AMP. Surface Mount Super Fast Rectifiers surface mounted applicat

The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.

AMP. Surface Mount Super Fast Rectifiers surface mounted applicat

Datasheet Thumbnail

Top Searches for this datasheet

ES1AL ES1JL
AMP. Surface Mount Super Fast Rectifiers
surface mounted application profile package power loss, high efficiency, Ideal automated placement Glass passivated chip junction High temperature soldering: 260OC/10 seconds terminals
Mechanical Data
Cases: plastic case Terminal Pure plated, lead free. Polarity: Color band cathode Packing: 12mm tape RS-481 Weight: approx. 15mg Marking: below table
Dimensions inches (millimeters)
Maximum Ratings Electrical Characteristics
Rating ambient temperature unless otherwise specified. Single phase, half wave, resistive inductive load. capacitive load, derate current Symbol Type Number Maximum Recurrent Peak Reverse Voltage VRRM
Maximum Voltage Maximum Blocking Voltage Marking Code Maximum Average Forward Rectified Current Fig. Peak Forward Surge Current, Single Half Sine-wave Superimposed Rated Load (JEDEC method Maximum Instantaneous Forward Voltage 1.0A Maximum Reverse Current Rated Blocking Voltage TA=100 Maximum Reverse Recovery Time Note Typical Junction Capacitance Note Maximum Thermal Resistance (Note Operating Temperature Range Storage Temperature Range Notes:
EHLYM
VRMS I(AV) IFSM
Units
EJLYM
0.95 +150 +150
EALYM EBLYM ECLYM EDLYM EFLYM EGLYM
TSTG
Reverse Recovery Test Conditions: IF=0.5A, IR=1.0A, IRR=0.25A Measured Applied VR=4.0 Volts P.C.B. Mounted 0.2" (5.0 5.0mm) Copper Area.
Version:
RATINGS CHARACTERISTIC CURVES (ES1AL THRU ES1JL)
FIG.1- MAXIMUM FORWARD CURRENT DERATING CURVE
Tj=25 PULSE WIDTH-300 DUTY CYCLE
FIG.2- TYPICAL INSTANTANEOUS FORWARD CHARACTERISTICS
AVERAGE FORWARD CURRENT.
INSTANTANEOUS FORWARD CURRENT.
RESISTIVE INDUCTIVE LOAD 0.2X0.2"(5.0X5.0mm) COPPER AREAS
LEAD TEMPERATURE.
FIG.3- MAXIMUM NON-REPETITIVE PEAK FORWARD SURGE CURRENT
PEAK FORWARD SURGE CURRENT.
0.01 8.3ms Single Half Sine Wave (JEDEC Method) TL=120 FORWARD VOLTAGE.
FIG.5- TYPICAL REVERSE CHARACTERISTICS
1000
INSTANTANEOUS REVERSE CURRENT.
NUMBER CYCLES 60Hz
Tj=125
FIG.4- TYPICAL JUNCTION CAPACITANCE
Tj=25 f=1.0MHz Vsig=50mVp-p
Tj=85
JUNCTION CAPACITANCE.(pF)
Tj=25
0.01 PERCENT RATED PEAK REVERSE VOLTAGE.
REVERSE VOLTAGE.
FIG.6- REVERSE RECOVERY TIME CHARACTERISTIC TEST CIRCUIT DIAGRAM
NONINDUCTIVE NONINDUCTIVE +0.5A 50Vdc (approx) PULSE GENERATOR (NOTE INDUCTIVE OSCILLOSCOPE (NOTE -0.25A
NOTES: Rise Time=7ns max. Input Impedance= megohm 22pf Rise Time=10ns max. Sourse Impedance= ohms
-1.0A TIME BASE 10ns/
Version:

AMP. Surface Mount Super Fast Rectifiers surface mounted applicat

Top Searches for this datasheet

Other recent searches