Output Ports Have Series Resistors, External Resistors Required State-

The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.

Output Ports Have Series Resistors, External Resistors Required State-

Datasheet Thumbnail

Top Searches for this datasheet

SN54ABT5402, SN74ABT5402 12-BIT LINE/MEMORY DRIVERS WITH 3-STATE OUTPUTS
Output Ports Have Series Resistors, External Resistors Required State-of-the-Art EPIC-B BiCMOS Design Significantly Reduces Power Dissipation Latch-Up Performance Exceeds JEDEC Standard JESD-17 Typical VOLP (Output Ground Bounce) 25°C Typical VOLV (Output Undershoot) 25°C Package Options Include Plastic Small-Outline (DW) Packages, Ceramic Chip Carriers (FK) DIPs (JT)
SN54ABT5402 PACKAGE SN74ABT5402 PACKAGE (TOP VIEW)
description
These 12-bit buffers line drivers designed specifically improve both performance density 3-state memory address drivers, clock drivers, bus-oriented receivers transmitters. 3-state control gate 2-input gate with active-low inputs that either output-enable (OE1 OE2) input high, outputs high-impedance state. outputs, which designed source sink include series resistors reduce overshoot undershoot. ensure high-impedance state during power power down, should tied through pullup resistor; minimum value resistor determined current-sinking capability driver. SN54ABT5402 characterized operation over full military temperature range 55°C 125°C. SN74ABT5402 characterized operation from 40°C 85°C.
FUNCTION TABLE INPUTS OUTPUT
SN54ABT5402 PACKAGE (TOP VIEW)
EPIC-B trademark Texas Instruments Incorporated.
UNLESS OTHERWISE NOTED this document contains PRODUCTION DATA information current publication date. Products conform specifications terms Texas Instruments standard warranty. Production processing does necessarily include testing parameters. POST OFFICE 655303
DALLAS, TEXAS 75265
Copyright 1994, Texas Instruments Incorporated
SN54ABT5402, SN74ABT5402 12-BIT LINE/MEMORY DRIVERS WITH 3-STATE OUTPUTS
logic symbol
logic diagram (positive logic)
Other Channels
This symbol accordance with ANSI/IEEE 91-1984 Publication 617-12. numbers shown packages.
absolute maximum ratings over operating free-air temperature range (unless otherwise noted)
Supply voltage range, Input voltage range, (see Note Voltage range applied output high state power-off state, Current into output state, Input clamp current, Output clamp current, Maximum power dissipation 55°C still air) (see Note package Storage temperature range 65°C 150°C
Stresses beyond those listed under "absolute maximum ratings" cause permanent damage device. These stress ratings only, functional operation device these other conditions beyond those indicated under "recommended operating conditions" implied. Exposure absolute-maximum-rated conditions extended periods affect device reliability. NOTES: input output negative-voltage ratings exceeded input output clamp-current ratings observed. maximum package power dissipation calculated using junction temperature 150°C board trace length mils. more information, refer Package Thermal Considerations application note 1994 Advanced BiCMOS Technology Data Book, literature number SCBD002B.
POST OFFICE 655303
DALLAS, TEXAS 75265
SN54ABT5402, SN74ABT5402 12-BIT LINE/MEMORY DRIVERS WITH 3-STATE OUTPUTS
recommended operating conditions (see Note
SN54ABT5402 Supply voltage High-level input voltage Low-level input voltage Input voltage High-level output current Low-level output current Input transition rise fall rate Outputs enabled SN74ABT5402 UNIT
Operating free-air temperature NOTE Unused floating inputs must held high low.
electrical characteristics over recommended operating free-air temperature range (unless otherwise noted)
PARAMETER IOZH IOZL Ioff ICEX TEST CONDITIONS Outputs high Outputs high input Other inputs Outputs Outputs disabled Outputs enabled Data inputs Outputs disabled Control inputs 0.05 0.05 0.05 3.35 3.85 ±100 -100 -100 25°C -1.2 SN54ABT5402 -1.2 3.35 3.85 0.65 ±100 -100 SN74ABT5402 -1.2 UNIT
typical values more than output should tested time, duration test should exceed second. This increase supply current each input that specified voltage level rather than GND.
PRODUCT PREVIEW information concerns products formative design phase development. Characteristic data other specifications design goals. Texas Instruments reserves right change discontinue these products without notice.
POST OFFICE 655303
DALLAS, TEXAS 75265
SN54ABT5402, SN74ABT5402 12-BIT LINE/MEMORY DRIVERS WITH 3-STATE OUTPUTS
switching characteristics over recommended ranges supply voltage operating free-air temperature, (unless otherwise noted) (see Figure
PARAMETER tPLH tPHL tPZH tPZL tPHZ tPLZ FROM (INPUT) (OUTPUT) 25°C SN54ABT5402 SN74ABT5402 UNIT
PRODUCT PREVIEW information concerns products formative design phase development. Characteristic data other specifications design goals. Texas Instruments reserves right change discontinue these products without notice.
POST OFFICE 655303
DALLAS, TEXAS 75265
SN54ABT5402, SN74ABT5402 12-BIT LINE/MEMORY DRIVERS WITH 3-STATE OUTPUTS
PARAMETER MEASUREMENT INFORMATION
From Output Under Test (see Note Open TEST tPLH/tPHL tPLZ/tPZL tPHZ/tPZH Open Open
LOAD CIRCUIT OUTPUTS Timing Input Input VOLTAGE WAVEFORMS PULSE DURATION VOLTAGE WAVEFORMS SETUP HOLD TIMES Data Input
Input (see Note tPLH Output
tPHL tPHL tPLH
Output Control tPZL Output Waveform (see Note Output Waveform Open (see Note tPZH
tPLZ tPHZ
Output
VOLTAGE WAVEFORMS PROPAGATION DELAY TIMES INVERTING NONINVERTING OUTPUTS
VOLTAGE WAVEFORMS ENABLE DISABLE TIMES LOW- HIGH-LEVEL ENABLING
NOTES: includes probe capacitance. input pulses supplied generators having following characteristics: MHz, Waveform output with internal conditions such that output except when disabled output control. Waveform output with internal conditions such that output high except when disabled output control. outputs measured time with transition measurement.
Figure Load Circuit Voltage Waveforms
POST OFFICE 655303
DALLAS, TEXAS 75265
SN54ABT5402, SN74ABT5402 12-BIT LINE/MEMORY DRIVERS WITH 3-STATE OUTPUTS
POST OFFICE 655303
DALLAS, TEXAS 75265
IMPORTANT NOTICE Texas Instruments subsidiaries (TI) reserve right make changes their products discontinue product service without notice, advise customers obtain latest version relevant information verify, before placing orders, that information being relied current complete. products sold subject terms conditions sale supplied time order acknowledgement, including those pertaining warranty, patent infringement, limitation liability. warrants performance semiconductor products specifications applicable time sale accordance with TI's standard warranty. Testing other quality control techniques utilized extent deems necessary support this warranty. Specific testing parameters each device necessarily performed, except those mandated government requirements. CERTAIN APPLICATIONS USING SEMICONDUCTOR PRODUCTS INVOLVE POTENTIAL RISKS DEATH, PERSONAL INJURY, SEVERE PROPERTY ENVIRONMENTAL DAMAGE ("CRITICAL APPLICATIONS"). SEMICONDUCTOR PRODUCTS DESIGNED, AUTHORIZED, WARRANTED SUITABLE LIFE-SUPPORT DEVICES SYSTEMS OTHER CRITICAL APPLICATIONS. INCLUSION PRODUCTS SUCH APPLICATIONS UNDERSTOOD FULLY CUSTOMER'S RISK. order minimize risks associated with customer's applications, adequate design operating safeguards must provided customer minimize inherent procedural hazards. assumes liability applications assistance customer product design. does warrant represent that license, either express implied, granted under patent right, copyright, mask work right, other intellectual property right covering relating combination, machine, process which such semiconductor products services might used. TI's publication information regarding third party's products services does constitute TI's approval, warranty endorsement thereof.
Copyright 1998, Texas Instruments Incorporated

Output Ports Have Series Resistors, External Resistors Required State-

Top Searches for this datasheet

Other recent searches