| The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers. |
Clock Generator Features Description Three output clock
Top Searches for this datasheetFS6183-03 Clock Generator Features Description Three output clock frequencies Output enable function Crystal oscillator tunable with external varactor 3.3V supply voltage (contact factory phase noise, jitter Small circuit board footprint (8-pin 0.150 SOIC) Special high transconductance crystal oscillator suitable external varactor VCXO function desired Custom frequency selections available contact your local Sales Representative more information FS6183 monolithic CMOS clock generator designed minimize cost component count digital video/audio systems. high-resolution phase-locked loop generates three output clocks (CLKA, CLKB, CLKC) through array post-dividers. frequencies ratiometrically derived from crystal frequency. locking output frequencies together eliminate unpredictable artifacts video systems. Table Crystal Output Frequencies DEVICE fXIN (MHz) 13.500 CLKA (MHz) 27.000 CLKB (MHz) 54.000 CLKC (MHz) 13.500 Figure Configuration CLKA XOUT FS6183-03 CLKC CLKB NOTE: Contact custom frequencies volt operation FS6183 8-pin (0.150 SOIC Figure Block Diagram CRYSTAL OSC. XOUT DIVIDER ARRAY CLKA CLKB CLKC FS6183 12.15.99 ISO9001 FS6183-03 Clock Generator Table Descriptions Key: Analog Input; Analog Output; Digital Input; Input with Internal Pull-Up; Input with Internal Pull-Down; Digital Input/Output; DI-3 Three-Level Digital Input, Digital Output; Power/Ground; Active TYPE NAME CLKA XOUT CLKB CLKC Clock Output Ground Crystal Oscillator Feedback Crystal Oscillator Drive Clock Output Clock Output Power Supply (+3.3V) Output Enable DESCRIPTION Functional Block Description Phase-Locked Loop (PLL) Crystal Oscillator on-chip PLLs standard frequency- phaselocked loop architecture. multiplies reference oscillator desired frequency ratio integers. frequency multiplication exact with zero synthesis error. oscillator operates crystal resonator parallel-resonant mode. FS6183-03 special high transconductance crystal oscillator insure start-up under conditions when used external varactor-based VCXO circuit used DCT-2000. ISO9001 12.15.99 FS6183-03 Clock Generator Electrical Specifications Table Absolute Maximum Ratings Stresses above those listed under Absolute Maximum Ratings cause permanent damage device. These conditions represent stress rating only, functional operation device these other conditions above operational limits noted this specification implied. Exposure maximum rating conditions extended conditions affect device performance, functionality, reliability. PARAMETER Supply Voltage (VSS ground) Input Voltage, Output Voltage, Input Clamp Current, VDD) Output Clamp Current, VDD) Storage Temperature Range (non-condensing) Ambient Temperature Range, Under Bias Junction Temperature Lead Temperature (soldering, 10s) Input Static Discharge Voltage Protection (MIL-STD 883E, Method 3015.7) SYMBOL MIN. VSS-0.5 VSS-0.5 VSS-0.5 MAX. VDD+0.5 VDD+0.5 UNITS CAUTION: ELECTROSTATIC SENSITIVE DEVICE Permanent damage resulting loss functionality performance occur this device subjected high-energy electrostatic discharge. Table Operating Conditions PARAMETER Supply Voltage Ambient Operating Temperature Range SYMBOL CONDITIONS/DESCRIPTION 3.3V MIN. TYP. MAX. UNITS ISO9001 12.15.99 FS6183-03 Clock Generator Table Electrical Specifications Unless otherwise stated, 3.3V 10%, load output, ambient temperature range 70°C. Parameters denoted with asterisk represent nominal characterization data production tested specific limits. Where given, characterization data typical. Negative currents indicate current flows device. PARAMETER Overall Supply Current, Dynamic, with Loaded Outputs Crystal Oscillator Crystal Resonator Frequency Crystal Loading Capacitance Crystal Oscillator Drive Transconductance Oscillator Source Current Oscillator Sink Current Clock Outputs (CLKA, CLKB, CLKC) High-Level Output Source Current Low-Level Output Sink Current Output Impedance Short Circuit Source Current Short Circuit Sink Current SYMBOL CONDITIONS/DESCRIPTION MIN. TYP. MAX. UNITS fXTAL 13.5MHz; 10pF fXTAL CL(xtal) gmOSC Fundamental Mode seen crystal connected XOUT 3.3V 3.3V V(XIN) V(XOUT) 3.3V V(XIN) VDD, V(XOUT) 13.5 mSiemens IOSH IOSL 2.0V 0.4V 0.1VDD; output driving high 0.1VDD; output driving shorted 30s, max. 3.3V; shorted 30s, max. Table Timing Specifications Unless otherwise stated, 3.3V 10%, load output, ambient temperature range 70°C. Parameters denoted with asterisk represent nominal characterization data production tested specific limits. Where given, characterization data typical. PARAMETER Clock Outputs (CLKx) Duty Cycle Jitter, Absolute Period (pk-pk) Jitter, Long Term Rise Time Fall Time Output Frequency Synthesis Error SYMBOL CONDITIONS/DESCRIPTION CLOCK (MHz) MIN. TYP. MAX. UNITS tclk; Measured VDD/2 tj(P) tj(LT) From rising edge next rising edge VDD/2, 10pF From 0-500µs VDD/2, 10pF compared ideal clock source 3.3V; 0.3V 3.0V; 10pF 3.3V; 3.0V 0.3V; 10pF (unless otherwise noted Frequency Table) ISO9001 12.15.99 FS6183-03 Clock Generator Package Information Table 8-pin SOIC (0.150") Package Dimensions DIMENSIONS INCHES MIN. 0.061 0.004 0.055 0.013 0.0075 0.189 0.150 0.230 0.010 0.016 MAX. 0.068 0.0098 0.061 0.019 0.0098 0.196 0.157 0.244 0.016 0.035 MILLIMETERS MIN. 1.55 0.102 1.40 0.33 0.191 4.80 3.81 5.84 0.25 0.41 MAX. 1.73 0.249 1.55 0.49 0.249 4.98 3.99 6.20 0.41 0.89 BASE PLANE RADII: 0.005" 0.01" SEATING PLANE typ. 0.050 1.27 Table 8-pin SOIC (0.150") Package Characteristics PARAMETER Thermal Impedance, Junction Free-Air 8-pin 0.150" SOIC Lead Inductance, Self Lead Inductance, Mutual Lead Capacitance, Bulk SYMBOL CONDITIONS/DESCRIPTION flow Corner lead Center lead lead adjacent lead lead TYP. 0.27 UNITS °C/W ISO9001 12.15.99 FS6183-03 Clock Generator Ordering Information DEVICE NUMBER FS6183-03 FS6183-03 PACKAGE TYPE 8-pin (0.150") SOIC (Small Outline Package) 8-pin (0.150") SOIC (Small Outline Package) OPERATING TEMPERATURE RANGE (Commercial) (Commercial) SHIPPING CONFIGURATION ORDERING CODE 11640-826 11640-836 Tape Reel Tubes Copyright 1999 American Microsystems, Inc. Devices sold covered warranty patent indemnification provisions appearing Terms Sale only. makes warranty, express, statutory implied description, regarding information forth herein regarding freedom described devices from patent infringement. makes warranty merchantability fitness purposes. reserves right discontinue production change specifications prices time without notice. AMI's products intended commercial applications. Applications requiring extended temperature range, unusual environmental requirements, high reliability applications, such military, medical life-support life-sustaining equipment, specifically recommended without additional processing such applications. American Microsystems, Inc., 2300 Buckskin Rd., Pocatello, 83201, (208) 233-4690, (208) 234-6796, Address: http://www.amis.com E-mail: tgp@amis.com ISO9001 12.15.99 Other recent searchesTPCF8102 - TPCF8102 TPCF8102 Datasheet PBA10F - PBA10F PBA10F Datasheet MPL025 - MPL025 MPL025 Datasheet MPL027 - MPL027 MPL027 Datasheet MPL038 - MPL038 MPL038 Datasheet MPL031 - MPL031 MPL031 Datasheet MPL034 - MPL034 MPL034 Datasheet MPI001 - MPI001 MPI001 Datasheet MPI002 - MPI002 MPI002 Datasheet MPB027 - MPB027 MPB027 Datasheet MPB038 - MPB038 MPB038 Datasheet MPB031 - MPB031 MPB031 Datasheet MPB037 - MPB037 MPB037 Datasheet LTC1427-50 - LTC1427-50 LTC1427-50 Datasheet APTM50DAM19 - APTM50DAM19 APTM50DAM19 Datasheet AD8001 - AD8001 AD8001 Datasheet 2N3904 - 2N3904 2N3904 Datasheet MAX6627 - MAX6627 MAX6627 Datasheet MAX6628 - MAX6628 MAX6628 Datasheet
Privacy Policy | Disclaimer |