Bulletin I25162/B ST230C.C SERIES PHASE CONTROL THYRISTORS H

The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.

Bulletin I25162/B ST230C.C SERIES PHASE CONTROL THYRISTORS H

Datasheet Thumbnail

Top Searches for this datasheet

Bulletin I25162/B
ST230C.C SERIES
PHASE CONTROL THYRISTORS Hockey Version
410A
Features
Center amplifying gate Metal case with ceramic insulator International standard case TO-200AB (A-PUK)
Typical Applications
motor controls Controlled power supplies controllers
Major Ratings Characteristics
Parameters
IT(AV) IT(RMS) ITSM 50Hz 60Hz 50Hz 60Hz typical
case style TO-200AB (A-PUK)
Units
KA2s KA2s
ST230C.C
5700 5970 1600
Order
ST230C.C Series
ELECTRICAL SPECIFICATIONS Voltage Ratings
Voltage Type number Code
ST230C.C
max. repetitive peak off-state voltage
1200 1400 1600
VRSM maximum nonrepetitive peak voltage
1300 1500 1700
max.
On-state Conduction
Parameter
T(AV) Max. average on-state current Heatsink temperature T(RMS) Max. on-state current Max. peak, one-cycle non-repetitive surge current
ST230C.C
(165) (85) 5700 5970 4800 5000
Units Conditions
180° conduction, half sine wave double side (single side) cooled 25°C heatsink temperature double side cooled 10ms 8.3ms 10ms 8.3ms 10ms KA2s 8.3ms 10ms 8.3ms
voltage reapplied 100% VRRM reapplied voltage reapplied 100% VRRM reapplied Sinusoidal half wave, Initial max.
Maximum fusing
Maximum fusing
1630 0.92
10ms, voltage reapplied (16.7% T(AV) IT(AV)), max.
T(TO)1 level value threshold voltage T(TO)2 High level value threshold voltage level value on-state slope resistance High level value on-state slope resistance Max. on-state voltage Maximum holding current Max. (typical) latching current
0.98 IT(AV)),TJ max. (16.7% IT(AV) IT(AV) max. 0.81 1.69 1000 (300) 25°C, anode supply resistive load IT(AV) ),TJ max. Ipk= 880A, max, 10ms sine pulse
0.88
Switching
Parameter
di/dt Max. non-repetitive rate rise turned-on current
ST230C.C
1000
Units Conditions
A/µs Gate drive 20V, max, anode voltage VDRM Gate current 1A/µs 0.67% VDRM, 25°C 300A, max, di/dt 20A/µs, dv/dt 20V/µs, Gate 100, 500µs
Typical delay time Typical turn-off time
Order
ST230C.C Series
Blocking
Parameter
dv/dt IDRM IRRM Maximum critical rate rise Max. peak reverse off-state leakage current
ST230C.C
off-state voltage
Units Conditions
V/µs max. linear rated VDRM max, rated applied
Triggering
Parameter
Maximum peak gate power
ST230C.C
10.0
Units Conditions
max, max, 50Hz, max,
PG(AV) Maximum average gate power +VGM -VGM Max. peak positive gate current Maximum peak positive gate voltage Maximum peak negative gate voltage TYP. gate current required trigger gate voltage required trigger gate current trigger gate voltage trigger
MAX. 0.25
max,
40°C 25°C 125°C 40°C 25°C 125°C Max. gate current/voltage trigger max. value which will trigger unit with rated VDRM anode-to-cathode applied Max. required gate trigger/ current/ voltage lowest value which will trigger units anode-to-cathode applied
Thermal Mechanical Specification
Parameter
Tstg Max. operating temperature range Max. storage temperature range
ST230C.C
0.17 0.08 0.033 0.017 4900 (500)
Units Conditions
operation single side cooled operation double side cooled operation single side cooled operation double side cooled (Kg) Outline Table
thJ-hs Max. thermal resistance, junction heatsink RthC-hs Max. thermal resistance, case heatsink Mounting force,
Approximate weight Case style
200AB (A-PUK)
Order
ST230C.C Series
RthJ-hs Conduction
(The following table shows increment thermal resistence RthJ-hs when devices operate different conduction angles than
Conduction angle
180° 120°
Sinusoidal conduction Rectangular conduction
Single Side Double Side 0.015 0.018 0.024 0.035 0.060 0.017 0.019 0.024 0.035 0.060 Single Side Double Side 0.011 0.019 0.026 0.036 0.060 0.011 0.019 0.026 0.037 0.061
Units
Conditions
max.
Ordering Information Table
Device Code
Thyristor Essential part number Converter grade Ceramic Voltage code: Code VRRM (See Voltage Rating Table) Case TO-200AB (A-PUK) Eyelet terminals (Gate Auxiliary Cathode Unsoldered Leads) Fast-on terminals (Gate Auxiliary Cathode Unsoldered Leads) Eyelet terminals (Gate Auxiliary Cathode Soldered Leads) Fast-on terminals (Gate Auxiliary Cathode Soldered Leads)
Critical dv/dt: None 500V/µsec (Standard selection) 1000V/µsec (Special selection)
Order
ST230C.C Series
Outline Table
ANODE GATE CREEPAGE DISTANCE: 7.62 (0.30) MIN. STRIKE DISTANCE: 7.12 (0.28) MIN. (0.75) DIA. MAX. (0.01) MIN. 13.7 14.4 (0.54 0.57) (0.01) MIN. (0.75) DIA. MAX. (1.50) MAX. GATE TERM. 1.47 (0.06) DIA. RECEPTACLE
Case Style TO-200AB (A-PUK)
HOLES 3.56 (0.14) 1.83 (0.07) MIN. DEEP (0.26) 4.75 (0.19)
dimensions millimeters (inches)
25°±
(1.65) MAX. (1.10)
Maximum Allowable Heatsink emperature (°C)
Average On-state Current Fig. Current Ratings Characteristics
Conduction Angle
Maximum Allowable Heatsink emperature (°C)
T230C.C eries ingle Cooled) RthJ-hs (DC) 0.17
230C.C eries ingle Cooled RthJ-hs (DC) 0.17
Conduction Period
120° 180°
120° 180°
Average On-state Current Fig. Current Ratings Characteristics
Order
ST230C.C Series
Maximum Allowable Heats emperature (°C) Average On-state Current Fig. Current Ratings Characteristics Maximum Average On-s tate Power 1100 1000 Averag On-s tate Current Fig. On-state Power Loss Characteristics 230C.C eries 125°C
Conduction Angle Cond uction Angle
Maximum Allowable Heats emperature (°C)
230C.C eries (Double Cooled) thJ-hs (DC) 0.08
230C.C eries (Double Cooled) thJ-hs (DC) 0.08
Conduction Period
120° 180°
120° 180°
Average On-state Current Fig. Current Ratings Characteristics
Maximum Avera On-state Power
1400 1200 1000
Conduction Period
180° 120°
RMSLimit
180° 120° Limit
Average On-state Current Fig. On-state Power Loss Characteristics 230C.C Series 125°C
Peak Half Wave On-s tate Current
5000 4500 4000 3500 3000
ated Load Condition With Rated VRRM Applied Following Initial 125°C 0.0083 0.0100
Peak Half Wave On-s tate Current
5500
6500 6000
Maximum Repetitive urge Current Versus Pulse rain Duration. Control Conduction Maintained. 5500 Initial 125°C Voltage Reapplied 5000 ated Reapplied 4500 4000 3500 3000 2500 230C.C eries Puls rain Duration
eries 2500 230C.C 2000
Number Equa Amplitude Half Current Pulses
2000 0.01
Fig. Maximum Non-Repetitive Surge Current Single Double Side Cooled
Order
Fig. Maximum Non-Repetitive Surge Current Single Double Side Cooled
ST230C.C Series
10000 Instantaneous On-state Current
25°C 125°C 1000
230C.C eries
Instantaneous On-state Voltage Fig. On-state Voltage Drop Characteristics nsien hermal thJ-hs thJ-hs 0.17 (Single thJ-hs 0.08 (Doub oled tion)
0.01 230C.C Series
0.001 0.001
0.01
uare Pulse Duration
Fig. Thermal Impedance thJ-hs Characteristics Instantaneous Gate Voltage tangular gate pulse ecommended load line rated di/dt 20V, 10ohms tr<=1 ommended load line <=30% rated 10V, 10ohms tr<=1
j=-40
10W, 20W, 40W, 60W,
0.66ms
j=25
j=125
0.001 0.01
Devic 230C.C eries
Frequenc imited PG(AV)
Instantaneous Gate Current Fig. Gate Characteristics
Order

Bulletin I25162/B ST230C.C SERIES PHASE CONTROL THYRISTORS H

Top Searches for this datasheet

Other recent searches