74LVC2G06 Inverters with open-drain outputs Product specification
|
|
|
Top Searches for this datasheet
74LVC2G06 Inverters with open-drain outputs
Product specification 2003
Philips Semiconductors
Product specification
Inverters with open-drain outputs
FEATURES Wide supply voltage range from 1.65 tolerant input/output interfacing with logic High noise immunity Complies with JEDEC standard: JESD8-7 (1.65 1.95 JESD8-5 (2.3 JESD8B/JESD36 (2.7 output drive (VCC CMOS power consumption Latch-up performance exceeds Direct interface with levels Inputs accept voltages SOT363 SOT457 package protection: EIA/JESD22-A114-A exceeds 2000 EIA/JESD22-A115-A exceeds Specified from +125 QUICK REFERENCE DATA Tamb SYMBOL tPLZ/tPZL PARAMETER propagation delay input output CONDITIONS Notes used determine dynamic power dissipation µW). VCC2 VCC2 where: input frequency MHz; output frequency MHz; output load capacitance supply voltage Volts; total load switching outputs; VCC2 outputs. condition VCC. input capacitance power dissipation capacitance gate notes DESCRIPTION
74LVC2G06
74LVC2G06 high-performance, low-power, low-voltage, Si-gate CMOS device superior most advanced CMOS compatible families. Inputs driven from either devices. This feature allows this device mixed environment. Schmitt trigger action inputs makes circuit tolerant slower input rise fall time. This device fully specified partial power-down applications using Ioff. Ioff circuitry disables output, preventing damaging backflow current through device when powered down. 74LVC2G06 provides inverting buffers. output this device open drain connected other open-drain outputs implement active-LOW wired-OR active-HIGH wired-AND functions.
TYPICAL
UNIT
2003
Philips Semiconductors
Product specification
Inverters with open-drain outputs
FUNCTION TABLE note INPUT Note HIGH voltage level; voltage level; high-impedance OFF-state. ORDERING INFORMATION PACKAGE TYPE NUMBER TEMPERATURE RANGE 74LVC2G06GW 74LVC2G06GV PINNING SYMBOL DESCRIPTION data input ground data input data output supply voltage data output
MNB094
74LVC2G06
OUTPUT
PINS
PACKAGE SC-88 SC-74
MATERIAL plastic plastic
CODE SOT363 SOT457
MARKING
+125 +125
handbook, halfpage
Fig.1 configuration.
handbook, halfpage
handbook, halfpage
MNB095
MNB096
Fig.2 Logic symbol.
Fig.3 IEEE/IEC logic symbol.
2003
Philips Semiconductors
Product specification
Inverters with open-drain outputs
RECOMMENDED OPERATING CONDITIONS SYMBOL Tamb PARAMETER supply voltage input voltage output voltage operating ambient temperature input rise fall times 1.65 active mode Power-down mode CONDITIONS MIN. 1.65
74LVC2G06
MAX. +125
UNIT
ns/V ns/V
LIMITING VALUES accordance with Absolute Maximum Rating System (IEC 60134); voltages referenced (ground SYMBOL ICC, IGND Tstg Notes input output voltage ratings exceeded input output current ratings observed. When (Power-down mode), output voltage normal operation. PARAMETER supply voltage input diode current input voltage output diode current output voltage output source sink current current storage temperature power dissipation Tamb +125 note active mode; notes CONDITIONS -0.5 -0.5 MIN. -0.5 MAX. +6.5 +6.5 +6.5 ±100 +150 UNIT
Power-down mode; notes -0.5
2003
Philips Semiconductors
Product specification
Inverters with open-drain outputs
CHARACTERISTICS recommended operating conditions; voltages referenced (ground TEST CONDITIONS SYMBOL PARAMETER OTHER Tamb note HIGH-level input voltage 1.65 1.95 LOW-level input voltage 1.65 1.95 LOW-level output voltage Ioff input leakage current 3-state output OFF-state VIL; current power leakage current 1.65 1.65 1.65 ±0.1 ±0.1 ±0.1 0.65 MIN. TYP.
74LVC2G06
MAX.
UNIT
0.35 0.45 0.55 0.55
quiescent supply current GND; additional quiescent supply current
2003
Philips Semiconductors
Product specification
Inverters with open-drain outputs
74LVC2G06
TEST CONDITIONS SYMBOL PARAMETER OTHER Tamb +125 HIGH-level input voltage 1.65 1.95 LOW-level input voltage 1.65 1.95 LOW-level output voltage Ioff Note typical values measured Tamb input leakage current 3-state output OFF-state VIL; current power leakage current 1.65 1.65 1.65 0.70 0.45 0.60 0.80 0.80 5000 0.65 0.35 MIN. TYP. MAX. UNIT
quiescent supply current GND; additional quiescent supply current
2003
Philips Semiconductors
Product specification
Inverters with open-drain outputs
CHARACTERISTICS TEST CONDITIONS SYMBOL PARAMETER WAVEFORMS Tamb note tPLZ/tPZL propagation delay input output Figs 1.65 1.95 Tamb +125 tPLZ/tPZL propagation delay input output Figs 1.65 1.95 Note MIN.
74LVC2G06
TYP.
MAX.
UNIT
typical values measured Tamb 1.8, 2.5, 2.7, respectively. WAVEFORMS
handbook, full pagewidth
input output
MNA529
INPUT 1.65 1.95 0.15 0.15
typical output voltage drop that occur with output load.
Fig.4 input (nA) output (nY) propagation delays.
2003
Philips Semiconductors
Product specification
Inverters with open-drain outputs
74LVC2G06
handbook, full pagewidth
VEXT PULSE GENERATOR D.U.T.
MNA616
1.65 1.95
VEXT tPZL/tPLZ
Definitions test circuit: Load resistor. Load capacitance including probe capacitance. Termination resistance should equal output impedance pulse generator.
Fig.5 Load circuitry switching times.
2003
Philips Semiconductors
Product specification
Inverters with open-drain outputs
PACKAGE OUTLINES Plastic surface mounted package; leads
74LVC2G06
SOT363
index
detail
scale
DIMENSIONS original dimensions) UNIT 0.30 0.20 0.25 0.10 1.35 1.15 0.65 0.45 0.15 0.25 0.15
OUTLINE VERSION SOT363
REFERENCES JEDEC EIAJ SC-88
EUROPEAN PROJECTION
ISSUE DATE 97-02-28
2003
Philips Semiconductors
Product specification
Inverters with open-drain outputs
74LVC2G06
Plastic surface mounted package; leads
SOT457
index
detail
scale
DIMENSIONS original dimensions) UNIT 0.013 0.40 0.25 0.26 0.10 0.95 0.33 0.23
OUTLINE VERSION SOT457
REFERENCES JEDEC EIAJ SC-74
EUROPEAN PROJECTION
ISSUE DATE 97-02-28 01-05-04
2003
Philips Semiconductors
Product specification
Inverters with open-drain outputs
DATA SHEET STATUS LEVEL DATA SHEET STATUS(1) Objective data PRODUCT STATUS(2)(3) Development DEFINITION
74LVC2G06
This data sheet contains data from objective specification product development. Philips Semiconductors reserves right change specification manner without notice. This data sheet contains data from preliminary specification. Supplementary data will published later date. Philips Semiconductors reserves right change specification without notice, order improve design supply best possible product. This data sheet contains data from product specification. Philips Semiconductors reserves right make changes time order improve design, manufacturing supply. Relevant changes will communicated Customer Product/Process Change Notification (CPCN).
Preliminary data Qualification
Product data
Production
Notes Please consult most recently issued data sheet before initiating completing design. product status device(s) described this data sheet have changed since this data sheet published. latest information available Internet data sheets describing multiple type numbers, highest-level product status determines data sheet status. DEFINITIONS Short-form specification data short-form specification extracted from full data sheet with same type number title. detailed information relevant data sheet data handbook. Limiting values definition Limiting values given accordance with Absolute Maximum Rating System (IEC 60134). Stress above more limiting values cause permanent damage device. These stress ratings only operation device these other conditions above those given Characteristics sections specification implied. Exposure limiting values extended periods affect device reliability. Application information Applications that described herein these products illustrative purposes only. Philips Semiconductors make representation warranty that such applications will suitable specified without further testing modification. DISCLAIMERS Life support applications These products designed life support appliances, devices, systems where malfunction these products reasonably expected result personal injury. Philips Semiconductors customers using selling these products such applications their risk agree fully indemnify Philips Semiconductors damages resulting from such application. Right make changes Philips Semiconductors reserves right make changes products including circuits, standard cells, and/or software described contained herein order improve design and/or performance. When product full production (status `Production'), relevant changes will communicated Customer Product/Process Change Notification (CPCN). Philips Semiconductors assumes responsibility liability these products, conveys licence title under patent, copyright, mask work right these products, makes representations warranties that these products free from patent, copyright, mask work right infringement, unless otherwise specified.
2003
Philips Semiconductors worldwide company
Contact information additional information please visit Fax: 24825 sales offices addresses send e-mail
Koninklijke Philips Electronics N.V. 2003
SCA75
rights reserved. Reproduction whole part prohibited without prior written consent copyright owner. information presented this document does form part quotation contract, believed accurate reliable changed without notice. liability will accepted publisher consequence use. Publication thereof does convey imply license under patent- other industrial intellectual property rights.
Printed Netherlands
R20/01/pp12
Date release: 2003
Document order number:
9397 11755
Other recent searches
XP04216 - XP04216 XP04216 Datasheet
TLV225x - TLV225x TLV225x Datasheet
TLV225xA - TLV225xA TLV225xA Datasheet
Si8440 - Si8440 Si8440 Datasheet
P1750A - P1750A P1750A Datasheet
2SD2117 - 2SD2117 2SD2117 Datasheet
Privacy Policy | Disclaimer
© 2012 Datasheet Archive
