1.8V-3.3V PicoPLL Programmable Quick Turn Clock CONFIGURATION SPE
|
|
|
Top Searches for this datasheet
PL611s-02/03
1.8V-3.3V PicoPLL Programmable Quick Turn Clock
CONFIGURATION SPEC.
0.85mm (850µmx750µm)
0.75mm
Advanced Time Programmable design. XOUT Programmable Direct Oscillation operation. FSEL, Very Jitter Phase Noise (30-70ps Pk-Pk typical) PDB^ Output frequency range 133MHz 1.8V operation 166MHz 2.5V operation Note: denotes internal pull 200MHz 3.3V operation Input Frequency: Fundamental crystal: 10MHz-50MHz. XOUT 8bit Switch Capacitor ±50ppm crystal tuning. current consumption, <10µA when FSEL, PDB^ activated. programmable configured Output Enable (OE) Power Down (PDB) input. Note: denotes internal pull Single 1.8V, 2.5V, 3.3V power supply Operating temperature range from -40°C 85°C SPECIFICATION Wire bond (PL611s-02) Flip-Chip layout.
PL611s-02
0.75mm
(0,0)
0.85mm
(850µmx750µm)
PL611s-03
(0,0)
Parameter Chip size Chip thickness size Chip Base
Value 0.75 0.85mm <150-250µm 90µm level
DESCRIPTION
PL611s high performance low-cost general purpose frequency synthesizer member PhaseLink's PicoPLL Factory Programmable `Quick Turn Clock (QTC)'. Designed small 2.5mmx2.0mm oscillator module high performance applications, PL611s offers best phase noise jitter performance, smallest size, power consumption comparable device. power down feature PL611s, when activated, allows consume less than 10µA power, while programming flexibility allows generating output, using low-cost crystal input.
BLOCK DIAGRAM
XIN/FIN XOUT XTAL Fref R-counter (8-Bit)
Programmable CLoad
M-counter (11-Bit)
Phase Detector
Charge Pump
Loop Filter
Fvco= Fref
Fout= Fvco/
Programmable Function
P-counter (5-Bit)
Programming Logic
47745 Fremont Blvd., Fremont, California 94538 (510) 492-0990 (510) 492-0991 www.phaselink.com 06/19/06 Page
PL611s-02/03
Charge-Pump Current
Charge pump current levels; programmable
1.8V-3.3V PicoPLL Programmable Quick Turn Clock
PROGRAMMING PARAMETERS
Output Frequency
Mode Fout Where: M=11 Note: FVCO/(2*P) Direct Oscillation Mode: Fout FIN/(2*P)
Output Drive Strength
Three optional drives choose from. They are: Low: Std: (default) High: 16mA
Crystal Load
Frequency Tuning ±50ppm
Programmable Input/Output
configured input input
ASSIGNMENT DESCRIPTION (PL611s-02)
Name
Assignment* (µm) (µm)
125.00 665.21
Type
Crystal input
Description
85.00
375.00
This programmable configured Output Enable (OE) input, Power Down input (PDB). This internal pull resistor. State (default) Tri-state Operating mode Power Down Mode Operating mode
XOUT
85.00 765.00 765.00 725.00
115.45 115.45 375.00 665.21
connection Programmable Clock Output connection Crystal Output
Note: coordinates indicate centers.
ASSIGNMENT DESCRIPTION (PL611s-03)
Name
XOUT
Assignment* (µm)
125.00 85.00 85.00 765.00
Type
Description
Crystal Output connection Programmable Clock Output connection This programmable configured Output Enable (OE) input, Power Down input (PDB). This internal pull resistor. State (default) Tri-state Operating mode Power Down Mode Operating mode
(µm)
665.21 375.00 115.45 115.45
765.00
375.00
725.00
665.21
Crystal input
47745 Fremont Blvd., Fremont, California 94538 (510) 492-0990 (510) 492-0991 www.phaselink.com 06/19/06 Page
Note: coordinates indicate centers.
PL611s-02/03
1.8V-3.3V PicoPLL Programmable Quick Turn Clock
ELECTRICAL SPECIFICATIONS
ABSOLUTE MAXIMUM RATINGS PARAMETERS
Supply Voltage Range Input Voltage Range Output Voltage Range Data Retention 85°C Storage Temperature Ambient Operating Temperature
SYMBOL
MIN.
MAX.
UNITS
Year
Exposure device under conditions beyond limits specified Maximum Ratings extended periods cause permanent damage device affect product reliability. These conditions represent stress rating only, functional operations device these other conditions above operational limits noted this specification implied.
SPECIFICATIONS
PARAMETERS
Crystal Input Frequency (XIN) Output Frequency Output Frequency Output Frequency Settling Time Output Enable Time (See MTC-1) Output Disable Time (See MTC-1) Sensitivity Output Rise Time (See MTC-1) Output Fall Time (See MTC-1) Duty Cycle (See MTC-1)
CONDITIONS
Fundamental Crystal Vdd=3.3V Vdd=2.5V Vdd=1.8V power-up (after increases over 1.62V) Function; 15pF Load Function; 15pF Load 15pF Load Frequency VDD+/-10% 15pF Load, 10/90%VDD, High Drive, 3.3V 15pF Load, 90/10%VDD, High Drive, 3.3V Enabled, VDD/2 Disabled
MIN.
TYP.
MAX.
UNITS
47.5
52.5
Period Jitter, Pk-to-Pk* With capacitive decoupling between (measured from 10,000 GND. samples) (See MTC-3) Note: Jitter performance depends programming parameters.
47745 Fremont Blvd., Fremont, California 94538 (510) 492-0990 (510) 492-0991 www.phaselink.com 06/19/06 Page
PL611s-02/03
1.8V-3.3V PicoPLL Programmable Quick Turn Clock
SPECIFICATIONS
PARAMETERS
Supply Current, Dynamic, with Loaded CMOS Outputs Supply Current, Dynamic, with Loaded CMOS Outputs Supply Current, Dynamic with Loaded CMOS Outputs Off: Supply Current, Dynamic, with Loaded CMOS Output Off: Supply Current, Dynamic, with Loaded CMOS Output Off: Supply Current, Dynamic with Loaded CMOS Output Stand Current, with Loaded Outputs (See MTC-1) Operating Voltage Output Voltage Output High Voltage Output Current, drive (See MCT-2) Output Current, Standard drive (See MCT-2) Output Current, High drive (See MCT-2)
SYMBOL
CONDITIONS
@Vdd=3.3V,30MHz, load=15pF @Vdd=2.5V,30MHz, load=15pF @Vdd=1.8V,30MHz, load=5pF @Vdd=3.3V,30MHz, load=15pF @Vdd=2.5V,30MHz, load=15pF @Vdd=1.8V,30MHz, load=5pF When PDB=0
MIN.
TYP.
2.1* 2.0* 1.6* 0.8*
MAX.
UNITS
1.62 3.63
+4mA Standard Drive -4mA Standard Drive 0.4V, 2.4V 0.4V, 2.4V 0.4V, 2.4V
Note: Please contact PhaseLink super low-power required.
CRYSTAL SPECIFICATIONS
PARAMETERS
Fundamental Crystal Resonator Frequency Crystal Loading Rating (The programmed value this range.) Maximum Sustainable Drive Level Operating Drive Level Crystal Shunt Capacitance Effective Series Resistance, Fundamental, 10-50MHz (See MCT-4)
Note: detailed crystal specification document also available this part
SYMBOL
(xtal)
MIN.
TYP.
MAX.
UNITS
47745 Fremont Blvd., Fremont, California 94538 (510) 492-0990 (510) 492-0991 www.phaselink.com 06/19/06 Page
PL611s-02/03
1.8V-3.3V PicoPLL Programmable Quick Turn Clock
MEASUREMENT TEST CIRCUITS (MTC)
MTC-1: Rise Time, Fall Time, Duty Cycle, VOL, VOH, Idd, Power Down Current, Output Enable/Disable MTC-3: Jitter Phase Noise
XOUT
0.1µF
0.1µF
0.1µF
Probe
XOUT
MTC-2: Output Drive Current Output Impedance
MTC-4: Negative Resistance
0.1µF XOUT 0.1µF Probe Network Analyzer XOUT 0.1µF
47745 Fremont Blvd., Fremont, California 94538 (510) 492-0990 (510) 492-0991 www.phaselink.com 06/19/06 Page
PL611s-02/03
1.8V-3.3V PicoPLL Programmable Quick Turn Clock
WAVEFORM SWITCHING CHARACTERISTICS Rise Fall times:
90%Vdd
10%Vdd
Duty Cycle: 50%Vdd Duty Cycle 100%
VOH, VOL:
47745 Fremont Blvd., Fremont, California 94538 (510) 492-0990 (510) 492-0991 www.phaselink.com 06/19/06 Page
PL611s-02/03
1.8V-3.3V PicoPLL Programmable Quick Turn Clock
ORDERING INFORMATION
part ordering, please contact Sales Department: 47745 Fremont Blvd., Fremont, 94538, Tel: (510) 492-0990 Fax: (510) 492-0991
PART NUMBER
order number this device combination following: Device number, Package type Operating temperature range
PL611s-0X
PART NUMBER PACKAGE W=WAFER
TEMPERATURE C=COMMERCIAL INDUSTRIAL
Part Order Number PL611s-0XWC PL611s-0XDC
Marking P611s-0XWC P611s-0XDC
Package Option Wafer
Temperature +70C +70C
PhaseLink Corporation, reserves right make changes products specifications, both time without notice. information furnished Phaselink believed accurate reliable. However, PhaseLink makes guarantee warranty concerning accuracy said information shall responsible loss damage whatever nature resulting from reliance upon this product. LIFE SUPPORT POLICY: PhaseLink's products authorized critical components life support devices systems without express written approval President PhaseLink Corporation.
47745 Fremont Blvd., Fremont, California 94538 (510) 492-0990 (510) 492-0991 www.phaselink.com 06/19/06 Page
Other recent searches
SST85LD1008M - SST85LD1008M SST85LD1008M Datasheet
RD60HUF1 - RD60HUF1 RD60HUF1 Datasheet
MT3303B-UY-A - MT3303B-UY-A MT3303B-UY-A Datasheet
LTC3545 - LTC3545 LTC3545 Datasheet
LTC3545 - LTC3545 LTC3545 Datasheet
LTC3545-1 - LTC3545-1 LTC3545-1 Datasheet
LTC3545EUD - LTC3545EUD LTC3545EUD Datasheet
LTC3545EUD-1 - LTC3545EUD-1 LTC3545EUD-1 Datasheet
DM74ALS251 - DM74ALS251 DM74ALS251 Datasheet
BTS5235-2G - BTS5235-2G BTS5235-2G Datasheet
AN251 - AN251 AN251 Datasheet
74ABT652A - 74ABT652A 74ABT652A Datasheet
Privacy Policy | Disclaimer
© 2012 Datasheet Archive
