(For frequencies this package please ACT39/38A) ACT38 miniature c

The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.

(For frequencies this package please ACT39/38A) ACT38 miniature c

Datasheet Thumbnail

Top Searches for this datasheet

ACT38
(For frequencies this package please ACT39/38A)
ACT38 miniature cylindrical package offering high vibration shock resistance together with high stability. most suitable portable equipment close packing density. series offers wide, frequency range popular Microprocessor, Consumer Instrumentation applications
Specification
Parameter
Frequency Range Frequency Tolerance @25°C Turnover Temperature Freq. Temp. coefficient Temp Operating Range Temp Storage Range Equivalent Series Resistance Shunt Capacitance Load Capacitance Motional Capacitance Drive Level Factor Insulation Resistance Aging Symbol f/fo Topr Tstg
Specification
30.00 100KHz ±20ppm typical 100ppm available) 25°C ±5°C -0.034 0.005ppm +60°C +85°C 20~40K 1.8pF 12.5pF (Others available.) 3.0fF typical 60,000 typical 500M ±5ppm
Condition
Please specify
25°C Please specify Typical
25°C ±3°C
DIMENSIONS (mm)
Please note that parameters necessarily specified same device
Customer Specify Frequency, Frequency Tolerance, Operating Temperature Range Load Capacitance line with ongoing policy product evolvement improvement, above specification subject change without notice.
ISO9001: 2000 Registered
quotations further information please contact Business Centre, Molly Millars Lane, Wokingham, Berks, RG41 2EY,
http://www.actcrystals.com
Issue Date 07/09/04
ACT38
SOLDERING CYLINDER CRYSTALS
Lead wire should soldered within 10seconds with iron having temperature less than 270°C. must exceed 150°C With regard wave soldering recommended that process carried with crystal unit upright circuit board. Should process carried with crystal unit side then steps must taken prevent heat transfer through can. Should whole crystal unit heated re-flow oven example) will result amarked deterioration performance even failure oscillate. This internal construction crystal unit which involves solder.
Please note that parameters necessarily specified same device
Customer Specify Frequency, Frequency Tolerance, Operating Temperature Range Load Capacitance line with ongoing policy product evolvement improvement, above specification subject change without notice.
ISO9001: 2000 Registered
quotations further information please contact Business Centre, Molly Millars Lane, Wokingham, Berks, RG41 2EY,
http://www.actcrystals.com
Issue Date 07/09/04

(For frequencies this package please ACT39/38A) ACT38 miniature c

Top Searches for this datasheet

Other recent searches