Voice 1-To-8 copier designed fast copying Aplus' Voice devices mass pr

The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.

Voice 1-To-8 copier designed fast copying Aplus' Voice devices mass pr

Datasheet Thumbnail

Top Searches for this datasheet

aP89C24 User Manual Voice Copier aP89341/170/085
Voice 1-To-8 copier designed fast copying Aplus' Voice devices mass production. Devices supported aP89341, 085. From eight pieces blank devices copied time. make copy, MASTER chip with voice data inserted MASTER socket. Blank chips inserted into OTP1 OTP8 sockets. Finally, COPY button pressed start copying. Busy (Yellow) Test Operation Copy Operation System Error Fail (All) Test Pass (Not All) Test Pass (All) Copy Pass (Not All) Copy Pass (All) Flash Flash Flash
Fail (Red) Flash
Status (Green) Flash Flash Flash On/Off
2007-7-9
Table Mode operation
POWER SUPPLY CONNECTION
regulated 5V~12V power supply minimum 1Amp capacity should used power source. centre jack positive terminal while outer contact terminal. Incorrect connection terminals will damage copier board. When power supply correctly connected, copier board will undergo power-up reset LEDs will flash times. This represents copier board ready use.
MASTER CHIPS PREPARATION
MASTER chip inserted into MASTER socket provides source voice data copy into blank ICs. MASTER chip produced based programmer. "Security" check under "Writer" menu must checked. Otherwise, chip will security protected copier will refuse copying with security protected MASTER chip. Please refer based Voice developing system user guide details compile program chip. Note that chip copied from copier cannot used MASTER chip because security protected.
TEST OPERATION
This function will blank check beginning bytes memory test program byte into chips. Follow procedures below TEST operation:
Insert from maximum blank into OTP1 OTP8 sockets (any socket empty there less than blank used.). Press TEST button. progress. BUSY will flash when operation
BUSY turns again indicate test operation finishes. When GREEN Flashing, indicates corresponding passed test. GREEN FAIL indicates corresponding blank unable copied.
FAIL will turn under test failed.
2007-7-9
COPY OPERATION
This function will copy data from MASTER chip chips inserted into OTP1 OTP8. Follow procedures below TEST operation:
master chip (the chip with original voice data) inserted into MASTER socket copier board. Insert from maximum blank into OTP1 OTP8 sockets (any socket left empty there less than blank used.). Press COPY button start copy BUSY begins flash. BUSY stops turns when copying finished. GREEN under corresponding socket turns indicate successfully programmed. When OFF, corresponding copied successfully. When programmed failed after programming, FAIL will turn
ERROR CHECKING MASTER
There error checking mechanism check data integrity MASTER chip. This important because data MASTER corrupted, copied will have wrong data copied. beginning COPY operation, data integrity MASTER chip checked. copier board finds data error MASTER chip, will prevent COPY operation process. whole system will Halted prevent further operation flash non-stop. When this happens, user should remove MASTER chip. Disconnect
power supply reconnect again reset board. Insert another MASTER chip replace one, insert blank press COPY button copy again.
2007-7-9
aP89C24 QUICK START GUIDE Voice Copier aP89341/170/085
Connecting Power Supply regulated power supply with min. 1Amp current capacity needed. Connect centre outer terminal power jack. LEDs flash times indicate ready use.
TEST Operation Insert tested empty sockets. Press TEST button start. BUSY flashes indicate testing progress. Green turns Flash means under check passed. FAIL turns when there under check passed.
COPY Opteration Insert with source data into MASTER socket. Insert copied empty socket. Press COPY button start copying. BUSY flashes indicate copying progress. Green turns means copy passed. FAIL turns when there copy passed.
Master Error (When COPY button pressed flash non-stop) This indicates copier board finds MASTER certain problem. Remove including MASTER Disconnect power supply. Wait re-connect power supply. Repeat Copy procedure above. copy process still cannot start, replace MASTER repeat power down power action again.
2007-7-9

Voice 1-To-8 copier designed fast copying Aplus' Voice devices mass pr

Top Searches for this datasheet

Other recent searches