Package TO-220AB Thermotab (Isolated Mounting Tab) Package TO-220

The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.

Package TO-220AB Thermotab (Isolated Mounting Tab) Package TO-220

Datasheet Thumbnail

Top Searches for this datasheet

Package TO-220AB Thermotab (Isolated Mounting Tab)
Package TO-220AB (Non-Isolated)
Product Description
sensitive gate triac bidirectional switch gate controlled either polarity main terminal voltage. primary purpose switching phase control applications such motor speed controls, temperature modulation controls, lighting controls.
Sensitive Gate Triac-10 Amps
Features
current TO-220AB isolated non-isolated package Glass-passivated junctions Voltages Volts Sensitive gate quadrants Operating temperature (TJ) from -40°C +110°C Storage temperature (TS) from -40°C +125°C
9001
TECC
Electrical Specifications
IT(RMS) Part Number
VDRM
Repetitive Peak Blocking Voltage (10)
Gate Trigger Current (12) (13)
IDRM
Peak Off-State Current Gate Open VDRM Rated Value (10) (11)
VPeak On-State Voltage Rated Current 25°C Volts
Gate Trigger Voltage 6VDC
Holding Current
On-State Current Conduction Angle 360°
Volts
mAmps QIII
mAmps 25°C 110°C
Volts 25°C 110°C
mAmps
Isolated Q2010L4 Q4010L4
NonIsolated Q2010R4 Q4010R4 Q5010R4 Q6010R4 Q8010R4
Q5010L4 Q6010L4 Q8010L4
Notes Electrical Specifications
Figure current ratings specified operating temperatures. Figure Figure typical instantaneous on-state current (iT) on-state voltage (vT). Figure Figure more than cycle Figure
Test conditions, 100mA, pulse width 25µSec., rise time 0.1µSec. Figure IGT. Initial on-state current 100mA di/dt test conditions, 100mA with 0.1µSec. rise time. either polarity with reference test conditions off-state Pulse width <10µs minimum gate current required switch thyristor from off-state on-state
Package Dimensions
INCHES 0.380 0.105 0.230 0.590 0.142 0.110 0.540 0.025 0.195 0.095 0.060 0.070 0.018 0.178 0.045 0.420 0.115 0.250 0.620 0.147 0.130 0.575 0.035 0.205 0.105 0.075 0.085 0.024 0.188 0.060 MILLIMETERS 9.65 10.67 2.66 2.92 5.85 6.35 14.98 15.75 3.61 3.73 2.80 3.30 13.71 14.60 0.63 0.89 4.95 5.21 2.41 2.67 1.52 1.91 1.78 2.16 0.45 0.61 4.52 4.78 1.14 1.53
Package MOUNTING COMMON MT2/ANODE Package MOUNTING ISOLATED
DIA.
CASE TEMPERATURE MEASUREMENT POINT
GATE NOTE: Maximum torque applied mounting in-lbs. (0.904
IGPeak Gate Current (12)
Peak Gate Power Dissipation (12)
PG(AV)
Average Gate Power Dissipation
ITSM
Peak Cycle Surge Forward Current
dv/dt
Critical Rateof-Rise Commutation Voltage Rated VDRM IT(RMS) Commutating di/dt=0.54 (10) Volts/µSec
dv/dt
di/dt
Surge (non-repetitive) On-State Current period 8.3ms fusing
Critical Maximum Gate Rate-of-Rise Rate-ofControlled Forward Change Turn-on time Off-State State Current Voltage 100°C
Amps
Watts
Watts
Amps
Volts/µSec
Amps/µSec
µSec
Amps2/Sec
60Hz
50Hz
General Notes
case temperature (TC) measured shown dimensional outline drawing. "Package Dimensions" opposite page. measurements made 60Hz with resistive load ambient temperature +25°C unless otherwise specified. Operating temperature (TJ) from -40°C 110°C Storage Temperature (TS) from -40°C 125°C Isolated package U.L. Recognized File #E71639
Definition Quadrants
(All polarities referenced MT1)
POLARITIES REFERENCED POSITIVE (Positive Half Cycle)
GATE
GATE
GATE
GATE
Thermal Resistance (Steady State) Junction Mounting
RJC°C/W (TYP) Package Isolated Package Non-Isolated
NEGATIVE (Negative Half Cycle)
Figure Maximum allowable Case Temperature On-State Current
Maximum Allowable Case Temperature (TC)
TO-220 (ISOLATED) PACKAGE CURRENT WAVEFORM: Sinusoidal LOAD: Resistive Inductive CONDUCTION ANGLE: CASE TEMPERATURE: Measured shown Dimensional Drawing TO-220 (NON-ISOLATED) PACKAGE
Figure Power dissipation (Typ.) On-State Current
Average On-State Power Dissipation [PD(AV)] Watts
TO-220
CURRENT WAVEFORM: Sinusoidal LOAD: Resistive Inductive CONDUCTION ANGLE: 360°
On-State Current [lT(RMS)] AMPS
On-State Current [lT(RMS)] AMPS
Figure Normalized Gate-Trigger Current Case Temperature
Figure Instantaneous On-State Current On-State Voltage (Typical)
Positive Negative Instantaneous On-State Current (iT)-Amps
+110 +125
25°C
IGT(TC 25°C)
Devices
Ratio
Lead Temperature (TC)
Positive Negative Instantaneous On-State Voltage )-Volts
Figure Normalized Gate-Trigger Voltage Case Temperature
Figure Normalized Holding Current Case Temperature
VGTfc 25°C)
25°C)
INITIAL ON-STATE CURRENT
+110 +125
Ratio
Ratio
Lead Temperature (TC)
+110 +125
Lead Temperature (TC)
Figure Peak Surge On-State Current Surge Current Duration
SUPPLY FREQUENCY: Sinusoidal LOAD: Resistive ON-STATE CURRENT:
T(RMS)
Rated Value Specified Case Temperature
On-State Current Amps
Peak Surge (Non-Repetitive)
DEVICES
NOTES GATE CONTROL LOST DURING IMMEDIATELY FOLLOWING SURGE CURRENT INTERVAL. OVERLOAD REPEATED UNTIL JUNCTION TEMPERATURE RETURNED STEADY-STATE RATED VALUE. 1000
Surge Current Duration full cycles
Figure Typical Turn-on Time Gate Trigger Current
DEVICES WITH lGT=25mA 25°C
Turn-On Time (tgt)
Gate Trigger Current (lGT)
TECCOR ELECTRONICS 1800 Hurd Drive Irving, Texas 75038-4385 United States America Phone: 972-580-7777 Fax: 972-550-1309 http://www.teccor.com thyristor.techsales@teccor.com
Teccor Electronics reserves right make changes time order improve designs supply best products possible. information this datasheet been carefully checked believed accurate reliable. However, liability type shall incurred Teccor circuits devices described herein. Furthermore, license patent rights implied given purchaser.
Please contact factory further information. Ref: SGTriac010801
Invensys company

Package TO-220AB Thermotab (Isolated Mounting Tab) Package TO-220

Top Searches for this datasheet

Other recent searches