Flat Chip Capacitor/Resistor Type CR73 Scope Application This spe
|
|
|
Top Searches for this datasheet
SS-188
Flat Chip Capacitor/Resistor Type CR73
Scope Application This specification applies flat combined chip CR73 produced Corporation. Rating Capacitor Item Voltage Rating Temperature Coefficient Dissipation Factor Insulation Resistance Dielectric Withstanding Voltage Resistor Item Power Rating Maximum Working Voltage Maximum Overload Voltage Temperature Coefficient Ratings +20%/-55% (-25°C +85°C) maximum vrms) 10,000 Mohms minimum 62.5 sec. 50mA charge sec. charge Environment Item Operation Environment Rating Ambient Temperature
Ratings 0.125 ±200 ppm/C°
Ratings -55°C 125°C 70°C
Type Designation type designation shall following form:
CR73
Type
Size Code 0805 1206
Terminations
Packaging Embossed Plastic
270M/510M
Capacitance/Resistance significant digits number zeros followed tolerance ±20%
PAGE
Bolivar Drive
P.O.
Bradford, 16701
814-362-5536
814-362-8883
www.koaspeer.com
SS-188
Capacitance Range Resistance Range Capacitance Range Capacitance Tolerance Resistance Range Resistance Tolerance 20%) 20%) Capacitance Series Capacitance Range
Resistance Series
Resistance Range ohms ohms ohms ohms
Dimensions Terminals
(unit: 1.25 Dimensions
Circuit Schematic
PAGE
Bolivar Drive
P.O.
Bradford, 16701
814-362-5536
814-362-8883
www.koaspeer.com
SS-188
Structure
Electrode Resistor Layer Glass Layer Epoxy Passivation Barrier Solder Coating
Alumina Ceramic Substrate First Electrode Dielectrios
Outer Coating Color Outer Coating Color (Capacitor Side) Dark blue Outer Coating Color (Resistor Side) Yellow
Test Conditions Unless otherwise specified, test shall performed accordance with JIS-C-5020 specifying temperature 15°C humidity 20%. questions arise about test results, test shall performed temperature humidity
PAGE
Bolivar Drive
P.O.
Bradford, 16701
814-362-5536
814-362-8883
www.koaspeer.com
SS-188
Reliability Test Electrical Characteristics
Item Insulation Resistance Requirement More than Test Methods Within minutes between terminal another
More than
minute between both terminals reverse side
More than
minute between both terminals coating
Dielectric Withstanding Voltage
evidence fuming flaming breakdown
times maximum rated voltage seconds with maximum charging current
Noise (Resistor)
More less 15dB
MIL-STD-202, Method
PAGE
Bolivar Drive
P.O.
Bradford, 16701
814-362-5536
814-362-8883
www.koaspeer.com
SS-188
Mechanical Characteristics
Item Resistance Soldering Heat Requirement evidence damage within ±10% within Approximately terminal should covered with solder mechanical damage Test Methods Immerse solder (H63A) 260°C
Solderability
Immerse solder (H63A) 230°C
Terminal Strength (Bend test)
Specimen shall soldered support applying strength that bending width becomes MIL-R-55342 4.7.12.2 hours each direction X,Y,Z frequency range 10-55-10Hz with 1.5mm amplitude
Terminal Strength (Pull test) Vibration
200g minimum evidence damage within ±10% within
Environmental Characteristics
Item Temperature cycling Requirement evidence damage within ±10% within evidence damage within ±10% within evidence damage within ±10% within Test Methods cycles between 40°C/30 minutes +125°C/30 minutes
Humidity Load)
MIL-STD-202F Method cycles
Moisture Resistance
Temp. 40°C Humidity 1000 hours hours hours Temp. 70°C 1000 hours hours hours
Load Life
evidence damage within ±10% within
PAGE
Bolivar Drive
P.O.
Bradford, 16701
814-362-5536
814-362-8883
www.koaspeer.com
SS-188
Packaging 10.1 Bulk Packaging pieces chip packed poly bag. marking seal shall marked: Type designation Nominal Capacitance/Nominal Resistance Quantity Production Lot. Manufacturer's name
10.2 Taping taping shall embossed carrier tapes width pitches. standard quantity reel shall 4000 pieces. Dimensions Carrier Tape
Direction Mark (Yellow)
Tape Running Direction
Type CR73 CR73
0.05 0.05 0.15 0.85
(unit: 1.75 1.75 0.25 0.25
tape peeling strength:
PAGE
Bolivar Drive
P.O.
Bradford, 16701
814-362-5536
814-362-8883
www.koaspeer.com
SS-188
Reel Dimensions Marking
Marking
Contents label Article Quantity Nominal capacitance/ Nominal resistance Customer's code (Subject change) Production Manufacturer's name (unit:
Type
Tape Embossed Carrier
Quan./Reel (pieces) 4,000
Reel Material Plastic
Pattern Design
Resist
Type
Chip Land
1.05
(unit:
PAGE
Bolivar Drive
P.O.
Bradford, 16701
814-362-5536
814-362-8883
www.koaspeer.com
SS-188
Soldering Reflow soldering should done 240°C less than seconds. Flow soldering should done 260°C less than seconds.
Solder Solder
Measurement Method Measurement Method impedance element connected with resistor capacitor series shall considered series equivalent circuit element value value shall measured 100MHz with series equivalent circuit. Measurement Method DISSIPATION FACTOR shall measured 1KHz impedance element connected series with resistor capacitor. Tolerance CAPACITANCE TOLERANCE capacitance tolerance regulated measure (impedance) 1MHz compare value with nominal capacitance tolerance this time. RESISTANCE TOLERANCE resistance tolerance regulated measure (impedance) 100MHz seek resistance with value compare with nominal resistance.
PAGE
Bolivar Drive
03/99
P.O.
Bradford, 16701
814-362-5536
814-362-8883
www.koaspeer.com
Other recent searches
TS-0142 - TS-0142 TS-0142 Datasheet
STi7101 - STi7101 STi7101 Datasheet
M21235 - M21235 M21235 Datasheet
FKC01 - FKC01 FKC01 Datasheet
Privacy Policy | Disclaimer
© 2012 Datasheet Archive
