LINE UNIDIRECTIONAL TVSarray DESCRIPTION This line unidirectional

The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.

LINE UNIDIRECTIONAL TVSarray DESCRIPTION This line unidirectional

Datasheet Thumbnail

Top Searches for this datasheet

SMS05 thru SMS24
LINE UNIDIRECTIONAL TVSarray
DESCRIPTION This line unidirectional array designed applications where protection required board level from voltage transients caused electrostatic discharge (ESD) defined 61000-4-2, electrical fast transients (EFT) 61000-4-4 effects secondary lighting. These arrays used protect discrete lines utilizing pins (1,3,4,6) with common anode (pins 2,5) configuration. SMS05 thru SMS24 product provides board level protection from static electricity other induced voltage surges that damage sensitive circuitry. These Transient Voltage Suppressor (TVS) diode arrays protect volt components such DRAM's SRAM's CMOS, HCMOS, HSIC, voltage interfaces volts. Because physical size, weight protection capabilities, this product ideal limited miniaturized electronic equipment such hand held instruments, computers, computer peripherals cell phones.
IMPORTANT: most current data, consult MICROSEMI's website: http://www.microsemi.com
arrayS
Microsemi
APPLICATIONS EIA-RS232 data rates 19.6kbs EIA-RS422 data rates 10Mbs EIA-RS423 data rates 100kbs
FEATURES
Protects through volt components Protects unidirectional lines Provides electrically isolated protection 23-6L Packaging
PACKAGING
Tape Reel Standard 3,000 pieces inch reel
MAXIMUM RATINGS
Operating Temperature: -55°C +150°C Storage Temperature: -55°C +150°C Peak Pulse power watts (8/20 Figure 23-6L Packaging
MECHANICAL
Molded SOT23-6L Surface Mount Weight .014 grams (approximate) Body Marked with device number Part symmetrical therefore defined either four corner pins (for clarification schematic page
ELECTRICAL CHARACTERISTICS LINE 25°C Unless otherwise specified
STAND VOLTAGE VOLTS SMS05 SMS12 SMS15 SMS24 12.0 15.0 24.0 BREAKDOWN VOLTAGE VOLTS 13.3 16.7 26.7 CLAMPING VOLTAGE (FIGURE VOLTS CLAMPING VOLTAGE (FIGURE VOLTS 14.5 STANDBY CURRENT CAPACITANCE MHz) TEMPERATURE COEFFICIENT mV/°C
PART NUMBER
DEVICE MARKING
SMS03 thru SMS24
CLAMPING VOLTAGE Amps Note: Transient Voltage Suppressor (TVS) product normally selected based stand voltage VWM. Product selected voltage should equal greater than continuous peak operating voltage circuit protected.
Copyright 2004 MSC1686.PDF 10-21-2004
Microsemi
Scottsdale Division 8700 Thomas 1390, Scottsdale, 85252 USA, (480) 941-6300, Fax: (480) 947-1503
Page
SMS05 thru SMS24
LINE UNIDIRECTIONAL TVSarray
SYMBOLS DEFINITIONS Symbol DEFINITION Rated stand voltage: Maximum voltage that applied over operating temperature range. must selected equal greater than operating voltage line protected Minimum Breakdown Voltage: minimum voltage device will exhibit specified current Clamping Voltage: Maximum clamping voltage across device when subjected given peak pulse current pulse time Standby Current: Leakage current VWM. Capacitance: Capacitance defined volts frequency stated Pico Farads. GRAPHS
Microsemi
Peak Pulse Power (Kw)
8/20µs 200W Pulse
0.001 1000
FIGURE Peak Pulse Power Pulse Time t=µsec
PACKAGING SCHEMATIC
FIGURE Pulse Wave Form
GRAPHS PACKAGE DATA
DIMENSIONS MILLIMETERS 2.70 0.00 1.00 0.35 0.10 1.50 1.70 2.60 0.20 1.10 0.40 0.15 1.60 1.90 2.80 2.90 3.10 0.10 1.30 0.50 0.25 1.80 2.10 3.00
DIMENSIONS INCHES .106 .000 .039 .014 .004 .059 .067 .102 .008 .043 .016 .006 .063 .075 .110 .114 .127 .004 .051 .020 .010 .071 .083 .118
Copyright 2004 MSC1686.PDF 10-21-2004
Microsemi
Scottsdale Division 8700 Thomas 1390, Scottsdale, 85252 USA, (480) 941-6300, Fax: (480) 947-1503
Page

LINE UNIDIRECTIONAL TVSarray DESCRIPTION This line unidirectional

Top Searches for this datasheet

Other recent searches