The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.    


Datasheet Search Engine   
 
Part # or Description: • 5V RS232 Driver • 2SC5066* • "Real Time Clock" • "USB connector" • "blue led" 5mm • 10 watt zener diode • 2N3055* motorola
 
Search Tip: Try entering the part number only. Include a wildcard (eg. lm317* or 1n4148*)

 

 

Triacs sensitive gate Glass passivated, sensitive gate triacs ful


Datasheet Thumbnail

  

Download PDF



Top Searches for this datasheet




Triacs sensitive gate
Glass passivated, sensitive gate triacs full pack, plastic envelope, intended general purpose bidirectional switching phase control applications, where high sensitivity required four quadrants.
BT137X series
QUICK REFERENCE DATA
SYMBOL VDRM IT(RMS) ITSM PARAMETER BT137XRepetitive peak off-state voltages on-state current Non-repetitive peak on-state current MAX. MAX. MAX. UNIT 500E 600E 800E
PINNING SOT186A
DESCRIPTION main terminal
CONFIGURATION
case
SYMBOL
main terminal gate
case isolated
LIMITING VALUES
Limiting values accordance with Absolute Maximum System (IEC 134). SYMBOL VDRM IT(RMS) ITSM PARAMETER Repetitive peak off-state voltages on-state current Non-repetitive peak on-state current fusing Repetitive rate rise on-state current after triggering full sine wave; full sine wave; prior surge 16.7 dIG/dt A/µs GT2- GT2- CONDITIONS MIN. -500 5001 MAX. -600 6001 -800 UNIT A/µs A/µs A/µs A/µs
dIT/dt
PG(AV) Tstg
Peak gate current Peak gate voltage Peak gate power Average gate power Storage temperature Operating junction temperature
over period
Although recommended, off-state voltages 800V applied without damage, triac switch on-state. rate rise current should exceed A/µs. September 1997 1.200
Triacs sensitive gate
ISOLATION LIMITING VALUE CHARACTERISTIC
unless otherwise specified SYMBOL Visol PARAMETER R.M.S. isolation voltage from three terminals external heatsink CONDITIONS 50-60 sinusoidal waveform; R.H. clean dustfree MIN.
BT137X series
TYP.
MAX. 2500
UNIT
Cisol
Capacitance from external heatsink
THERMAL RESISTANCES
SYMBOL j-hs PARAMETER Thermal resistance junction heatsink Thermal resistance junction ambient CONDITIONS full half cycle with heatsink compound without heatsink compound free MIN. TYP. MAX. UNIT
STATIC CHARACTERISTICS
unless otherwise stated SYMBOL PARAMETER Gate trigger current CONDITIONS GT2- GT2- GT2- GT2- MIN. 0.25 TYP. MAX. 1.65 UNIT
Latching current
Holding current On-state voltage Gate trigger voltage Off-state leakage current
VDRM(max);
DYNAMIC CHARACTERISTICS
unless otherwise stated SYMBOL dVD/dt PARAMETER Critical rate rise off-state voltage Gate controlled turn-on time CONDITIONS VDRM(max); exponential waveform; gate open circuit VDRM(max); dIG/dt A/µs; MIN. TYP. MAX. UNIT V/µs
September 1997
1.200
Triacs sensitive gate
BT137X series
Ptot
BT137
Ths(max)
IT(RMS)
BT137X
IT(RMS)
Fig.1. Maximum on-state dissipation, Ptot, versus on-state current, IT(RMS), where conduction angle.
BT137 BT137
Fig.4. Maximum permissible current IT(RMS) versus heatsink temperature Ths.
BT137
1000
ITSM
time
IT(RMS)
initial
limit
quadrant
10us
100us
10ms
100ms
0.01
surge duration
Fig.2. Maximum permissible non-repetitive peak on-state current ITSM, versus pulse width sinusoidal currents, 20ms.
Fig.5. Maximum permissible repetitive on-state current IT(RMS), versus surge duration, sinusoidal currents, 73°C.
VGT(Tj) VGT(25
ITSM
BT137 ITSM time
BT136
initial
Number cycles 50Hz
1000
Fig.3. Maximum permissible non-repetitive peak on-state current ITSM, versus number cycles, sinusoidal currents,
Fig.6. Normalised gate trigger voltage VGT(Tj)/ VGT(25°C), versus junction temperature
September 1997
1.200
Triacs sensitive gate
BT137X series
IGT(Tj) IGT(25
BT137E GT2- GT2-
BT137
1.264 0.0378 Ohms
Fig.7. Normalised gate trigger current IGT(Tj)/ IGT(25°C), versus junction temperature
IL(Tj) IL(25
Fig.10. Typical maximum on-state characteristic.
TRIAC
j-hs (K/W)
BT137
with heatsink compound without heatsink compound unidirectional bidirectional
0.01 10us 0.1ms
10ms
0.1s
Fig.8. Normalised latching current IL(Tj)/ IL(25°C), versus junction temperature
IH(Tj) IH(25C)
Fig.11. Transient thermal impedance j-hs, versus pulse width
dVD/dt (V/us)
TRIAC
1000
Fig.9. Normalised holding current IH(Tj)/ IH(25°C), versus junction temperature
Fig.12. Typical, critical rate rise off-state voltage, dVD/dt versus junction temperature
September 1997
1.200
Triacs sensitive gate
MECHANICAL DATA
Dimensions Mass:
10.3
BT137X series
Recesses (2x) max. depth
15.8 max. max. seating plane 15.8
max. tinned 13.5 min.
(2x) 2.54
5.08
Fig.13. SOT186A; seating plane electrically isolated from terminals.
Notes Refer mounting instructions F-pack envelopes. Epoxy meets UL94 1/8".
September 1997
1.200
Triacs sensitive gate
DEFINITIONS
Data sheet status Objective specification Product specification Limiting values
BT137X series
This data sheet contains target goal specifications product development. This data sheet contains final product specifications.
Preliminary specification This data sheet contains preliminary data; supplementary data published later.
Limiting values given accordance with Absolute Maximum Rating System (IEC 134). Stress above more limiting values cause permanent damage device. These stress ratings only operation device these other conditions above those given Characteristics sections this specification implied. Exposure limiting values extended periods affect device reliability. Application information Where application information given, advisory does form part specification. Philips Electronics N.V. 1997 rights reserved. Reproduction whole part prohibited without prior written consent copyright owner. information presented this document does form part quotation contract, believed accurate reliable changed without notice. liability will accepted publisher consequence use. Publication thereof does convey imply license under patent other industrial intellectual property rights.
LIFE SUPPORT APPLICATIONS
These products designed life support appliances, devices systems where malfunction these products reasonably expected result personal injury. Philips customers using selling these products such applications their risk agree fully indemnify Philips damages resulting from such improper sale.
September 1997
1.200

Other recent searches


SED1640 - SED1640   SED1640 Datasheet
SED1651 - SED1651   SED1651 Datasheet
SED1635 - SED1635   SED1635 Datasheet
KDZ36B - KDZ36B   KDZ36B Datasheet
FM24CL64 - FM24CL64   FM24CL64 Datasheet
DIP-40 - DIP-40   DIP-40 Datasheet
APT6029BLL - APT6029BLL   APT6029BLL Datasheet
APT6029SLL - APT6029SLL   APT6029SLL Datasheet

 

Privacy Policy | Disclaimer
© 2012 Datasheet Archive