IEC384-10/ CECC32100 IEC60068-2

Reliability Data (Reference to IEC Specication) IEC384-10/ CECC32100 Clause IEC60068-2 Test Method Test 1-1 Mounting 1-2

SMD Dual-band Filters - DIP Series Reliability Data (Reference to IEC Specication) IEC384-10/ IEC384-10/ CECC32100 CECC32100 Clause IEC60068-2 IEC60068-2 Test Method Test 1-1 Mounting 1-2 Procedure Requirements No visible damage Visual inspection and dimension check The filter can be mounted on printedcircuit boards or ceramic substrates by applying wave soldering,reflow soldering (including vapour phase soldering) or conductive Any applicable method using*10 magnification 1-3-1 Filter VSWR < 2 at 20 Standard test board 1-4 Adhesion A force of 3 N applied for 10 s to the line joining the terminations and in a plane parallel to the substrate No visible damage 1-5 Bond strength of plating on end face Mounted in accordance with CECC 32 100,paragraph 4.4 No visible damage Conditions: bending 0.5 mm at a rate of 1 mm/s,radius jig.340mm, 2mm warp on FR4 board of 90mm length No visible damage In accordance with specification (chip off 1 mm) 1-6 20(Tb) Resistance to soldering heat 260 ± 5 for 10 ± 0.5 s in a static solder bath 260 ± 5 for 30 ± 1.0 s in a static solder bath No visible damage and complies with electrical performance Using visual enlargement of *10, dissolution of the termination shall not exceed 10% 1-7 20(Ta) Solderability Zero hour test,and test after storage(20 to 24months) in original atmosphere; un-mounted chips completely immersed for 2±0.5 s in 235 ± 5 . Th termination must be well tinned, at least 75% is well tinned at termination 4(Na) Rapid change of temperature -40 (30 minutes) to + 85 (30 minutes); 200 cycles No visible damage and complies with electrical performance IEC 60384-10 Climate sequence 1. Initial measurement 2. 2.Dry Heat(16hours,85deg.C) 3. Damp heat,cycle,Test Db first cycle(24hours;55deg.C;95 to 100% R.H.) 4. Cold(-20deg.C,2hours) 5. Damp heat,cycle,Test Db, remaining 6. Final measurements No visible damage and complies with electrical performance 3(Ca) Damp heat 500 ± 12 hours at 40 ; 90 to 95 % RH No visible damage and complies with electrical performance Endurance 500 ± 12 hours at 85 ; No visible damage and complies with electrical performance 1-8 1-9 1-10 1-11