
10ms
Single Pulse
1000
,Source-to-Drain Voltage
Drain-to-Source Voltage
Typical Source-Drain Diode Forward Voltage
Maximum Safe Operating Area
www.irf.com
IRH7054, IRH8054 Devices
Pre-Irradiation
LIMITED PACKAGE
D.U.T.
Drain Current
-VDD
Pulse Width Duty Factor
10a. Switching Time Test Circuit
Case Temperature
Maximum Drain Current Case Temperature
td(on)
d(off)
10b. Switching Time Waveforms
0.50
Thermal Response thJC
0.20 0.10 0.05 0.02 0.01 SINGLE PULSE (THERMAL RESPONSE) Notes: Duty factor Peak thJC 0.0001 0.001 0.01
0.01
0.001 0.00001
Rectangular Pulse Duration (sec)
Maximum Effective Transient Thermal Impedance, Junction-to-Case
www.irf.com
Pre-Irradiation
IRH7054, IRH8054 Devices
1200
Single Pulse Avalanche Energy (mJ)
BOTTOM
1000
12a. Unclamped Inductive Test Circuit
Starting Junction Temperature
12c. Maximum Avalanche Energy Drain Current
12b. Unclamped Inductive Waveforms
Current Regulator Same Type D.U.T.
.2µF .3µF
D.U.T.
Charge
Current Sampling Resistors
Fig13a. Basic Gate Charge Waveform
13b. Gate Charge Test Circuit
www.irf.com
IRH7054, IRH8054 Devices
Repetitive Rating; Pulse width limited
maximum junction temperature. Refer current HEXFET reliability report. 25V, Starting 25°C, [0.5 (IL2) Peak 35A, 12V, 35A, di/dt 220A/µs, BVDSS, 150°C Suggested 2.35 Pulse width Duty Cycle
Pre-Irradiation
Total Dose Irradiation with Bias.
volt applied during irradiation MIL-STD-750, method 1019, codition Total Dose Irradiation with Bias. rated BVDSS (pre-radiation) applied during irradiation MlL-STD-750, method 1019, condition This test performed using flash x-ray source operated e-beam mode (energy ~2.5 MeV), nsec pulse. Pre-Irradiation Post-Irradiation test conditions identical facilitate direct comparison circuit applications.
Case Outline Dimensions TO-204AE
Conforms JEDEC Outline TO-204AE Dimensions Millimeters Inches
WORLD HEADQUARTERS: Kansas St., Segundo, California 90245, Tel: (310) 3331 GREAT BRITAIN: Hurst Green, Oxted, Surrey 9BB, Tel: 1883 732020 CANADA: Lincoln Court, Brampton, Ontario L6T3Z2, Tel: (905) 2200 GERMANY: Saalburgstrasse 157, 61350 Homburg Tel: 6172 96590 ITALY: Liguria 10071 Borgaro, Torino Tel: 0111 EAST: Bldg., 30-4 Nishi-Ikebukuro 3-Chome, Toshima-Ku, Tokyo Japan Tel: 3983 0086 SOUTHEAST ASIA: Seng Promenade, Great World City West Tower, 13-11, Singapore 237994 Tel: 8371 TAIWAN:16 Suite 207, Sec. South Road, Taipei, 10673, Taiwan Tel: 886-2-2377-9936 http://www.irf.com/ Data specifications subject change without notice. 10/98
www.irf.com

REPETITIVE AVALANCHE dv/dt RATED HEXFET TRANSISTOR 60Volt, 0

Top Searches for this datasheet

Other recent searches