WATT WIDE INPUT DC-DC CONVERTERS Isolated Output Input Range Six-

The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.

WATT WIDE INPUT DC-DC CONVERTERS Isolated Output Input Range Six-

Datasheet Thumbnail

Top Searches for this datasheet

WATT WIDE INPUT DC-DC CONVERTERS
Isolated Output Input Range Six-Sided Shield Remote ON/OFF Control Efficiency 200KHz Switching Frequency
MODEL NUMBER 2EE-01 2EE-02 2EE-03 2EE-04 2EE-05 2EE-06 2EE-07 2EE-08 2EE-11 2EE-12 2EE-13 2EE-14 2EE-15 2EE-16 2EE-17 2EE-18 2EE-21 2EE-22 2EE-23 2EE-24 2EE-25 2EE-26 2EE-27 2EE-28
INPUT VOLTAGE
OUTPUT VOLTAGE
OUTPUT CURRENT 3000 1250 1000 ±625 ±500 1500/±310 1500/±250 1500/310/500 3000 1250 1000 ±625 ±500 1500/±310 1500/±250 1500/310/500 3000 1250 1000 ±625 ±500 1500/±310 1500/±250 1500/310/500
INPUT CURRENT LOAD FULL LOAD 1700 1600 1600 1520 1520 1600 1600 1470
EFF.
CASE
9-18
5/±12 5/±15 +5/+12/-5
18-36
5/±12 5/±15 +5/+12/-5
36-72
5/±12 5/±15 +5/+12/-5
NOTE: Nominal Input Voltage
Specifications
INPUT SPECIFICATIONS:
Input Voltage Range.12V.9-18V 24V.18-36V 48V.36-72V Input Filter.Pi Type
OUTPUT SPECIFICATIONS:
Voltage Accuracy Single Output.±1.0% max. Dual +Output.±1.0% max. -Output.±3.0% max. Triple, 5V.±2.0% max. 12V/15V.±3.0% max. Voltage Balance (Dual).±1.0% max. Transient Response: Single, Step Load Change.<500µ sec. Dual, FL-1/2L±1% Error Band.<500µ sec. External Trim Adj. Range.±10%. Ripple Noise, 20MHz BW.10mV RMS, max. 75mV max. Temperature Coefficient.± 0.02%/°C Short Circuit Protection.Continuous Line Regulation1, Single/Dual.±0.2% max. Triple.±1.0% max. Load Regulation2, Single/Dual.±1.0% max. Triple.±5.0% max.
GENERAL SPECIFICATIONS:
Efficiency.See Table Isolation Voltage.500 Isolation Resistance.109ohms Switching Frequency.200KHz, Operating Temperature Range.-25°C 71°C Case Temperature.100°C max. Cooling.Free-Air Convection Storage Temperature Range.-55°C 105°C EMI/RFI.Six-Sided Continuous Shield Dimensions.2.56 0.83 inches 76.2 21.1 Case Material.Black Coated Copper with Non-Conductive Base
TRIPLE OUTPUT LOADING TABLE
Output
No.)
Voltage Min.(2) 0.25 0.10 0.10 0.10/0.10
Amperes Nom. 0.31 0.25 0.31/0.50
NOTE:
NOTE:
Maximum total power from outputs limited watts output should allowed exceed maximum current. Minimum current each output required maintain specified regulation.
Measured From High Line Line Measured From Full Load Load
CASE
Dimensions Inches(mm)
CONNECTION
0.80 (20.3)
0.20 (5.1)
0.70 (17.8) 0.40 (10.2)
Single Output
Daul Output
Triple Output +Input -Input +Output Common -Output Output
0.30 (7.6)
0.04 (1.0)
+Input +Input -Input -Input +Output Common Output Trim -Output +Output -Output Remote On/Off Control
Remote On/Off Control
BOTTOM VIEW
2.50 3.00 (63.5) (76.2)
Logic Compatibility EC-On EC-Off Shutdown Idle Current Input Resistance Control Common
CMOS Open Collector >+5.5VDC Open Circuit <1.8 100K ohms (Ein VDC) Referenced Input Minus
External Output Trimming
Output optionally externally trimmed (±10%) with fixed resistor external trimpot shown.
TRIM TRIM DOWN
0.40 (10.2) 1.50 (38.1) 2.56 (65.0) 0.60 (15.2)
0.22 (5.6) min.
0.83 (21.1)
ohms TRIMPOT
Specifications Typical Nominal Line, Full Load 25°C Unless Otherwise Noted.
4532 Telephone Road Suite Ventura, 93003 (805 642-0660 (800)456-2006 (805) 642-0790
e-mail: sales@behlman.com Web-site: www.behlman.com
Cabot Court Hauppauge, 11788 (631)435-0410 (800)874-6727 Fax(631)951-4341

WATT WIDE INPUT DC-DC CONVERTERS Isolated Output Input Range Six-

Top Searches for this datasheet

Other recent searches