±6000V Pulse Output

The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.

Datasheet Thumbnail

Top Searches for this datasheet

PVX-4130 000V PULSE GENERATOR
±6000V Pulse Output <60ns Rise Fall Times <150ns Pulse Width >10KHz Pulse Repetition Frequency Optimized Drive Deflection Plates, Grids Other Capacitive Loads Protected Against Arcs, Shorts Load Transients Voltage Current Monitor Outputs
PVX-4130 pulse generator produces fast, high voltage wave forms 6,000V. Optimized high impedance capacitive loads, PVX-4130 well suited driving extraction grids deflection plates electrostatic modulation particle beams time-of -flight mass spectrometers accelerators. robust versatile design also makes well suited pulsing gating power tube grids, Pockels cells Switches, acoustic transducers, microchannel plates, photomultiplier tubes image intensifiers. exceptional pulse fidelity PVX-4130 will optimize performance system which used. PVX-4130 generates output voltage pulse 6,000 volts with rise fall times less than 60ns, with very flat voltage pulses into capacitive load. generate singled-ended output pulses from ground +6000V from ground -6000V, also generate pulses originating from voltage offset from ground using both VLow VHigh power supply inputs. This offset from -6000V +6000V, with maximum power supply voltage differential 6000V. PVX-4130 requires gate signal, high voltage power supply optional offset supply inputs. output pulse width frequency controlled gate signal. pulse output voltage controlled amplitude input power supplies. When input gate high, VHIGH supply connected output. When input gate low, VLOW supply
connected output. Therefore PVX-4130 used generate negative-going pulse logically inverting input gate, that input gate high until unit pulsed. When input gate goes low, VLOW input supply connected output, thereby generating negative-going pulse. PVX-4130 features front panel indicator LEDs monitor status pulse generator. Front panel voltage current monitors provide straightforward means view output voltage current waveforms real-time, eliminating need external high voltage oscilloscope probe. pulse generator direct-coupled, air-cooled solidstate half-bridge (totem pole) design, offering equally fast pulse rise fall times, power dissipation, virtually over-shoot, under-shoot ringing. over-current detection shut-down circuitry protect pulse generator from potential damage arcs shorts load interconnect cable. control protection logic circuitry, support power, energy storage output network incorporated into PVX-4130. connected directly load, does require series shunt resistors, impedance-matching networks between pulser load, additional energy storage (capacitor banks). this taken care within PVX-4130.
DIRECTED ENERGY INCORPORATED
SPECIFICATIONS (All specifications measured into 50pF load connected with feet (~1.2m) RG-58 (50) coaxial cable)
OUTPUT Maximum Value: Minimum Value: Means Adjustment: Pulse Rise Fall Time: Pulse Width: Pulse Recurrence Frequency (PRF): Max. Average Power: Max. Duty Cycle: Droop: Over/undershoot: Throughput Delay Jitter: Output Connector Cable: ±6000 Volts High VLow) Volts Controlled Power Supply Input Voltages <60ns, typically <52ns (10% 90%) <150ns Controlled Input Gate Single shot 10KHz 6000V continuous output, maximum limited power dissipation 100W High VLow), derated 2W/°C over 25°C ambient Continuous 160ns Typical <1ns shot-to-shot Kings 10KV, Rear Panel, With feet (~1.2M) RG-58 (50) Coaxial Cable
45ns Rise Time, 6000V Output
(25ns/Div horizontal scale, 1.2kV/Div vertical scale)
INPUT VOLTAGE +VIN High Absolute Max. Value: +6000 Volts Absolute Min. Value: -6000 Volts Relative Max. Value: +6000 Volts over VLow Voltage Relative Min. Value: Over VLow Voltage INPUT VOLTAGE -VIN Absolute Max. Value: +6000 Volts Absolute Min. Value: -6000 Volts Input Connectors: GATE Gate Source Connector Kings 10KV, Rear Panel (One each +VIN -VIN into into connector front panel
125ns Minimum Pulse Width, 6000V Output
(25ns/Div horizontal scale, 1.2kV/Div vertical scale)
VOLTAGE CURRENT MONITORS Voltage Monitor: 2000:1 into connector Current Monitor: 10A/V into connector GENERAL Support Power: 90VAC 240VAC, 50/60Hz
Typical Output Waveform, 6000V Output
(2.5µs/Div horizontal scale, 1.2kV/Div vertical scale)
Dimensions (Excluding Con- 19"W 5.2"H 16"D (48.25cm 13.2cm nectors): 41cm Weight (Approximate): lbs. (8.2 Kilograms)
SPECIFICATIONS SUBJECT CHANGE WITHOUT NOTICE
These specifications measured driving 50pF load connected with feet RG-58 cable, 6000V output. However PVX-4130 drive loads picofarads several hundred picofarads capacitance, limited maximum power dissipation capability lower load capacitances and/or voltages less then 6000V, PVX-4130 operate continuous pulse recurrence frequencies above 10KHz. PVX-4130 also drive resistive inductive loads, within limitations. Contact additional information applications assistance. power dissipated PVX-4130 when driving capacitive load defined formula CV2F, where total load capacitance, including capacitance load, interconnect cable, internal capacitance PVX-4130, pulse voltage, pulse repetition frequency total pulses second). (For these calculations, internal capacitance PVX-4130 100pF, RG-58 cable 30pf/foot.) Given maximum dissipation 100W, maximum load capacitance, frequency and/or voltage which PVX-4130 operate approximated using this formula. This formula also approximates high voltage power supply requirements needed drive given load specific voltage frequency. This formula applicable when driving resistive inductive loads.
10KHz Repetition Frequency, 6000V Output
(50µs/Div horizontal scale, 1.2kV/Div vertical scale)
#9200 -0215 Directed Energy, Inc. 2000
Directed Energy, Inc. IXYS Company 2401 Research Blvd., Suite Fort Collins, 80526 970-493- 1901 Fax: 970-493-1903 Email: deiinfo@directedenergy.com Web: http://www.directedenergy.com

±6000V Pulse Output

Top Searches for this datasheet

Other recent searches