PROTECTED QUAD POWER DRIVER Providing improved output current lim

The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.

PROTECTED QUAD POWER DRIVER Providing improved output current lim

Datasheet Thumbnail

Top Searches for this datasheet

UDx2559B
PROTECTED QUAD POWER DRIVER
Providing improved output current limiting, UDK, UDN, UDQ2559B, quad power drivers combine logic gates high-current bipolar outputs with complete output protection. Each four outputs will sink state. outputs have minimum breakdown voltage (load dump) sustaining voltage inputs compatible with CMOS logic systems. Over-current protection each channel been designed into these devices activated approximately protects each output from short circuits with supply voltages When output current trip point reached, that output stage driven linearly resulting reduced output current level. over-current shortcircuit condition continues, thermal-limiting circuits will first sense rise junction temperature then rise chip temperature, further decreasing output current. Under worst-case conditions, these devices will tolerate short circuits outputs, simultaneously. These devices used drive various loads including incandescent lamps (without warming limiting resistors) inductive loads such relays, solenoids, stepping motors. packages offer fused leads enhanced thermal dissipation. Package 16-pin power with exposed tabs, 28-lead power PLCC, 16-lead power wide-body SOIC surfacemount applications. lead (Pb) free versions have 100% matte leadframe plating.
Data Sheet 29317.14D
OUT4 OUT3 GROUND GROUND OUT2 OUT1
ENABLE GROUND GROUND
Dwg. PP-017-1
ABSOLUTE MAXIMUM RATINGS
25°C Output Voltage, VOUT Over-Current Protected Output Voltage, VOUT Output Current, IOUT Supply Voltage, Input Voltage, Package Power Dissipation, Graph Operating Temperature Range, Prefix `UDK' -40°C +125°C Prefix `UDN' -20°C +85°C Prefix `UDQ' -40°C +85°C Storage Temperature Range, -55°C +150°C *Outputs peak current limited approximately driver. Circuit Description Application further information.
FEATURES
Output Current Channel Independent Over-Current Protection Each Driver Thermal Protection Device Each Driver Output-Saturation Voltage Integral Output Flyback Diodes CMOS Compatible Inputs
2559 PROTECTED QUAD POWER DRIVER
Selection Guide Part Number Pb-free Package Ambient Temperature (°C)
UDN2559B UDN2559B-T UDN2559EB UDN2559EB-T UDN2559LB UDN2559LB-T UDQ2559B UDQ2559B-T UDQ2559LB UDQ2559LB-T UDK2559B UDK2559B-T UDK2559EB UDK2559EB-T UDK2559LB UDK2559LB-T
16-pin DIP, exposed tabs 16-pin DIP, exposed tabs 28-lead PLCC 16-pin DIP, exposed tabs 16-lead SOIC 16-lead SOIC 16-pin DIP, exposed tabs 16-pin DIP, exposed tabs 16-lead SOIC 16-lead SOIC 16-pin DIP, exposed tabs 16-pin DIP, exposed tabs 28-lead PLCC 28-lead PLCC 16-lead SOIC 16-pin DIP, exposed tabs
UDx2559LB
GROUND GROUND ENABLE GROUND GROUND
Dwg. PP-017-6
Northeast Cutoff, 15036 Worcester, Massachusetts 01615-0036 (508) 853-5000
2559 PROTECTED QUAD POWER DRIVER
FUNCTIONAL BLOCK DIAGRAM
Channels)
ENABLE THERMAL LIMIT
OUTN
Dwg. FP-041
UDx2559EB
ALLOWABLE PACKAGE POWER DISSIPATION WATTS
CONNECTION
ENABLE
OUT2
OUT1
SUFFIX 'EB', 36°C/W
6°C/W
GROUND GROUND GROUND GROUND
SUFFIX 'B', 43°C/W
SUFFIX 'LB', 90°C/W
CONNECTION
SUPPLY
TEMPERATURE
Dwg. GP-004-2B
Dwg. PP-019-1
(VOUT1 IOUT1 (VOUTn IOUTn (VCC ICC) TA)/RJA
Northeast Cutoff, 15036 Worcester, Massachusetts 01615-0036 (508) 853-5000 Copyright 1995, 2002 Allegro MicroSystems, Inc.
2559 PROTECTED QUAD POWER DRIVER
ELECTRICAL CHARACTERISTICS +25°C (prefix `UDN') over operating temperature range (prefix `UDK' `UDQ'), 4.75 5.25
Limits Characteristic Output Leakage Current Symbol ICEX Test Conditions VOUT VOUT Output Sustaining Voltage Output Saturation Voltage VOUT(SUS) VOUT(SAT) IOUT Devices, IOUT Devices, IOUT `EB' Packages Only, IOUT Over-Current Trip Input Voltage ITRIP Logic Logic Input Current Logic Logic Total Supply Current VIN(1) VEN(1) VIN(0) VEN(0) VIN(1) VEN(1) VIN(0) VEN(0) Outputs VIN* Outputs Clamp Diode Forward Voltage Clamp Diode Leakage Current Turn-On Delay tPHL tPLH Thermal Limit IOUT IOUT Min. Typ. <1.0 <1.0 Max. Units
Typical Data design information only. Negative current defined coming (sourcing) specified terminal. used here, -100 defined greater than (absolute magnitude convention) minimum implicitly zero. inputs simultaneously, other tests performed with each input tested separately.
www.allegromicro.com
2559 PROTECTED QUAD POWER DRIVER
TYPICAL OUTPUT CHARACTERISTIC CIRCUIT DESCRIPTION APPLICATION
INCANDESCENT LAMP DRIVER
150°C
SCALE
OUTPUT VOLTAGE,
High incandescent lamp turn-ON/in-rush currents contribute poor lamp reliability destroy semiconductor lamp drivers. Warming current-limiting resistors protect both driver lamp significant power either when lamp when lamp respectively. Lamps with steady-state current ratings driven these devices without need warming (parallel) current-limiting (series) resistors. When incandescent lamp initially turned cold filament minimum resistance would normally allow in-rush current. With these drivers, during turn-ON, high in-rush current sensed internal low-value sense resistor. Drive current output stage then diverted shunting transistor, load current momentarily limited approximately During this short transition period, output current reduced value dependent supply voltage filament resistance. During lamp warmup, filament resistance increases maximum value, output stage goes into saturation applies maximum rated voltage lamp.
INDUCTIVE LOAD DRIVER Bifilar (unipolar) stepper motors, relays, solenoids driven directly. internal flyback diodes prevent damage output transistors suppressing high-voltage spikes that occur when turning inductive load. rapid current decay (fast turn-OFF speeds), Zener diodes will raise flyback voltage inprove performance. However, peak voltage must exceed specified minimum sustaining voltage (VSUPPLY VOUT(SUS)). FAULT CONDITIONS
165°C
JUNCTION TEMP. LIMIT
THERMAL GRADIENT SENSING OUT(SAT)
TRIP
OUTPUT CURRENT,
Dwg. GP-013
TYPICAL OUTPUT BEHAVIOR
NORMAL LAMP IN-RUSH CURRENT
SCALE
LAMP CURRENT
THERMAL GRADIENT SENSING CURRENT LIMIT ITRIP
event shorted load, load current will attempt increase. described above, drive current affected output stage reduced, causing output stage linear, limiting peak output current approximately power dissipation that output stage increases, thermal gradient sensing circuit will become operational, further decreasing drive current affected output stage reducing output current value dependent supply voltage load resistance. Continuous multiple overload conditions causing chip temperature reach approximately 165°C will result additional reduction output current maintain safe level. fault condition corrected, output stage will return normal saturated condition.
TIME
Dwg. WP-008
Northeast Cutoff, 15036 Worcester, Massachusetts 01615-0036 (508) 853-5000
2559 PROTECTED QUAD POWER DRIVER
Package, 16-pin
with internally fused pins external thermal tabs
Preliminary dimensions, reference only Dimensions inches Metric dimensions (mm) brackets, reference only (reference JEDEC MS-001 Dimensions exclusive mold flash, gate burrs, dambar protrusions Exact case lead configuration supplier discretion within limits shown Terminal mark area
.775 19.69 .735 18.67
.014 0.36 .008 0.20
.280 7.11 .240 6.10
.300 .7.62
.430 10.92
.195 4.95 .115 2.92 .015 0.38 .100 .2.54 .022 .056 .014 .036 .010 [0.25] .150 3.81 .115 2.92
.210 5.33
SEATING PLANE
.005 0.13 .070 1.78 .045 1.14
2559 PROTECTED QUAD POWER DRIVER
Package, 28-pin PLCC
with internally fused pins through through
.495 12.57 .485 12.32 .007 [0.18]
.456 11.58 .450 11.43 .007 [0.18] .002 [0.05]
.456 11.58 .450 11.43 .007 [0.18] .002 [0.05]
.020 0.51
.219 5.56 .191 4.85
.219 5.56 .191 4.85 .495 12.57 .485 12.32 .007 [0.18] .020 0.51 .120 3.05 .090 2.29 .032 0.81 .026 0.66 .007 [0.18] .004 [0.10] .021 0.53 .013 0.33 .007 [0.18] .219 5.56 .191 4.85 Preliminary dimensions, reference only (reference JEDEC MS-018 Dimensions inches Millimeters (mm) brackets, reference only Dimensions exclusive mold flash, gate burrs, dambar protrusions Exact case lead configuration supplier discretion within limits shown Terminal mark area .219 5.56 .191 4.85 .180 4.57 .165 4.19
SEATING PLANE
.050 1.27
www.allegromicro.com
2559 PROTECTED QUAD POWER DRIVER
with internally fused pins
Package, 16-pin SOIC
10.63 .419 9.97 .393 0.25 [.010] 10.50 .614 10.10 .598 0.33 .013 0.20 .008
7.60 .299 7.40 .291 1.27 .050 0.40 .016
0.25 .010
0.10 [.004] 0.51 .020 0.31 .012 0.25 [.010] 1.27 .050
SEATING PLANE 2.65 .104 2.35 .093 0.30 .012 0.10 .004
SEATING PLANE GAUGE PLANE
Preliminary dimensions, reference only Dimensions millimeters U.S. Customary dimensions (in.) brackets, reference only (reference JEDEC MS-013 Dimensions exclusive mold flash, gate burrs, dambar protrusions Exact case lead configuration supplier discretion within limits shown Terminal mark area
Northeast Cutoff, 15036 Worcester, Massachusetts 01615-0036 (508) 853-5000
2559 PROTECTED QUAD POWER DRIVER
products described here manufactured under more U.S. patents U.S. patents pending. Allegro MicroSystems, Inc. reserves right make, from time time, such departures from detail specifications required permit improvements performance, reliability, manufacturability products. Before placing order, user cautioned verify that information being relied upon current. Allegro products authorized critical components life-support devices systems without express written approval. information included herein believed accurate reliable. However, Allegro MicroSystems, Inc. assumes responsibility use; infringement patents other rights third parties which result from use.
Northeast Cutoff, 15036 Worcester, Massachusetts 01615-0036 (508) 853-5000

PROTECTED QUAD POWER DRIVER Providing improved output current lim

Top Searches for this datasheet

Other recent searches