8-CHANNEL SATURATED SINK DRIVERS 2596 2597 8-CHANNEL SATURAT

The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.

8-CHANNEL SATURATED SINK DRIVERS 2596 2597 8-CHANNEL SATURAT

Datasheet Thumbnail

Top Searches for this datasheet

2596 2597
8-CHANNEL SATURATED SINK DRIVERS
2596 2597
8-CHANNEL SATURATED SINK DRIVERS
output-saturation voltages high load currents provided UDN2596A UDN2597A sink driver ICs. These devices used interface buffers between standard low-power digital logic (particularly MOS) high-power loads such relays, solenoids, stepping motors, incandescent displays. eight saturated sink drivers each device feature high-voltage, high-current open-collector outputs. Transient suppression clamp diodes minimum output sustaining voltage allow their with many inductive loads. saturated (non-Darlington) outputs provide collectoremitter voltage drops well improved turn-off times active pull-down function within output predrive section. UDN2596A with output loads while UDN2597A with loads Adjacent outputs paralleled higher load currents. Inputs require very input current activated logic level consistent with much greater sinking capability associated with NMOS, CMOS, logic. UDN2596A UDN2597A rated with logic levels.
Data Sheet 29320.2A
Dwg. W-100
Both devices furnished 20-pin packages with copper leadframes improved thermal characteristics. UDN2596A also available operation between -40°C +85°C. order,
FEATURES
ABSOLUTE MAXIMUM RATINGS 25°C
OutputVoltage,VCE Output Current, IOUT (UDN2596A) (UDN2597A) Supply Voltage, Input Voltage, Package Power Dissipation, 2.27 Operating Temperature Range, -20°C +85°C Storage Temperature Range, 65°C +150°C
*Derate rate 18.2 mW/°C above +25°C
Non-Inverting Function Output Voltages Sink Capability Min. Output Breakdown Output Transient-Suppression Diodes
Output Pull-Down Fast Turn-Off TTL, CMOS Compatible Inputs Automotive Capable
EIGHT DRIVERS
Dwg. W-101
2596 2597
8-CHANNEL SATURATED SINK DRIVERS
ELECTRICAL CHARACTERISTICS 25°C,
Characteristics Output Leakage Current Output Sustaining Voltage Symbol ICEX VCE(sus) Applicable Devices Both UDN2596A UDN2597A Output Saturation Voltage VCE(SAT) UDN2596A UDN2597A Clamp Diode Leakage Current Clamp Diode Forward Voltage Both UDN2596A UDN2597A Logic lnput Current IlN(0) IlN(1) Supply Current (per driver) ICC(ON) Both Both UDN2596A UDN2597A ICC(OFF) Turn-On Delay Turn-Off Delay tpd0 tpd1 Both Both Both Limits Test Conditions VOUT lOUT lOUT lOUT lOUT EOUT EOUT Min. Max. Units
TYPICAL APPLICATION
DUAL STEPPER MOTOR DRIVE
RECOMMENDED OPERATING CONDITIONS
Type Number UDN2596A UDN2597A Logic IOUT
Note: Pins must both connected power ground.
Dwg. W-102A
Northeast Cutoff, 15036 Worcester, Massachusetts 01615-0036 (508) 853-5000 Copyright 1984, 1996, Allegro MicroSystems, Inc.
2596 2597
8-CHANNEL SATURATED SINK DRIVERS
UDN2580A UDN2585A
Dimensions Inches
0.014 0.008
0.430 0.280 0.240
0.300
0.070 0.045
0.100 1.060 0.980
0.005
0.210
0.015
0.150 0.115 0.022 0.014
Dwg. MA-001-20
Dimensions Millimeters (Based 25.4
0.355 0.204
10.92 7.11 6.10
7.62
1.77 1.15
2.54 26.92 24.89
0.13
5.33
0.39
3.81 2.93 0.558 0.356
Dwg. MA-001-20
NOTES: Exact body lead configuration vendor's option within limits shown. Lead spacing tolerance non-cumulative. Lead thickness measured seating plane below.
2596 2597
8-CHANNEL SATURATED SINK DRIVERS
POWER SINK DRIVERS SELECTION GUIDE
ORDER OUTPUT CURRENT, OUTPUT VOLTAGE, NUMBER DRIVERS
Output Ratings
Serial Latched
Features
Diode Saturated Internal Protection Input Drivers Clamp Outputs Hall Sensor/Driver Hall Sensor/Driver Dual 14-Line Decoder/Driver Hall Sensor/Driver Hall Sensor/Driver Stepper Motor Controller/Driver Microstepping Controller/Driver Stepper Motor Translator/Driver Stepper Motor Controller/Driver
Part Number
2595 5833 5832 7003 5140 2596 5275 5800 5801 5821 5841 5842 6817 2547 2549 2543 2559 2597 3625 3626 7024 7029 7042 5804 2064 2068 2065 2069 5829 2544 2540 7026 2878 2879
1000 1200 1250 1500 1600 1800 3000 4000
Current maximum specified test condition, voltage maximum rating. specification sustaining voltage limits over-current protection voltage limits. Complete part number includes additional characters indicate operating temperature range package style.
Allegro MicroSystems, Inc. reserves right make, from time time, such departures from detail specifications required permit improvements design products. Components made under military approvals will accordance with approval requirements. information included herein believed accurate reliable. However, Allegro MicroSystems, Inc. assumes responsibility use; infringements patents other rights third parties which result from use.
Northeast Cutoff, 15036 Worcester, Massachusetts 01615-0036 (508) 853-5000

8-CHANNEL SATURATED SINK DRIVERS 2596 2597 8-CHANNEL SATURAT

Top Searches for this datasheet

Other recent searches