Internal Address Data Latches Bytes Internal Control Timer Fast Write

The Datasheet Archive - 100 Million Datasheets from 7500 Manufacturers.

Internal Address Data Latches Bytes Internal Control Timer Fast Write

Datasheet Thumbnail

Top Searches for this datasheet

Single 3.3V Supply Fast Read Access Time Automatic Page Write Operation
Internal Address Data Latches Bytes Internal Control Timer Fast Write Cycle Time Page Write Cycle Time Maximum 128-Byte Page Write Operation Power Dissipation Active Current CMOS Standby Current Hardware Software Data Protection DATA Polling Write Detection High Reliability CMOS Technology Endurance: 100,000K Cycles Data Retention: Years JEDEC Approved Byte-Wide Pinout Commercial Industrial Temperature Ranges
1-Megabit (128K Voltage Paged Parallel EEPROMs AT28LV010
Description
AT28LV010 high-performance 3-volt only Electrically Erasable Programmable Read Only Memory. megabit memory organized 131,072 words bits. Manufactured with Atmel's advanced nonvolatile CMOS technology, device offers access times with power dissipation just When device deselected, CMOS standby current less than (continued)
Configurations
Name I/O0 I/O7 Function Addresses Chip Enable Output Enable Write Enable Data Inputs/Outputs Connect Don't Connect PDIP View
I/O0 I/O1 I/O2 I/O7 I/O6 I/O5 I/O4 I/O3 I/O0
PLCC View
TSOP View
I/O7 I/O6 I/O5 I/O4 I/O3 I/O2 I/O1 I/O0
I/O1 I/O2 I/O3 I/O4 I/O5 I/O6
I/O7
Rev. 0395B-10/98
AT28LV010 accessed like Static read write cycle without need external components. device contains 128-byte page register allow writing bytes simultaneously. During write cycle, address bytes data internally latched, freeing address data other operations. Following initiation write cycle, device will automatically write latched data using internal control timer. write cycle detected
DATA polling I/O7. Once write cycle been detected access read write begin. Atmel's 28LV010 additional features ensure high quality manufacturability. device utilizes internal error correction extended endurance improved data retention characteristics. Software data protection implemented guard against inadvertent writes. device also includes extra bytes EEPROM device identification tracking.
Block Diagram
Absolute Maximum Ratings*
Temperature Under Bias -55°C +125°C Storage Temperature -65°C +150°C Input Voltages (including Pins) with Respect Ground .-0.6V +6.25V Output Voltages with Respect Ground .-0.6V 0.6V Voltage with Respect Ground .-0.6V +13.5V *NOTICE: Stresses beyond those listed under "Absolute Maximum Ratings" cause permanent damage device. This stress rating only functional operation device these other conditions beyond those indicated operational sections this specification implied. Exposure absolute maximum rating conditions extended periods affect device reliability
AT28LV010
AT28LV010
Device Operation
READ: AT28LV010 accessed like Static RAM. When high, data stored memory location determined address pins asserted outputs. outputs high impedance state when either high. This dualline control gives designers flexibility preventing contention their system. WRITE: write operation AT28LV010 allows bytes data written into device during single internal programming period. Each write operation must preceded software data protection (SDP) command sequence. This sequence series three unique write command operations that enable internal write circuitry. command sequence data written must conform software protected write cycle timing. Addresses latched falling edge whichever occurs last data latched rising edge whichever occurs first. Each successive byte must written within (tBLC) previous byte. tBLC limit exceeded AT28LV010 will cease accepting data commence internal programming operation. more than data byte written during single programming operation, they must reside same page defined state inputs. each high transition during page write operation, must same. inputs used specify which bytes within page written. bytes loaded order altered within same load period. Only bytes which specified writing will written; unnecessary cycling other bytes within page does occur. DATA POLLING: AT28LV010 features DATA Polling indicate write cycle. During byte page write cycle attempted read last byte written will result complement written data presented I/O7. Once write cycle been completed, true data valid outputs, next write cycle begin. DATA Polling begin anytime during write cycle. TOGGLE BIT: addition DATA Polling AT28LV010 provides another method determining write cycle. During write operation, successive attempts read data from device will result I/O6 toggling between zero. Once write completed, I/O6 will stop toggling valid data will read. Reading toggle begin time during write cycle. DATA PROTECTION: precautions taken, inadvertent writes occur during transitions host system power supply. Atmel incorporated both hardware software features that will protect memory against inadvertent writes. HARDWARE PROTECTION: Hardware features protect against inadvertent writes AT28LV010 following ways: power-on delay-once reached 2.0V (typical) device will automatically time (typical) before allowing write; write inhibit-holding low, high high inhibits write cycles; noise filter-pulses less than (typical) inputs will initiate write cycle. SOFTWARE DATA PROTECTION: AT28LV010 incorporates industry standard software data protection (SDP) function. Unlike standard 5-volt only EEPROM's, AT28LV010 enabled times. Therefore, write operations must preceded command sequence. data 3-byte command sequence written device; addresses command sequence utilized just like other location device. attempt write device without 3-byte sequence will start internal timers. data will written device. However, duration tWC, read operations will effectively polling operations.
Operating Range
AT28LV010-20 Operating Temperature (Case) Power Supply Com. Ind. 70°C -40°C 85°C 3.3V AT28LV010-25 70°C -40°C 85°C 3.3V
Operating Modes
Mode Read Write
DOUT High
Standby/Write Inhibit Write Inhibit Write Inhibit Output Disable Notes: VIH. Refer Programming Waveforms.
High
Characteristics
Symbol Parameter Input Load Current Output Leakage Current Standby Current CMOS Active Current Input Voltage Input High Voltage Output Voltage Output High Voltage 3.0V -100 3.0V 0.45 Condition VI/O Com. 0.3V Ind. Units
MHz; IOUT 3.6V
AT28LV010
AT28LV010
Read Characteristics
AT28LV010-20 Symbol tACC
AT28LV010-25 Units
Parameter Address Output Delay Output Delay Output Delay Output Float Output Hold from Address, whichever occurred first
tDF(3)(4)
Read Waveforms(1)(2)(3)(4)
Notes:
delayed tACC after address transition without impact tACC. delayed after falling edge without impact tACC after address change without impact tACC. specified from whichever occurs first pF). This parameter characterized 100% tested.
Input Test Waveforms Measurement Level
Output Test Load
Capacitance
MHz, 25°C(1)
Symbol COUT Note: Units Conditions VOUT
This parameter characterized 100% tested.
Write Characteristics(1)
Symbol tAS, tOES tDH, tOEH Note: Parameter Address, Set-up Time Address Hold Time Chip Select Set-up Time Chip Select Hold Time Write Pulse Width Data Set-up Time Data, Hold Time Units
write operations must preceded command sequence.
Write Waveforms
Controlled
Controlled
AT28LV010
AT28LV010
Software Protected Write Characteristics
Symbol tBLC tWPH Parameter Write Cycle Time Address Set-up Time Address Hold Time Data Set-up Time Data Hold Time Write Pulse Width Byte Load Cycle Time Write Pulse Width High Units
Programming Algorithm
LOAD DATA ADDRESS 5555
Notes: Data Format: I/O7 I/O0 (Hex); Address Format: (Hex). Data protect state will re-activated program cycle. bytes data loaded.
LOAD DATA ADDRESS 2AAA
LOAD DATA ADDRESS 5555
WRITES ENABLED(2)
LOAD DATA ADDRESS(3)
LOAD LAST BYTE LAST ADDRESS(3)
ENTER DATA PROTECT STATE
Software Protected Program Cycle Waveforms(1)(2)(3)
Notes:
must conform addressing sequence first three bytes shown above. After command sequence been issued page write operation follows, page address inputs A16) must same each high transition CE). must high only when both low.
Data Polling Characteristics(1)
Symbol tOEH Notes: Parameter Data Hold Time Hold Time Output Delay
Units
Write Recovery Time These parameters characterized 100% tested. Read Characteristics
Data Polling Waveforms
Toggle Characteristics(1)
Symbol tOEH tOEHP Notes: Parameter Data Hold Time Hold Time Output Delay High Pulse Write Recovery Time These parameters characterized 100% tested. Read Characteristics
Units
Toggle Waveforms
Notes:
Toggling either both will operate toggle bit. Beginning ending state I/O6 will vary. address location used address should vary.
AT28LV010
AT28LV010
Ordering Information(1)
tACC (ns) (mA) Active Standby 0.02 Ordering Code AT28LV010-20JC AT28LV010-20PC AT28LV010-20TC AT28LV010-20JI AT28LV010-20PI AT28LV010-20TI AT28LV010-25JC AT28LV010-25PC AT28LV010-25TC AT28LV010-25JI AT28LV010-25PI AT28LV010-25TI Package 32P6 32P6 32P6 32P6 Operation Range Commercial 70°C) Industrial (-40° 85°C) Commercial 70°C) Industrial (-40° 85°C)
0.02
0.02
0.02
Note:
Valid Part Numbers table below.
Valid Part Numbers
following table lists standard Atmel products that ordered.
Device Numbers AT28LV010 AT28LV010 Speed Package Temperature Combinations
Products
Reference Section: Parallel EEPROM Products
Package Type 32P6 32-Lead, Plastic J-Leaded Chip Carrier (PLCC) 32-Lead, 0.600" Wide, Plastic Dual Inline Package (PDIP) 32-Lead, Plastic Thin Small Outline Package (TSOP)
Packaging Information
32J, 32-Lead, Plastic J-Leaded Chip Carrier (PLCC) Dimensions Inches (Millimeters)
JEDEC STANDARD MS-016
32P6, 32-Lead, 0.600" Wide, Plastic Dual Inline Package (PDIP) Dimensions Inches (Millimeters)
.045(1.14)
IDENTIFY
.025(.635)
.012(.305) .008(.203) .530(13.5 .490(12.4 .021(.533) .013(.330) .030(.762) .015(3.81) .095(2.41) .060(1.52) .140(3.56) .120(3.05)
1.67(42.4) 1.64(41.7)
.032(.813) .026(.660)
.553(14.0) .547(13.9) .595(15.1) .585(14.9)
.566(14.4) .530(13.5)
050(1.27)
1.500(38.10) .220(5.59) SEATING PLANE .161(4.09) .125(3.18) .110(2.79) .090(2.29) .065(1.65) .041(1.04) .630(16.0) .590(15.0) .690(17.5) .610(15.5)
.090(2.29) .005(.127)
.300(7.62) .430(10.9) .390(9.90) CONTACT POINTS
.065(1.65) .015(.381) .022(.559) .014(.356)
.022(.559) (3X) .453(11.5) .447(11.4) .495(12.6) 485(12
.012(.305) .008(.203)
32T, 32-Lead, Plastic Thin Small Outline Package (TSOP) Dimensions Millimeters (Inches)*
JEDEC OUTLINE MO-142
INDEX MARK
18.5(.728) 18.3(.720)
20.2(.795) 19.8(.780)
0.50(.020)
7.50(.295) 8.20(.323) 7.80(.307)
0.25(.010) 0.15(.006)
1.20(.047)
0.15(.006) 0.05(.002) 0.20(.008) 0.10(.004) 0.70(.028) 0.50(.020)
*Controlling dimension: millimeters
AT28LV010
AT28LV010
Atmel Headquarters
Corporate Headquarters
2325 Orchard Parkway Jose, 95131 (408) 441-0311 (408) 487-2600
Atmel Operations
Atmel Colorado Springs
1150 Cheyenne Mtn. Blvd. Colorado Springs, 80906 (719) 576-3300 (719) 540-1759
Europe
Atmel U.K., Ltd. Coliseum Business Centre Riverside Camberley, Surrey GU15 England (44) 1276-686677 (44) 1276-686697
Atmel Rousset
Zone Industrielle 13106 Rousset Cedex, France (33) (33)
Asia
Atmel Asia, Ltd. Room 1219 Chinachem Golden Plaza Mody Road Tsimshatsui East Kowloon, Hong Kong (852) 27219778 (852) 27221369
Japan
Atmel Japan K.K. Tonetsu Shinkawa Bldg., 1-24-8 Shinkawa Chuo-ku, Tokyo 104-0033 Japan (81) 3-3523-3551 (81) 3-3523-7581
Fax-on-Demand
North America: 1-(800) 292-8635 International: 1-(408) 441-0732
e-mail
literature@atmel.com
Site
http://www.atmel.com
1-(408) 436-4309
Atmel Corporation 1998. Atmel poration makes warranty products, other than those expressly contained Company's standard warranty which detailed Atmel's Terms Conditions located Company's website. Company assumes responsibility errors which appear this document, reserves right change devices specifications detailed herein time without notice, does make commitment update information contained herein. licenses patents other intellectual proper Atmel granted Company connection with sale Atmel products, expressly implication. Atmel's products authorized critical components life suppor devices systems. Marks bearing
and/or
registered trademarks trademarks Atmel Corporation. Printed recycled paper.
0395B-10/98/xM
Terms product names this document trademarks others.

Internal Address Data Latches Bytes Internal Control Timer Fast Write

Top Searches for this datasheet

Other recent searches