Download

PDF Abstract Text:

L- Band Fiber Optic RF Link AC208

Features · 950 to 2100 MHz Frequency · 1.3 µm Low Noise Laser · High Dynamic Range · Optical Stabilization · Monitoring and Alarm Capability · Singlemode Fiber

L- Band Fiber Optic RF Link AC208
Features · 950 to 2100 MHz Frequency · 1.3 µm Low Noise Laser · High Dynamic Range · Optical Stabilization · Monitoring and Alarm Capability · Singlemode Fiber
This unit is optimize for operation in the full L - Band of 950 to 2100 MHz commonly used in satellite ground stations. The RF interface is via a 50 SMA (or F type 75 ohm) connector The optical connector is a low reflection FC / APC connector. The unit requires a single 12 volt DC supply with no external settings necessary. A laser and received optical power monitor and alarm is provided. The AC 208 is also available in a 19 inch AC powered subrack. Alternate packaging options are available.
Min 1280 950
Typ 1310 + / - 1.0 + / - 1.5 1.5:1
Max 1360 2100
Units nm MHz dB
Absolute Maximums Parameter Operating Temperature Storage Temperature Maximum RF Input to Transmitter Maximum Optical Input to Receiver D.C. Supply Voltage Package Schematic
0.35 (8.9) 0.75 (19) 0.156 DIA (4.0) 4X FC / APC 0.75 (19) 5.375 (136.5) 1.125
L- Band Fiber Optic RF Link AC208
-30 to +75OC -40 to +90OC +10 dBm 4 mW 12 volts
0.156 DIA (4.0) 4X ST / PC (Output)
Laser Alarm
DC Power
DC Optical Power Alarm
RF Input 5.0 (127) 5.0 (127)
RF Output
0.75 9 pin D, male (19) Dimensions in inches (mm)
9 pin D, male
PINOUT
1. +12 volts Laser Enable (TX only, 10 mA) NC (RX)
DANGER
Invisible Laser Radiation. Avoid Direct Exposure to Beam. Maximum Power 50 mW Wavelength 1300 nm Class IIIb Product
Ordering Information Model Number: Description:
AC 208 L-Band Fiber Optic RF Link
The AC 1208 is a 19 inch subrack which can be configured with multiple transmitters or receivers plus LNA as required. An AC power supply is provided internally. Please consult the Sales Department for other packaging configurations
Laser Warning: Invisible Laser Radiation emitting from optical connector. Avoid direct exposure to beam. 50 mW max. @ 1300nm. Class IIIb. Product complies with 21 CFR 1040.10 and 1040.11.
The information is considered to be accurate however to provide the best product possible, Anacom Systems Corporation reserves the right to make changes and improvements to the specifications without notice.
Anacom Systems Corporation
www.anacomsystems.com
techinfo@anacomsystems.com
100 Jersey Avenue, Bldg. A, New Brunswick, NJ 08901 · Tel: 732 846-2680 Fax: 732 846-2626