The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.    


Datasheet Search Engine   
 
Part # or Description: • 5V RS232 Driver • 2SC5066* • "Real Time Clock" • "USB connector" • "blue led" 5mm • 10 watt zener diode • 2N3055* motorola
 
Search Tip: Try entering the part number only. Include a wildcard (eg. lm317* or 1n4148*)

 

 

16-Bit Inverting Buffer/Driver with 3-State Outputs PI74VCX Famil


Datasheet Thumbnail

  

Download PDF



Top Searches for this datasheet



PI74VCX16240
16-Bit Inverting Buffer/Driver with 3-State Outputs
PI74VCX Family designed voltage operation, 1.8V 3.6V 3.6V Tolerant Inputs Outputs Supports Live Insertion Balanced Drive, ±24mA Uses patented Noise Reduction Circuitry Typical VOLP (Output Ground Bounce) <0.6V 2.5V, Typical VOHV (Output Undershoot) -0.6V 2.5V, Power-Off high impedance inputs outputs Industrial operation -40°C +85°C Packages available: 48-pin wide plastic TSSOP 48-pin wide plastic SSOP
Product Description
Pericom Semiconductor's PI74VCX series logic circuits produced Company's advanced 0.35 micron CMOS technology, achieving industry leading speed. inverting buffer/driver designed specifically improve both performance density 3-state memory address drivers, clock drivers, bus-oriented receivers transmitters. device used four 4-bit buffers, 8-bit buffers, 16-bit buffer. provides symmetrical active-low outputenable (OE) inputs. ensure high-impedance state during power power down, should tied through pullup resistor; minimum value resistor determined current-sinking capability driver. PI74VCX family Tolerant, allowing operate 1.8/3.6V systems.
Logic Block Diagram
PS8323
09/14/98
PI74VCX16240 16-BIT INVERTING BUFFER DRIVER WITH 3-STATE OUTPUTS
Product Description
Name Description 3-State Output Enable Inputs (Active LOW) Inputs 3-State Outputs Ground Power
Truth Table(1)
Inputs Outputs
Product Configuration
Notes: High Signal Level Signal Level Don't Care Irrelevant High Impedance
48-PIN
PS8323
09/14/98
PI74VCX16240 16-BIT INVERTING BUFFER DRIVER WITH 3-STATE OUTPUTS
Maximum Ratings
(Above which useful life impaired. user guidelines, tested.) Supply Voltage Range, 0.5V 4.6V Input Voltage Range, -0.5V 4.6V Output Voltage Range, (3-Stated) -0.5V 4.6V Output Voltage Range, VO(1) (Active) -0.5V VCC+0.5 Input Diode Current (IIK) VI<0V -50mA Output Diode Current (IOK) VO<0V -50mA VO>VDD +50mA Output Source/Sink Current (IOH/IOL) ±50mA Current Supply (ICC GND) ±100mA Storage Temperature Range, Tstg -65°C 150°C Note: Stresses greater than those listed under MAXIMUM RATINGS cause permanent damage device. This stress rating only functional operation device these other conditions above those indicated operational sections this specification implied. Exposure absolute maximum rating conditions extended periods affect reliability.
Recommended Operating Conditions(2)
Supply voltage High- level input voltage Low- level input voltage Input voltage Output voltage Active State State 3.0V 3.6V 2.3V 2.7V 1.8V Operating Data Retention Only 2.7V 3.6V 2.7V 3.6V ns/V Units
Output current IOH/IOL Input transistion rise fall rate(3) Operating free- temperature
Notes Absolute maximum must observed. Unused control inputs must held HIGH prevent them from floating. measured between 0.8V 2.0V, 3.0V.
PS8323
09/14/98
PI74VCX16240 16-BIT INVERTING BUFFER DRIVER WITH 3-STATE OUTPUTS
Electrical Characteristics over Recommended Operating Free-Air Temperature Range
(unless otherwise noted)
Characteristics (2.7V<VDD 3.6V)
Parame HIGH Level Input Voltage Level Input Voltage -100µA HIGH Level Output Voltage -12mA -18mA -24mA 100µA Level Output Voltage 12mA 18mA 24mA IOFF Input Leakage Current STATE utput Leakage Power- Leakage Current Quiescent Supply Current 0.0V, 3.6V 3.6V (VI,VO) 3.6V (VI,VO) 3.6V 0.6V, ther inputs 0.55 ±5.0 Conditions Typ. Units
Increase input
PS8323
09/14/98
PI74VCX16240 16-BIT INVERTING BUFFER DRIVER WITH 3-STATE OUTPUTS
Electrical Characteristics over Recommended Operating Free-Air Temperature Range
(unless otherwise noted) (continued from previous page)
Characteristics (2.3V 2.7V)
Parame HIGH Level Input Voltage Level Input Voltage 100µA HIGH Level Output Voltage 12mA 18mA 100µA IOFF Level Output Voltage 12mA 18mA Input Leakage Current STATE Output Leakage Power- Leakage Current Quiescent Supply Current 0.0V, 2.7V 3.6V (VI,VO) 3.6V (VI,VO) 3.6V Conditions ±5.0 Typ. Units
Characteristics (1.8V 2.3V)
Parame IOFF HIGH Level Input Voltage Level Input Voltage HIGH Level Output Voltage 100µA Level Output Voltage 100µA Input Leakage Current STATE Output Leakage Power- Leakage Current Quiescent Supply Current 0.0V, 1.8V 3.6V (VI,VO) 3.6V (VI,VO) 3.6V Conditions ±5.0 Typ. Units
PS8323
09/14/98
Dynamic Switching Characteristics
Symbol Parame Conditions +25°C Typical 0.25 0.25 Units
PI74VCX16240 16-BIT INVERTING BUFFER DRIVER WITH 3-STATE OUTPUTS
Electrical Characteristics(1)
-40°C +85°C, 30pF, Symbol Parame 3.3V ±0.3V tPHL, tPLH tPZL, tPZH tPLZ, tPHZ tOSHL tOSLH Prop Delay utput Enable Time utput Disable Time utput utput Skew(2) 2.5V ±0.2V 1.8V Units
Notes 50pF approximatly 300ps maximum specification Skew defined absolute value difference between actual propagation delay separate outputs same device. specification applies outputs switching same direction, either HIGH (tOSHL) HIGH (tOSLH).
VOLP
Quiet Output Dynamic Peak
50pF, VIH= VDD, VIL=
VOLV
Quiet Output Dynamic Valley
50pF, VIH= VDD, VIL=
VOHV
Quiet Output Dynamic Valley
50pF, VIH= VDD, VIL=
Capacitance
Symbol
COUT
Parame
Input Capacitance Output Capacitance
Conditions
1.8V, 2.5V 3.3V, VDD, 1.8V, 2.5V 3.3V VDD, 10MHz 1.8V, 2.5V 3.3V
Typical
Units
Power Dissipation Capacitance
PS8323
09/14/98
PI74VCX16240 16-BIT INVERTING BUFFER DRIVER WITH 3-STATE OUTPUTS Switch Position
tPLZ/tPZL tPHZ/tPZH
Open
Test Circuits Switching Waveforms
Parameter Measurement Information (VDD 1.8V 3.6V)
Open
From Output Under Test
50pF
(See Note
Pulse Width
Low-High-Low Pulse High-Low-High Pulse VDD/2 VDD/2
Setup, Hold, Release Timing
Data Input Timing Input VDD/2 VDD/2
Propagaton Delay
Input tPLH Output tPHL tPLH tPHL
VDD/2 VDD/2
Notes: includes probe capacitance. Waveform output with internal conditions such that output except when disabled output control. Waveform output with internal conditions such that output HIGH except when disabled output control. input pulses supplied generators having following characteristics: MHz, 2ns, 2ns, measured from 90%, unless otherwise specified. outputs measured time with transition measurement.
Opposite Phase Input Transition VDD/2
Enable Disable Timing
Output Control
(Active LOW)
VDD/2 tPZL VDD/2 +0.15V tPZH VDD/2 tPHZ -0.15V tPLZ
Output Waveform 2xVDD
(see Note
Output Waveform
(see Note
Pericom Semiconductor Corporation 2380 Bering Drive Jose, 95131 1-800-435-2336 (408) 435-1100 http://www.pericom.com
PS8323 09/14/98

Other recent searches


MSU1HF1 - MSU1HF1   MSU1HF1 Datasheet
MSU2HF1 - MSU2HF1   MSU2HF1 Datasheet
MPC555 - MPC555   MPC555 Datasheet
MB86697A - MB86697A   MB86697A Datasheet
LG-150IR-CT - LG-150IR-CT   LG-150IR-CT Datasheet
ISL9519EVAL2Z - ISL9519EVAL2Z   ISL9519EVAL2Z Datasheet
DSE-962-014 - DSE-962-014   DSE-962-014 Datasheet
AN569 - AN569   AN569 Datasheet

 

Privacy Policy | Disclaimer
© 2012 Datasheet Archive