Voltage Axial Flow Fans Micro Slim Deep Features: 40mm micro

The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.

Voltage Axial Flow Fans Micro Slim Deep Features: 40mm micro

Datasheet Thumbnail

Top Searches for this datasheet

GM0500PEV Series
Voltage Axial Flow Fans
Micro Slim Deep Features:
40mm micro slim fans. Ideally precision cooling compact equipment. Patented single-coil brushless pole motor. Locked rotor protection. Precision ball bearings.
Characteristics:
Motor design Insulation resistance Dielectric strength Noise level Input power, current speed Tolerance performance Patented single-coil brushless pole motor design. More than 500M between internal stator lead wire(+) measured 500V. Applied 500V minute 600V seconds between housing lead wire(+). Measured semi-anechoic chamber with background noise level below 15db(A). running free with microphone distance meter from intake. Measured after continuous minute operation rated voltage clean air, ambient temperature 25°C. ±15% rated power current. Measured double chamber. values recorded when speed stabilized rated voltage.
Specifications:
Rated voltage Operating voltage range Starting voltage Direction rotation Operating temperature Storage temperature Bearing system Vibration (25°C Power On/Off). Counter-clockwise viewed from front blade. +70°C. +70°C. Vapo bearing system. Vibration acceleration 1.5G frequency 5~50~5Hz applied directions cycles minute each, total vibration time minutes.
Material:
Frame Impeller Bobbin Lead Wire Thermoplastic PBT. Thermoplastic PBT. Thermoplastic PBT. 28AWG, +Red, -Black.
Page
24/04/06 V1.0
GM0500PEV Series
Voltage Axial Flow Fans
GM0502PEV1-8.N.GN: Rated speed delivery Static pressure Rated current Rated power Noise level 13,000RPM ±20%. 3.0CFM. 0.22 inch-H2O. 0.11 Amp. watts. 31db(A).
Performance Curves
Static Pressure GM0502PEV1-8.N.GN
Page
24/04/06 V1.0
GM0500PEV Series
Voltage Axial Flow Fans
Dimensions
GM0502PEV1-8.N.GN
flow direction Best mounting direction
Toward label side. orientation.
Specifications:
GM0502PEV2-8.N.GN: Rated speed delivery Static pressure Rated current Rated power Noise level 10,000RPM ±30%. 2.2CFM. 0.16 inch-H2O. 0.08 Amp. watts. 23db(A).
Page
24/04/06 V1.0
GM0500PEV Series
Voltage Axial Flow Fans
Performance Curves
Static Pressure GM0502PEV2-8.N.GN
Page
24/04/06 V1.0
GM0500PEV Series
Voltage Axial Flow Fans
Dimensions
GM0502PEV2-8.N.GN
flow direction Best mounting direction
Toward label side. orientation.
Specifications:
GM0503PEV1-8.N.GN: Rated speed delivery Static pressure Rated current Rated power Noise level 9500RPM ±30%. 4.9CFM. 0.14 inch-H2O. 0.13 Amp. watts. 28db(A).
Page
24/04/06 V1.0
GM0500PEV Series
Voltage Axial Flow Fans
Performance Curves
Static Pressure GM0503PEV1-8.N.GN
Page
24/04/06 V1.0
GM0500PEV Series
Voltage Axial Flow Fans
Dimensions
GM0503PEV1-8.N.GN
flow direction Best mounting direction
Toward label side. orientation.
Specifications:
GM0503PEV2-8.N.GN: Rated speed delivery Static pressure Rated current Rated power Noise level 7500RPM ±30%. 3.7CFM. 0.09 inch-H2O. 0.08 Amp. watts. 24db(A).
Page
24/04/06 V1.0
GM0500PEV Series
Voltage Axial Flow Fans
Performance Curves
Static Pressure GM0503PEV2-8.N.GN
Page
24/04/06 V1.0
GM0500PEV Series
Voltage Axial Flow Fans
Dimensions
GM0503PEV2-8.N.GN
flow direction Best mounting direction
Toward label side. orientation.
Specifications:
GM0503PEV2-8.N.GN: Rated speed delivery Static pressure Rated current Rated power Noise level 7000RPM ±30%. 5.9CFM. 0.10 inch-H2O. 0.09 Amp. watts. 32db(A).
Page
24/04/06 V1.0
GM0500PEV Series
Voltage Axial Flow Fans
Performance Curves
Static Pressure GM0504PEV1-8.GN
Page
24/04/06 V1.0
GM0500PEV Series
Voltage Axial Flow Fans
Dimensions
GM0504PEV1-8.GN
flow direction Best mounting direction
Toward label side. orientation.
Specifications:
GM0504PEV2-8.GN: Rated speed delivery Static pressure Rated current Rated power Noise level 6000RPM ±30%. 5.5CFM. 0.08 inch-H2O. 0.07 Amp. watts. 26db(A).
Page
24/04/06 V1.0
GM0500PEV Series
Voltage Axial Flow Fans
Performance Curves
Static Pressure GM0504PEV2-8.GN
Page
24/04/06 V1.0
GM0500PEV Series
Voltage Axial Flow Fans
Dimensions
flow direction Best mounting direction
Toward label side. orientation.
Notes:
Safety: There thermo-protector installed this product, such thermo-fuse, current-fuse, thermo-protector. There smoking, ignition, electric shock insulation degradation cases motor lock, motor lead short circuit, overload, over voltage, and/or other failure. Please protection circuit your product. There reverse-connection prevention diode installed this product. Therefore, reverse connected, cause smoking, ignition, and/or destruction, although these conditions manifest immediately. recommended that protection device installed your product when there possibility reverse connection. Please verify that this product being installed used compliance with safety standards. Please handle install this product carefully. Hitting dropping this product this cause damage. Please donot damage this product including coil lead wires while installing wiring. There smoking fire. Other: When building your device, please examine thoroughly variation EMC, temperature rise, life data, quality, etc. this product shock/drop/vibration testing, etc. there problems accidents connection with this product, should mutually discussed examined. holders bearings damaged touched with fingers other objects. Additionally, static electricity (ESD) cause damage internal circuits. Please handle this product carefully.
Page
24/04/06 V1.0
GM0500PEV Series
Voltage Axial Flow Fans
Other: Please avoid operating this product poisonous material (organic silicon, cyanogens, formalin, phenol, etc.) corrosive environments (H2S, SO2, NO2, Cl2, etc). Improper mounting cause harsh resonance, vibration, noise. Please mount securely. Safety priority. Please furnish guard accessories prevent injury personnel. Unless otherwise noted, tests conducted 25°C ambient temperature relative humidity. Always ensure that fans stored according storage temperatures specified. Donot store high humidity environment. fans stored more than months, with functional testing recommended before use. This reserves right components with equivalent specifications from multiple sources.
Specification Table
Type Standard,25mm Noise, 25mm Standard,30mm Noise,30mm Standard,40mm Noise,40mm Voltage Power (Watts) Flow ft/min ltrs/sec 0.76 0.57 1.43 1.15 2.07 Noise (dBA Dimension Part Number GM0502PEV1-8.N.GN GM0502PEV2-8.N.GN GM0503PEV1-8.N.GN GM0503PEV2-8.N.GN GM0504PEV1-8.GN GM0504PEV2-8.GN
Dimensions Millimetres (Unless Specified)
Page
24/04/06 V1.0
GM0500PEV Series
Voltage Axial Flow Fans
Notes:
International Sales Offices:
AUSTRALIA Farnell InOne
9645 8888 9644 7898
FINLAND Farnell InOne
7780 5411
NETHERLANDS Farnell InOne
7373 7333
SWITZERLAND Farnell InOne
AUSTRIA Farnell InOne
2180 2180
FRANCE Farnell InOne
ZEALAND Farnell InOne
0646 0656
Farnell InOne
8701 8701
BELGIUM Farnell InOne
2810 3648
GERMANY Farnell InOne
NORWAY Farnell InOne
BuckHickman InOne
8450 8450
BRAZIL Farnell-Newark InOne
4066 9400 4066 9410
HONG KONG Farnell-Newark InOne 2268 9888
2268 9899
PORTUGAL Farnell InOne
8804 5288
8701 8701
CHINA Farnell-Newark InOne
++86 6238 5152 ++86 6238 5022
IRELAND Farnell InOne
9277 9016
SINGAPORE
Farnell-Newark InOne 6788 0200
export
EXPORT Farnell InOne
8701 8701
6788 0300
enquiries from other markets
DENMARK Farnell InOne
ITALY Farnell InOne
SPAIN Farnell InOne
8805 5107
http://www.farnellinone.com
ESTONIA Farnell InOne
7780 5411
Farnell-Newark InOne 7873 8000 7873 7000
MALAYSIA
SWEDEN Farnell InOne
http://www.buckhickmaninone.com http://www.cpc.co.uk
Disclaimer This data sheet contents (the "Information") belong Premier Farnell Group (the "Group") licensed licence granted other than information purposes connection with products which relates. licence intellectual property rights granted. Information subject change without notice replaces data sheets previously supplied. Information supplied believed accurate Group assumes responsibility accuracy completeness, error omission from made Users this data sheet should check themselves Information suitability products their purpose make assumptions based information included omitted. Liability loss damage resulting from reliance Information (including liability resulting from negligence where Group aware possibility such loss damage arising) excluded. This will operate limit restrict Group's liability death personal injury resulting from negligence. Multicomp registered trademark Group. Premier Farnell 2004.
Page
24/04/06 V1.0

Voltage Axial Flow Fans Micro Slim Deep Features: 40mm micro

Top Searches for this datasheet

Other recent searches