TLP2200 Isolated Buss Driver High Speed Line Receiver Micropocess
|
|
|
Top Searches for this datasheet
TLP2200
TLP2200
Isolated Buss Driver High Speed Line Receiver Micropocessor System Interfaces Gate Driver Direct Replacement HCPL-2200
TOSHIBA TLP2200 consists GaAAs light emitting diode integrated high gain, high speed photodetector. This unit 8-lead package. detector three state output stage that eliminates need pull-up resistor, built-in schmitt trigger. detector internal shield that provides guaranteed common mode transient immunity 1000V Input current: 1.6mA Power supply voltage: 4.5~20V Switching speed: 2.5MBd guaranteed Common mode transient immunity: ±1000V (min.) Guaranteed performance over temp: 0~85°C Isolation voltage: 2500Vrms(min.) recognized: UL1577, file E67349 TOSHIBA Weight: 0.54 11-10C4 Unit
Configuration (top view)
SHIELD N.C. Anode Cathode N.C. (enable) (output)
Truth Table (positive logic)
Input Enable Output
Schematic
SHIELD
2002-09-25
TLP2200
Recommended Operating Conditions
Characteristic Input current, Input current, Supply voltage Enable voltage high Enable voltage (TTL load) Operating temperature Symbol IF(ON) IF(OFF) Topr Min. Typ. Max. Unit
Absolute Maximum Ratings derating required 70°C)
Characteristic Forward current Peak transient forward current Reverse voltage Output current Supply voltage Output voltage Three state enable voltage Total package power dissipation (Note (Note Symbol IFPT Topr Tstg Tsol Rating -0.5~20 -0.5~20 -0.5~20 -40~85 -55~125 2500 Unit Vrms
Operating temperature range Storage temperature range Lead solder temperature (10s) (**) Isolation voltage 1min., R.H. 60%,Ta 25°C) (Note
(Note Pulse width 300pps. (Note Derate 4.5mW above 70°C ambient temperature. (Note Device considered terminal device: Pins shorted together, pins 5,6,7 shorted together (**) 1.6mm below seating plane.
2002-09-25
TLP2200
Electrical Characteristics (unless otherwise specified, 0~85°C,VCC 4.5~20V,
IF(ON) 1.6~5mA, IF(OFF) 0~0.1mA, 0~0.8V,VEH 2.0~20V)
Characteristic Output leakage current VCC) Logic output voltage Logic high output voltage Logic enable current Logic high enable current Symbol IOHH ICCL ICCH IOZL High impedance state output current IOZH IOSL IOSH IHYS RI-O CI-O don't care don't care 5mA, 25°C 10mA, 25°C 1MHz, 25°C VI-O 500V R.H. VI-O 1MHz Test Condition 5mA, 4.5V 5.5V Min. 5.5V 5.5V 0.4V 2.4V 5.5V 5.5V 5.5V
Typ.* 0.32 -0.13 0.01 0.01 0.05 1.55 -2.0
Max. -0.32
Unit
6.4mA load) -2.6mA 0.4V 2.7V 5.5V
Logic enable voltage Logic high enable voltage Logic supply current Logic high supply current
Logic short circuit output current Logic high short circuit output current Input current hysteresis Input forward voltage
(Note (Note
Temperature coefficient forward voltage Input reverse breakdown voltage Input capacitance Resistance (input-output) Capacitance (input-output)
(Note (Note
(**) typ. values 25°C, IF(ON) unless otherwise specified.
2002-09-25
TLP2200
Switching Characteristics
(unless otherwise specified, 0~85°C,VCC 4.5~20V,IF(ON) 1.6~5mA,IF(OFF) 0~0.1mA)
Characteristic Propagation delay time logic high output level (Note Propagation delay time logic output level (Note Output rise time (10-90%) Output fall time (90-10%) Output enable time logic high Output enable time logic Output disable time from logic high Output disable time from logic Common mode transient immunity logic high output (Note Common mode transient immunity logic output (Note tpZH tpZL tpHZ tpLZ 0mA, 50V, 25°C 1000 1.6mA, 50V, 25°C -1000 tpHL Symbol Test Circuit Test Condition Without peaking capacitor With peaking capacitor Without peaking capacitor With peaking capacitor Min. Typ. Max. Unit
tpLH
typ. values 25°C, IF(ON) unless otherwise specified. (Note Duration output short circuit time should exceed 10ms. (Note tpLH propagation delay measured from point leading edge input pulse 1.3V point leading edge output pulse. tpHL propagation delay measured from point trailing edge input pulse 1.3V point trailing edge output pulse. (Note maximum rate rise common mode voltage that sustained with output voltage logic state 0.8V). maximum rate fall common mode voltage that sustained with output voltage logic high state 2.0V).
2002-09-25
TLP2200
Test Circuit tpHL, tpLH,
Pulse Generator IF(ON) Input tpLH Output tpHL 1.3V Input Monitoring Node C1=120pF Output Monitoring Node Input Monitoring Node D1~D4 1S1588
IF(ON)
2.15k 1.6mA
1.1k
peaking capacitor. probe capacitances include approximately 15pF which includes probe stray wiring capacitance.
Test Circuit tpHZ, tpZH, tpLZ tpZL
Pulse Generator 3.0V 1.3V Closed tPZH 1.3V tPHZ 0.5V ~1.5V Closed approximately 15pF which includes probe stray wiring capacitance.
Input Output IF=IF (OFF) Closed Open Output IF=IF (ON)
D1~D4 1S1588
tPZL 1.3V
tPLZ 0.5V
Open Closed
2002-09-25
TLP2200
Test Circuit Common Mode Transient Immunity
Output Switch note6 Switch 1.6mA VO(MAX.) VO(MIN.) Pulse gen. Output Monitoring Node 0.1µF Bypass
2002-09-25
TLP2200
RESTRICTIONS PRODUCT
000707EBC
TOSHIBA continually working improve quality reliability products. Nevertheless, semiconductor devices general malfunction fail their inherent electrical sensitivity vulnerability physical stress. responsibility buyer, when utilizing TOSHIBA products, comply with standards safety making safe design entire system, avoid situations which malfunction failure such TOSHIBA products could cause loss human life, bodily injury damage property. developing your designs, please ensure that TOSHIBA products used within specified operating ranges forth most recent TOSHIBA products specifications. Also, please keep mind precautions conditions forth "Handling Guide Semiconductor Devices," "TOSHIBA Semiconductor Reliability Handbook" etc. TOSHIBA products listed this document intended usage general electronics applications (computer, personal equipment, office equipment, measuring equipment, industrial robotics, domestic appliances, etc.). These TOSHIBA products neither intended warranted usage equipment that requires extraordinarily high quality and/or reliability malfunction failure which cause loss human life bodily injury ("Unintended Usage"). Unintended Usage include atomic energy control instruments, airplane spaceship instruments, transportation instruments, traffic signal instruments, combustion control instruments, medical instruments, types safety devices, etc. Unintended Usage TOSHIBA products listed this document shall made customer's risk. Gallium arsenide (GaAs) substance used products described this document. GaAs dust fumes toxic. break, pulverize product, chemicals dissolve them. When disposing products, follow appropriate regulations. dispose products with other industrial waste with domestic garbage. products described this document subject foreign exchange foreign trade laws. information contained herein presented only guide applications products. responsibility assumed TOSHIBA CORPORATION infringements intellectual property other rights third parties which result from use. license granted implication otherwise under intellectual property other rights TOSHIBA CORPORATION others. information contained herein subject change without notice.
2002-09-25
Other recent searches
TEMT6000 - TEMT6000 TEMT6000 Datasheet
MW500-1233 - MW500-1233 MW500-1233 Datasheet
MSM58321 - MSM58321 MSM58321 Datasheet
ICX252AK - ICX252AK ICX252AK Datasheet
FDMS8670 - FDMS8670 FDMS8670 Datasheet
BRT11 - BRT11 BRT11 Datasheet
BG320240B - BG320240B BG320240B Datasheet
Privacy Policy | Disclaimer
© 2012 Datasheet Archive
