Clock Generator with VCXO Features Description Matches
|
|
|
Top Searches for this datasheet
FS6128-07
Clock Generator with VCXO
Features
Description
Matches MK3727 center frequency characteristics Phase-locked loop (PLL) device synthesizes output clock frequency from crystal oscillator external reference clock On-chip tunable voltage-controlled crystal oscillator (VCXO) allows precise system frequency tuning 3.3V supply voltage Very phase noise with "pullable" 14pF crystals external padding capacitors required Small circuit board footprint (8-pin 0.150 SOIC) Custom frequency selections available contact your local Sales Representative more information
FS6128 monolithic CMOS clock generator designed minimize cost component count digital video/audio systems. core FS6128 circuitry that implements voltage-controlled crystal oscillator (VCXO) when external resonator (nominally 13.5MHz) attached. VCXO allows device frequencies precisely adjusted systems that have frequency matching requirements, such digital satellite receivers. high-resolution phase-locked loop generates output clock (CLK) through post-divider. frequency ratiometrically derived from VCXO frequency. locking frequency other system reference frequencies eliminate unpredictable artifacts video systems reduce electromagnetic interference (EMI) frequency harmonic stacking.
Figure Configuration
XTUNE
Table Crystal Output Frequencies
XOUT
DEVICE FS6128-07 fXIN (MHz) 13.500 (MHz) 27.000
8-pin (0.150) SOIC
Figure Block Diagram
FS6128-07
NOTE: Contact custom frequencies
VCXO XOUT XTUNE DIVIDER
FS6128-07
American Microsystems, Inc. reserves right change detail specifications required permit improvements design products.
ISO9001
8.8.00
FS6128-07
Clock Generator with VCXO
Table Descriptions
Key: Analog Input; Analog Output; Digital Input; Input with Internal Pull-Up; Input with Internal Pull-Down; Digital Input/Output; DI-3 Three-Level Digital Input, Digital Output; Power/Ground; Active
TYPE
NAME XTUNE XOUT VCXO Feedback Power Supply (+3.3V) VCXO Tune Ground Clock Output Power Supply (+3.3V) Ground VCXO Drive
DESCRIPTION
Functional Block Description
Voltage-Controlled Crystal Oscillator (VCXO)
EXAMPLE: crystal with following parameters used: 0.025pF 6pF. Using minimum maximum 10pF, 20pF, tuning range (peak-to-peak)
VCXO provides tunable, low-jitter frequency reference rest FS6128 system components. Loading capacitance crystal internal FS6128. external components (other than resonator itself) required operation VCXO. Continuous fine-tuning VCXO frequency accomplished varying voltage XTUNE pin. value this voltage controls effective capacitance presented crystal. actual amount that this load capacitance change will alter oscillator frequency depends characteristics crystal well oscillator circuit itself. important that crystal load capacitance specified correctly "center" tuning range. Table simple formula obtain "pulling" capability crystal oscillator
0.025
Phase-Locked Loop (PLL)
on-chip standard frequency- phaselocked loop architecture. multiplies reference oscillator frequency desired output frequency ratio integers. frequency multiplication exact with zero synthesis error (unless otherwise specified).
ppm)
where: shunt holder) capacitance crystal motional capacitance crystal extremes (minimum maximum) applied load capacitance presented FS6128.
ISO9001
8.8.00
FS6128-07
Clock Generator with VCXO
Electrical Specifications
Table Absolute Maximum Ratings
Stresses above those listed under Absolute Maximum Ratings cause permanent damage device. These conditions represent stress rating only, functional operation device these other conditions above operational limits noted this specification implied. Exposure maximum rating conditions extended conditions affect device performance, functionality, reliability.
PARAMETER Supply Voltage (VSS ground) Input Voltage, Output Voltage, Input Clamp Current, VDD) Output Clamp Current, VDD) Storage Temperature Range (non-condensing) Ambient Temperature Range, Under Bias Junction Temperature Lead Temperature (soldering, 10s) Input Static Discharge Voltage Protection (MIL-STD 883E, Method 3015.7)
SYMBOL
MIN. VSS-0.5 VSS-0.5 VSS-0.5
MAX. VDD+0.5 VDD+0.5
UNITS
CAUTION: ELECTROSTATIC SENSITIVE DEVICE
Permanent damage resulting loss functionality performance occur this device subjected high-energy electrostatic discharge.
Table Operating Conditions
PARAMETER Supply Voltage Ambient Operating Temperature Range Crystal Resonator Frequency SYMBOL fXTAL Fundamental Mode CONDITIONS/DESCRIPTION 3.3V MIN. 13.5 TYP. MAX. UNITS
ISO9001
8.8.00
FS6128-07
Clock Generator with VCXO
Table Electrical Specifications
Unless otherwise stated, 3.3V 10%, load output, ambient temperature range 70°C. Parameters denoted with asterisk represent nominal characterization data production tested specific limits. Where given, characterization data from typical. Negative currents indicate current flows device.
PARAMETER Overall Supply Current, Dynamic, with Loaded Outputs Supply Current, Static
SYMBOL
CONDITIONS/DESCRIPTION
MIN.
TYP.
MAX.
UNITS
fXTAL 13.5MHz; 10pF, 3.6V 3.6V
Voltage Controlled Crystal Oscillator (contact factory approved crystal sources other application assistance) Crystal Loading Capacitance Center Tuning Voltage Crystal Resonator Motional Capacitance XTUNE Effective Range Synthesized Load Capacitance Min. Synthesized Load Capacitance Max. VCXO Tuning Range VCXO Tuning Characteristic Crystal Drive Level Clock Output (CLK) High-Level Output Source Current Low-Level Output Sink Current Output Impedance Short Circuit Source Current Short Circuit Sink Current IOSH IOSL 2.0V 0.4V 0.1VDD; output driving high 0.1VDD; output driving shorted 30s, max. 3.3V; shorted 30s, max.
@V(XTUNE)=minimum value @V(XTUNE)=maximum value fXTAL 13.5MHz; CL(xtal) 14pF; C1(xtal) 25fF (peak-to-peak)
CL(xtal)
Order crystal this capacitance (parallel load) desired center frequency Specified motional capacitance crystal will affect pullability (see text)
ppm/V
Note: positive change XTUNE positive change VCXO frequency RXTAL=20; 20pF
ISO9001
8.8.00
FS6128-07
Clock Generator with VCXO
Table Timing Specifications
Unless otherwise stated, 3.3V 10%, load output, ambient temperature range 70°C. Parameters denoted with asterisk represent nominal characterization data production tested specific limits. Where given, characterization data from typical.
PARAMETER Overall VCXO Stabilization Time Stabilization Time Synthesis Error Clock Output (CLK) Duty Cycle Jitter, Period (peak-peak) Jitter, Long Term (y()) Rise Time Fall Time
SYMBOL
CONDITIONS/DESCRIPTION
MIN.
TYP.
MAX.
UNITS
tVCXOSTB tPLLSTB
From power valid From VCXO stable (unless otherwise noted Frequency Table)
Ratio high pulse width measured from rising edge next falling edge VDD/2) clock period tj(P) tj(LT) From rising edge next rising edge VDD/2, 10pF From 0-500µs VDD/2, 10pF compared ideal clock source 3.3V; 0.3V 3.0V; 10pF 3.3V; 3.0V 0.3V; 10pF
ISO9001
8.8.00
FS6128-07
Clock Generator with VCXO
Package Information
Table 8-pin SOIC (0.150") Package Dimensions
DIMENSIONS INCHES MIN. 0.061 0.004 0.055 0.013 0.0075 0.189 0.150 0.230 0.010 0.016 MAX. 0.068 0.0098 0.061 0.019 0.0098 0.196 0.157 0.244 0.016 0.035 MILLIMETERS MIN. 1.55 0.102 1.40 0.33 0.191 4.80 3.81 5.84 0.25 0.41 MAX. 1.73 0.249 1.55 0.49 0.249 4.98 3.99 6.20 0.41 0.89
BASE PLANE RADII: 0.005" 0.01"
SEATING PLANE
typ.
0.050
1.27
Table 8-pin SOIC (0.150") Package Characteristics
PARAMETER Thermal Impedance, Junction Free-Air 8-pin 0.150" SOIC Lead Inductance, Self Lead Inductance, Mutual Lead Capacitance, Bulk SYMBOL CONDITIONS/DESCRIPTION flow Corner lead Center lead lead adjacent lead lead TYP. 0.27 UNITS °C/W
ISO9001
8.8.00
FS6128-07
Clock Generator with VCXO
Ordering Information
Table Device Ordering Codes
ORDERING CODE DEVICE NUMBER PACKAGE TYPE 8-pin (0.150") SOIC (Small Outline Package) OPERATING TEMPERATURE RANGE 70°C (Commercial) SHIPPING CONFIGURATION Tape Reel
11640-843
FS6128-07
Copyright 2000 American Microsystems, Inc.
Devices sold covered warranty patent indemnification provisions appearing Terms Sale only. makes warranty, express, statutory implied description, regarding information forth herein regarding freedom described devices from patent infringement. makes warranty merchantability fitness purposes. reserves right discontinue production change specifications prices time without notice. AMI's products intended commercial applications. Applications requiring extended temperature range, unusual environmental requirements, high reliability applications, such military, medical life-support life-sustaining equipment, specifically recommended without additional processing such applications.
American Microsystems, Inc., 2300 Buckskin Rd., Pocatello, 83201, (208) 233-4690, (208) 234-6796, Address: http://www.amis.com E-mail: tgp@amis.com
ISO9001
8.8.00
Other recent searches
SDC5D28 - SDC5D28 SDC5D28 Datasheet
MSM27C1652CZ - MSM27C1652CZ MSM27C1652CZ Datasheet
GVT71256B18 - GVT71256B18 GVT71256B18 Datasheet
CY7C266 - CY7C266 CY7C266 Datasheet
Privacy Policy | Disclaimer
© 2012 Datasheet Archive
