VC-91 VC-2R8Z91-1751R AD60-35001-02E

Voltage Controlled Oscillator VC-91 Series ØFeatures ·Single VCO with enable switch ØApplications

VCO Voltage Controlled Oscillator VC-91 VC-91 Series ØFeatures ·Single VCO with enable switch ØApplications ·For CDMA ØSpecifications ·P/N:VC-2R8Z91-1751R VC-2R8Z91-1751R Item Unit Low band Enable=ON , Vcc=2.8 V mA 10.0 MAX Enable=OFF , Vcc=2.8 V mA 0.02 MAX Vt=0.4 V MHz 1715 MAX Vt=2.3 V MHz 1788 MIN MHz/V 38 to 58 dBm - 6.0 to 0.0 dBc/Hz -120 MAX Current Consumption OSC Frequency Tuning Volt. Sensitivity Output Power Vcc=2.8 V Phase Noise Offset=120kHz Harmonics Up to 3rd dBc -20 MAX Pushing Vcc=+/-0.1V kHz +/-500 MAX Pulling VSWR=2 All phase kHz +/-1000 MAX Band Switching Logic FUJITSU MEDIA DEVICES LIMITED Voltage Controlled Oscillator (VCO) ØExternal Dimensions ØRecommended PCB Land Pattern Unit: mm FUJITSU MEDIA DEVICES LIMITED Voltage Controlled Oscillator (VCO) ØTape Packing ( Packing unit: 4,000pcs/reel ) -Carrier Tape Configuration and Dimension Unit: mm C D B A 06 0.2 0.4 0.6 0.8 - Reel Configuration and Dimension W1 W2 Unit: mm FUJITSU MEDIA DEVICES LIMITED Voltage Controlled Oscillator (VCO) ØAttention in use The above products are designed, developed and manufactured as contemplated for general use, including without limitation, ordinary industrial use, general office use,personal use, and household use. But are not designed, developed and manufactured as contemplated (1)for use accompanying fatal risks or dangers that, unless extremely high safety is secured,could have a serious effect to the public, and could lead directly to death, personal injury, severe physical damage or other loss(i.e., nuclear reaction control in nuclear facility, aircraft flight control, air traffic control, mass transport control, medical life support system, missile launch control in weapon system), or(2) for use requiring extremely high reliability (i.e., submersible repeater and artificial satellite).You shall not use the above products for the above-mentioned uses. If your equipment is likely to be used for the abovementioned uses, please consult with our sales representative before use. Fujitsu shall not be liable against you and/or any third party for any claims or damages arising in connection with the abovementioned uses of the above products. FUJITSU MEDIA DEVICES LIMITED http://jp.fujitsu.com/fmd/en/ Japan Global Sales Shin-Yokohama Square Bldg., Shin-yokohama 2-3-12,Kohoku-ku, Yokohama, Kanagawa 222-0033, Japan Tel: +81-45-471-0061 Fax: +81-45-471-0076 North and South America FUJITSU MEDIA DEVICES OF AMERICA, INC. 1250 East Arques Avenue, M/S 136 Sunnyvale, CA 94085-3470, U.S.A. Tel: +1-408-746-7500 Fax: +1-408-746-7555 http://www.fmda.fujitsu.com Asia Pacific FUJITSU MEDIA DEVICES HONG KONG Ltd. Suite 2012, Tower 1 The Gateway, 25 Canton Road, Tsim Sha Tsui, Kowloon, Hong Kong Tel: +852-2866-8509 Fax: +852-2866-8287 Europe FUJITSU MICROELECTRONICS EUROPE GmbH Pittlerstrasse 47, 63225 Langen, Germany Tel: +49-6103-690-0 Fax: +49-6103-690-122 http://www.fme.fujitsu.com/ FUJITSU MEDIA DEVICES HONG KONG LTD. (Taiwan representative office) 19F, No.39, Section 1, Chung hwa Road, Taipei Taiwan R.O.C. Tel: +886-2-2311-2255 Fax: +886-2-2371-8347 FUJITSU MEDIA DEVICES TRADING(SHANGHA) Ltd. Room 3104, Bund Center 222 Yan An Road East, Shanghai 200002 China Tel: +86-21-6323-4560 Fax: +86-21-6323-4510 The contents of this document are subject to change without notice. Customers are advised to consult with FUJITSU MEDIA DEVICES sales representatives before ordering. The information and circuit diagrams in this document are presented as examples of device applications, and are not intended to be incorporated in devices for actual use. Also, FUJITSU MEDIA DEVICES is unable to assume responsibility for infringement of any patent rights or other rights of third parties arising from the use of this information or circuit diagrams. The products described in this document are designed, and manufactured as contemplated for general use, including without limitation, ordinary industrial use, general office use, personal use, and household use, but are not designed, developed and manufactured as contemplated (1) for use accompanying fatal risks or dangers that, unless extremely high safety is secured, could have a serious effect to the public, and could lead directly to death, personal injury, severe physical damage or other loss (I.e., nuclear reaction control in nuclear facility, aircraft flight control, air traffic control, mass transport control, medical life support system, missile launch control in weapon system), or (2) for use requiring extremely high reliability (I.e., submersible repeater and artificial satellite), Please note that Fujitsu will not be liable against you and/or any third party for any claims or damages arising in connection with above-mentioned uses of the products. Any electronic devices have inherently certain rate of failure. You must protect against injury, damage or loss from such failures by incorporating safety design measures into your facility and equipment such as redundancy, fire protection, and prevention of over-current levels and other abnormal operating conditions. If any products described in this document represent goods or technologies subject to certain restrictions on export under the Foreign Exchange and Foreign Trade Control Law of Japan, the prior authorization by Japanese government should be required for export of those products from Japan. ©2006 FUJITSU LIMITED Printed in Japan AD60-35001-02E AD60-35001-02E , 2006