CA708-01-01D SPECIFICATIONS ZWS120PPF-24 ITEMS Nominal

The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.

CA708-01-01D SPECIFICATIONS ZWS120PPF-24 ITEMS Nominal

Datasheet Thumbnail

Top Searches for this datasheet

ZWS120PPF
CA708-01-01D
SPECIFICATIONS
ZWS120PPF-24
ITEMS Nominal Output Voltage Minimum Output Current Maximum Output Current Peak Output Current Maximum Output Power Peak Output Power Efficiency (Typ) Input Voltage Range Input Current (Typ) Inrush Current (Typ) PFHC Output Voltage Range Maximum Ripple Noise Maximum Line Regulation Maximum Load Regulation Maximum Temperature Drift Over Current Protection Over Voltage Protection Hold-Up Time (Typ) Parallel Operation Series Operation Operating Temperature Operating Humidity Storage Temperature Storage Humidity Cooling Withstand Voltage
ZWS120PPF-28
ZWS120PPF-36
(*1) (*1) (*2) (*3)
(*4) (*5) (*9) (*2)
Isolation Resistance Vibration
120.4 122.4 240.8 241.2 132VAC 265VAC Auto selectable 63Hz 1.2A 200VAC 200VAC 25°C Cold Start Conform 1000 class ±10% 205% 135% 17ms 120W Possible 60°C CONVECTION: 50°C 100% 60°C 85°C 95%RH Convection cooling Input Output 3.0kVAC (20mA), Input 2.0kVAC (20mA) Output 500VAC (100mA) 1min. More than 100M Ta=25°C 70%RH, Output 500VDC 55Hz Amplitude sweep 1min Less than 19.6m/s2 each Less than 196.1m/s2 Conform UL1950, 950, EN60950, Build meet DENTORI Conform VCCI class EN55022B
Shock Safety Weight Size W.H.D.)
NOTES: Operating time peak output less than 10sec. Duty 0.35 100VAC maximum output power, 25°C. cases where conformance various safety specs CSA, required described 120VAC,200 240VAC, 60Hz name plate. 100/230VAC Input power Maximum Output Power Please refer measurement line load regulation output ripple voltage.
(Measure with JEITA RC-9131 probe)
From -132VAC 265VAC, constant load. From load Full load Maximum power constant input voltage. From +50°C, constant input voltage load. Current limiting with automatic recovery. Avoid operate overload dead short more than 30seconds. circuit will shutdown output, manual reset. Refer Instruction Manual. standard mounting method, Measurement point ripple
Component side
Fig.
Measurement point Load Line regulation
Fig.
150mm AWG#18 Elec. 100µF Film 0.1µF Bandwidth scope 100MHz
ZWS120PPF
CA708-01-02
OUTPUT DERATING
*COOLING: CONVECTION COOLING LOADING CONDITION (°C) Mounting Mounting Mounting Mounting Mounting
OUTPUT DERATING CURVE
LOAD (°C)
Mounting:
Input connector
Input connector
Input
Output
Component
Output
Input

CA708-01-01D SPECIFICATIONS ZWS120PPF-24 ITEMS Nominal

Top Searches for this datasheet

Other recent searches