PD6NG-053R3E2 PD6NG-0505E2 PD6NG-0509E2 PD6NG-0512E2 PD6NG-0515E2 PD6NG-0524E2 - Datasheet Archive

 

Telefax: +49 (0)6135 931070 www.peak-electronics.de info@peak-electronics.de PD6NG-XXXXE2:1H30 3KV ISOLATED 1W REGULATED SINGLE

 

Telefon: +49 (0)6135 931069 Telefax: +49 (0)6135 931070 www.peak-electronics.de info@peak-electronics.de PD6NG-XXXXE2:1H30 3KV ISOLATED 1W REGULATED SINGLE OUTPUT SIP8 Electrical Specifications (Typical at + 25 , nominal input voltage, rated output current unless otherwise specified) Input Specifions Voltage range Filter 4.5-9, 9-18, 18-36 and 36-72 VDC Wide lnput Capacitor type lsolation Specifications Rated voltage Resistance Capacitance 3000 VDC 1 G 65 PF Output Specifications Voltage accuracy Ripple and noise (at 20 MHz BW) Short circuit protection Line voltage regulation Load voltage regulation Temperature coefficient +/-2 %, typ. 100 mV p-p, max. Continuous, auto restart +/-0.2 % typ. +/-0.5 % typ. load = 10 ~ 100% +/-0.02 % / General Specifications Efficiency Switching frequency Refer to the table 75 KHz, typ. Environmental Specifications Operating temperature (ambient) Storage temperature Humidity Cooling - 40 to + 80 - 55 to + 125 Up to 90 %, non condensing Free air convection Physical Characteristics Dimensions SIP Case material 21.80 x 9.20 x 11.10 mm Non conductive black plastic Samples of Partnumbers PART NO. PD6NG-053R3E2 PD6NG-053R3E2:1H30 PD6NG-0505E2 PD6NG-0505E2:1H30 PD6NG-0509E2 PD6NG-0509E2:1H30 PD6NG-0512E2 PD6NG-0512E2:1H30 PD6NG-0515E2 PD6NG-0515E2:1H30 PD6NG-0524E2 PD6NG-0524E2:1H30 PD6NG-123R3E2 PD6NG-123R3E2:1H30 PD6NG-1205E2 PD6NG-1205E2:1H30 PD6NG-1209E2 PD6NG-1209E2:1H30 PD6NG-1212E2 PD6NG-1212E2:1H30 PD6NG-1215E2 PD6NG-1215E2:1H30 PD6NG-1224E2 PD6NG-1224E2:1H30 PD6NG-243R3E2 PD6NG-243R3E2:1H30 PD6NG-2405E2 PD6NG-2405E2:1H30 PD6NG-2409E2 PD6NG-2409E2:1H30 PD6NG-2412E2 PD6NG-2412E2:1H30 PD6NG-2415E2 PD6NG-2415E2:1H30 PD6NG-2424E2 PD6NG-2424E2:1H30 PD6NG-483R3E2 PD6NG-483R3E2:1H30 PD6NG-4805E2 PD6NG-4805E2:1H30 PD6NG-4809E2 PD6NG-4809E2:1H30 PD6NG-4812E2 PD6NG-4812E2:1H30 PD6NG-4815E2 PD6NG-4815E2:1H30 PD6NG-4824E2 PD6NG-4824E2:1H30 INPUT VOLTAGE (VDC) INPUT CURRENT NO LOAD (mA) INPUT CURRENT FULL LOAD (mA) OUTPUT VOLTAGE (VDC) OUTPUT CURRENT (max.mA) EFFICIENCY FULL LOAD (% TYP.) 4.5 - 9 4.5 - 9 4.5 - 9 4.5 - 9 4.5 - 9 4.5 - 9 9 - 18 9 - 18 9 - 18 9 - 18 9 - 18 9 - 18 18 - 36 18 - 36 18 - 36 18 - 36 18 - 36 18 - 36 36 - 72 36 - 72 36 - 72 36 - 72 36 - 72 36 - 72 24 23 23 23 22 23 24 13 12 11 11 11 7 7 8 7 6 7 3 4 4 3 3 3 243 229 229 226 222 227 236 111 110 106 108 110 58 55 55 55 53 54 29 27 27 27 26 26 3,3 5 9 12 15 24 3,3 5 9 12 15 24 3,3 5 9 12 15 24 3,3 5 9 12 15 24 303 200 111 83 66 42 303 200 111 83 66 42 303 200 111 83 66 42 303 200 111 83 66 42 68 72 72 73 74 73 70 74 75 78 77 76 71 75 75 76 78 77 72 76 78 78 80 80 PD6NG-XXXXE2:1H30 3KV ISOLATED 1W REGULATED SINGLE OUTPUT SIP8 Dimensions 21,8 PEAK Modelcode 1 2 3 5 9,2 6 7 8 11,10 0.25± 0.05 3.20 typ. 0.50± 0.05 2.0± 0.50 3.10 typ. 0.50± 0.05 Recommended footprint details 2.54 typ. 2,54 XX.X± 0.5m/m XX.XX± 0.25m/m Unit : mm 1.00.15 /0 2,54 Derating Graph and Pinning Output Pin Connection # Single 1 - V Input 2 Temperature Derating Graph Ambient Temperature C + V Input 3 Omitted 5 Safe Operating Area Ctrl 4 1.00W NE 6 + V Output 7 - V Output 8 40 0 40 80 100 CS Control input can be left open (3) No external connection allowed (5) Optional external capacitor (8) PD6NG-XXXXE2:1H30 3KV ISOLATED 1W REGULATED SINGLE OUTPUT SIP8 External capacitance: Pin 3 (CTRL) These converters will work with without external capacitors but they are necessary in order to guarantee the full line load range. All parts have been tested using the following recommended values. Control pin (ON/OFF) Output starts at low or open and stops when high. Voltage applied via a limiting resistor and switching diode. The converter is in a low power mode during the high level phase. + Vout + Vin Cin Converter Connection example Cout - Vout - Vin Cin Cout 10uF/100V, low ESR. 100uF/25V, low ESR. MCU 1K 1N4148 1N4148 CONVERTER Vcc-5V PIN 3 Pin 8 (CS) This pin provides a connection point to the main reservoir capacitor. Additional capacitance can be added from this to pin 7. Any low ESR capacitor will improve ripple and noise in some measure. Starting values can be in the range of 100uF. Pin 5 (NE) This pin is used internally and must have have no external connection. Application Notes Pin 3: The outside control connection. This pin provides the converter output ON/OFF, and the control common is referred to negative input. Pin 5: This pin belongs to the secondary side. It just avoids someone to reverses the primary and secondary. Pin 8: Max. 1000 uF Specification can be changed without notice. REV: 1 / 03.2003 Copyright PEAK electronics GmbH