Logic voltage: High-voltage output: VDD-35V max. Multiple display 4-bi

The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.

Logic voltage: High-voltage output: VDD-35V max. Multiple display 4-bi

Datasheet Thumbnail

Top Searches for this datasheet

HT16511 1/16 Duty Controller
Logic voltage: High-voltage output: VDD-35V max. Multiple display 4-bit general purpose input port external resistors necessary driver output
(12-segment 16-digit 20-segment 8-digit)
matrix scanning steps dimmer circuit output ports (20mA max.)
(provides PMOS open-drain pull-low resistor output)
Serial interface with (CLK, 52-pin package
Applications
Consumer products panel function control Industrial measuring instrument panel function control Other similar application panel function control
General Description
HT16511 (Vacuum Fluorescent Display) controller/driver that driven 1/16 duty factor. consists segment output lines, grid output lines, segment/grid output drive lines, output ports, control circuit, display memory, scan circuit. Serial data inputs HT16511 through three-line serial interface. This controller/driver ideal peripheral device MCU.
Block Diagram
ltip
Rev. 1.20
December 2003
HT16511
Assignment
Assignment
Chip Size: 103.5 70.5 (mil)2 substrate should connected layout artwork.
Rev. 1.20
December 2003
HT16511
Coordinates
-1110.000 -1110.000 -1110.000 -1110.000 -1110.000 -1165.900 -1110.000 -1110.000 -1110.000 -1110.000 -1110.000 -1110.000 -1110.000 -897.200 -782.500 -674.500 -566.500 -458.500 -350.500 -242.500 -134.500 -26.500 81.500 189.500 297.500 405.500 555.300 450.300 345.300 240.300 135.300 9.800 -125.500 -230.500 -335.500 -440.500 -545.500 -650.500 -755.500 -560.300 -560.300 -560.300 -560.300 -560.300 -560.300 -560.300 -560.300 -560.300 -560.300 -560.300 -560.300 -560.300 977.250 977.250 977.250 977.250 977.250 977.250 977.250 977.250 977.250 977.250 977.250 977.250 977.250 977.250 405.500 297.500 189.500 81.500 -34.700 -173.950 -285.150 -390.150 -501.350 -606.350 -765.200 -720.000 -612.000 -504.000 -396.000 -288.000 -180.000 -55.150 49.850 173.350 281.350 389.350 497.350 605.350 713.350 545.400 545.400 545.400 545.400 545.400 684.850 684.850 684.850 684.850 684.850 726.350 Unit:
Description
Name SW1~SW4 4-bit general purpose input port Output serial data falling edge shift clock, starting from order bit. This NMOS open-drain output pin. Input serial data rising edge shift clock, starting from order bit. connection Reads serial data rising edge, outputs data falling edge. Initializes serial interface rising falling edge HT16511. Then waits receive command. Data input after fallen processed command. While command data processed, current processing stopped, serial interface initialized. While high, ignored. Keying data input these pins latched display cycle. Positive power supply Segment source output pins (dual function). This PMOS open-drain pull-low resistor output. Segment Grid driver output pins. These pins selectable segment grid driving. This PMOS open-drain pull-low resistor output. power supply Grid driver output pins (Grid only). This PMOS open-drain pull-low resistor output. driver output ports. This CMOS output pin. Negative power supply, ground Connected external resistor oscillator circuit. Description
10~13
K0~K3
15~26 27~32, 35~36 37~44 46~50 S1/K1~S12/K12 S13/G16~S20/G9 G8~G1 LED4~LED0
Rev. 1.20
December 2003
HT16511
Approximate Internal Connections
Absolute Maximum Ratings
Supply Voltage .VSS-0.3V VSS+6.0V Input Voltage.VSS-0.3V VDD+0.3V Operating Temperature.-25°C 75°C Storage Temperature .-50°C 125°C
Note: These stress ratings only. Stresses exceeding range specified under Maximum cause substantial damage device. Functional operation this device other conditions beyond those listed specification implied prolonged exposure extreme conditions affect device reliability.
D.C. Characteristics
Symbol fOSC IOL1 IOH1 IOH21 IOH22 IOL3 VOH1 VOL1 VOL2 Parameter Logic Supply Voltage Supply Voltage Oscillation Frequency Output Pull-low Resistor Operating Current Driver Leakage Current Sink Current Source Current Segment/Key Source Current Segment/Grid Source Current Sink Current Input Voltage Input Voltage High-level Output Voltage Low-level Output Voltage Low-level Output Voltage Test Conditions ROSC=51kW Driver output load, display VO=VDD-30V, driver VOL=1V, LED0~LED4 VOH=0.9VDD, LED0~LED4 VOH=VDD-2V, S1/K1~S12/K12 VOH=VDD-2V VOL=0.4V LED0~LED4, IOH1=-1mA LED0~LED4, IOL1=20mA IOL2=4mA Conditions Min. 0.7VDD 0.9VDD Typ. Max. VDD-35 0.3VDD
Ta=25°C Unit
Rev. 1.20
December 2003
HT16511
A.C. Characteristics
Symbol tPHL tPLH tmax Fall Time Maximum Clock Frequency Input Capacitance Clock Pulse Width Strobe Pulse Width Data Setup Time Data Hold Time Clock-Strobe Time Wait Time Rise Time Parameter Test Conditions Propagation Delay Time Conditions CLK®DO CL=15pF, RL=10kW CL=300pF, S0~S12 CL=300pF, G1~G16 CL=300pF, Duty=50% rising edge rising edge rising edge falling edge Min. Typ. Max. Ta=25°C Unit
Functional Description
Display Display Mode static display organized into bits stores data transmitted from external device HT16511 through serial interface. contents directly mapped contents driver. Data accessed through data setting, address setting display control commands. assigned addresses 8-bit unit follows:
Dimming Control HT16511 provides 8-step dimmer function display controlling 3-bit binary command code. full pulse width grid signal divides into uniform sections (pulse width modulation) technology. uniform sections available form steps dimmer 3-bit binary code. 8-step dimmer includes 1/16, 2/16, 4/16, 10/16, 11/16, 12/16, 13/16 14/16. 1/16 pulse width indicates minimum lightness. 14/16 pulse width represents maximum lightness (Refer display control command). Matrix Key-Input Data Storage matrix scans series states each level strobe signal (S1/K1~S12/K12) output HT16511. strobe signal outputs time-multiplexed signals from S1/K1~S12/K12. states inputs K0~K3 sampled strobe signal S1/K1~S12/K12 latched into register.
Note:
Only lower bits addresses assigned SEG17 through SEG20 valid, higher bits ignored.
Rev. 1.20
December 2003
HT16511
matrix made matrix, shown below.
data each stored illustrated below, read with read command, starting from least significant bit.
Data HT16511 provides extra 4-bit general input port. data provided with available binary code. data read with read command, starting from least significant bit. Bits through data
Commands Port port belongs CMOS output configuration. Data written port with write command, starting from least least significant bit. application (see application circuits), user adopts internal NMOS device driver component connecting VDD. When this port corresponding lights; when turns off. data bits through ignored.
Commands display mode status driver. first byte input HT16511 through after fallen, regarded command. high while commands/data transmitted, serial communication initialized, commands/ data being transmitted valid (however, commands/data previously transmitted remains valid).
Display mode setting commands
These commands initialize HT16511 select number segments number grids (1/8~1/16 duty, segments segments). When these commands executed, display forcibly turned off, scanning also stopped. resume display, display command must executed. same mode selected, nothing happens.
Rev. 1.20
December 2003
HT16511
Note: Power-on status: 16-digit, segment mode selected.
Data setting commands
These commands data write data read modes.
ttin itte ttin
Note: power-on status: normal mode operation address increment mode set.
Address setting commands
These commands address display memory.
address higher set, data ignored until valid address set. Note: power-on status: address 00H.
Display control commands
tity
Note: power-on status: 1-16 pulse width display turned off. scanning will stopped during power
Rev. 1.20
December 2003
HT16511
Timing Diagrams
Scanning Display Timing
Note: cycle scan consists frames, data matrixes stored RAM.
Rev. 1.20
December 2003
HT16511
Serial Communication Format
Reception (command/data write)
Transmission (data read)
must sure connect external pull-high resistor this (1kW 10kW). Note: When data read, wait time necessary.
Updating display memory incrementing address
Note: Command sets display mode Command sets data Command sets address Data transfers display data bytes max.) Command controls display
Updating specific addresses
Note: Command sets data Command sets address Data: display data
Rev. 1.20
December 2003
HT16511
Application Circuits
Note:
ROSC=51kW oscillator resistor R1=1~10kW external pull-high resistor R2~R6=750W~1.2kW R7~R10=10kW external pull-low resistor D1~D12=1N4001 Ef=Filament voltage
Rev. 1.20
December 2003
HT16511
Package Information
52-pin Outline Dimensions
Symbol
Dimensions Min. 18.80 13.90 18.80 13.90 2.50 0.73 0.10 Nom. 1.00 0.40 0.10 Max. 19.20 14.10 19.20 14.10 3.10 3.40 1.03 0.20
Rev. 1.20
December 2003
HT16511
Holtek Semiconductor Inc. (Headquarters) No.3, Creation Science Park, Hsinchu, Taiwan Tel: 886-3-563-1999 Fax: 886-3-563-1189 http://www.holtek.com.tw Holtek Semiconductor Inc. (Sales Office) 4F-2, 3-2, YuanQu St., Nankang Software Park, Taipei 115, Taiwan Tel: 886-2-2655-7070 Fax: 886-2-2655-7373 Fax: 886-2-2655-7383 (International sales hotline) Holtek Semiconductor (Shanghai) Inc. Floor, Building No.889, Shan Rd., Shanghai, China Tel: 021-6485-5560 Fax: 021-6485-0313 http://www.holtek.com.cn Holtek Semiconductor (Hong Kong) Ltd. Block 3/F, Industrial Building, 777-779 Cheung Rd., Kowloon, Hong Kong Tel: 852-2-745-8288 Fax: 852-2-742-8657 Holmate Semiconductor, Inc. 46712 Fremont Blvd., Fremont, 94538 Tel: 510-252-9880 Fax: 510-252-9885 http://www.holmate.com Copyright 2003 HOLTEK SEMICONDUCTOR INC. information appearing this Data Sheet believed accurate time publication. However, Holtek assumes responsibility arising from specifications described. applications mentioned herein used solely purpose illustration Holtek makes warranty representation that such applications will suitable without further modification, recommends products application that present risk human life malfunction otherwise. products authorized critical components life support devices systems. Holtek reserves right alter products without prior notification. most up-to-date information, please visit site http://www.holtek.com.tw.
Rev. 1.20
December 2003

Logic voltage: High-voltage output: VDD-35V max. Multiple display 4-bi

Top Searches for this datasheet

Other recent searches