Watts, Surface Mount Terminations General Specifications

The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.

Watts, Surface Mount Terminations General Specifications

Datasheet Thumbnail

Top Searches for this datasheet

Model RFP-100200-4Z50-2 Surface Mount Terminations
Watts,
Surface Mount Terminations
General Specifications
Resistive Element: Substrate: Terminals: Thick film Beryllium oxide ceramic Thick film silver
Electrical Specifications Features
Watts Ceramic Non-Nichrome Resistive Element VSWR 100% Tested
Resistance Value: Frequency Range: Input Power: V.S.W.R.: ohms, Watts 1.25:1
Notes: Tolerance ±.010, unless otherwise specified. Operating temperature -55°C +125°C (see chart). Designed meet exceed applicable portions MIL-E-5400. dimensions inches. Specifications subject change without notice.
Outline Drawing
VIEW .100 BOTTOM VIEW .040 SIDE VIEW
.015 .200 HATCHED AREA INDICATES LOCATION PROTECTIVE COATING .035 .020
VER. 12/5/01
Available Tape Reel Pick Place Manufacturing.
Sales Desk USA: Voice: (800) 544-2414 Fax: (315) 432-9121 Sales Desk Europe: Voice: (+44) 232392 Fax: (+44) 251369
Model RFP-100200-4Z50-2
RATED POWER
Surface Mount Terminations
Typical Performance
Power Derating
Suggested Mounting Procedures
SOLDER PASTE SOLDER FILLED
SCREW PLS.)
BOARD HEATSINK
Solder part place using 60/40 type solder with controlled temperature iron (700°F). Drill thermal vias through fill with solder, such 60/40 type. ensure good thermal connectivity heat sink, drill heatsink mount board heat sink using screws.
P.C.B. SOLDER INTERFACE TEMPERATURE
Available Tape Reel Pick Place Manufacturing.
Sales Desk USA: Voice: (800) 544-2414 Fax: (315) 432-9121 Sales Desk Europe: Voice: (+44) 232392 Fax: (+44) 251369

Other recent searches